Battery Installation
1. Push down and out on the battery
compartment cover to remove it.
2. Insert the two "AAA" batteries into the
battery compartment of the remote
control, making sure the + and - signs on
the batteries and the inside of the battery
compartment match up.
3. Replace the battery compartment
cover.
Notes:
Do not mix batteries from different
manufacturers, or old with new.
If the remote control will not be used
for an extended period of time,
remove the batteries to prevent
damage-causing corrosion.
Remove the dead batteries
immediately to prevent damage-
causing corrosion.
If battery leakage occurs, wipe the
battery liquid from inside the battery
compartment, and then replace both
batteries.
Always replace both batteries at the
same time, using new, fully charged
batteries.
The life expectancy of batteries may
vary depending on amount of use.
Notes:
!Do not direct the remote sensor
toward any light source, such as
direct sunlight or strong fluorescent
light as it may cause the unit not to
operate correctly.
!When other remote controls are
used nearby or when the remote is
used near equipment using infrared
rays, interference may occur.
!Placing an object on the remote
control may cause it to inadvertently
depress a button, changing a
function and shortening battery life.
!Do not cover the front of the DVD
receiver with tinted glass, as it may
cause interference with normal
operation of the controller.
!Make sure there is no solid objects
between the remote control and the
remote sensor. This could prevent
the unit from receiving the signal.
!Do not spill water or put wet items
on the remote control.
Using the Remote Control
Point the remote control at the remote
sensor on the DVD receiver. When the
signal is received from the remote, the
unit will function accordingly. The remote
will operate up to approximately 16' from
the remote sensor at an angle of around
30' in each direction.
BATTERIES
INCORRECT USE OF BATTERIES MAY
CAUSE THEM TO LEAK, CORRODE,
OR EXPLODE.
OPERATING THE
REMOTE CONTROL
