Customer Support
*Please have your invoice and order ID ready before contacting
Customer Support.
Etekcity Corporation
1202 N. Miller St., Suite A
Anaheim, CA 92806
USA
Support Hours
Mon–Fri,
9:00 am–5:00 pm PST/PDT
Email: support@etekcity.com
Toll-Free: (855) 686-3835
If you encounter any issues or have any questions about your
new product, please contact our helpful Customer Support Team.
1. Flip the lantern over and twist
the battery compartment lid
counterclockwise to remove it.
2. Remove the insulation strip.
[Figure 1.1]
3. Replace the battery
compartment lid.
Set Up
Operation
Note: If you’re not using the
lantern for an extended period
of time, remove the batteries to
avoid power drainage.
1. Pull up on the handles to
turn on the lantern.
[Figure 2.1] ON
OFF
[Figure 2.2]
[Figure 2.1]
Figure 1.1
Note: Adjust the height to
control the amount of light
emitted from the lantern.
2. Fully collapse the lantern to
turn it off.
[Figure 2.2]
Replacing Batteries
1. Turn off the lantern.
2. Flip the lantern over and rotate
the battery compartment lid
counterclockwise to remove it.
[Figure 3.1]
3. Remove the old batteries
and install new batteries,
making sure they are placed
in the correct polarity.
[Figure 3.2]
4. Replace the battery
compartment lid by rotating
it clockwise.
[Figure 3.3]
Figure 3.1
Figure 3.3
Figure 3.2
Warranty Information
Scan Here to Receive Exclusive News:
Your product comes with 2 years of warranty,
starting from the date of purchase.
1. Scan the QR code or visit
etekcity.com/warranty.
2. Enter your purchase info to receive
exclusive news.
3. Learn about our quality customer support
and gain easy access to warranty
information.
Federal Communication Commission
Interference Statement
FCC SDOC SUPPLIER’S DECLARATION OF
CONFORMITY
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Etekcity Corporation hereby declares that this equipment is in
compliance with the FCC Part 15 Subpart B. The declaration of
conformity may be consulted in the support section of our website,
accessible from www.etekcity.com.
FCC Caution: Any changes or modifications not expressly approved
by the party responsible for compliance could void the user’s authority
to operate this equipment.
A3_22C22_us
