OPERATION
STARTING UP
1. For long term logging, suggest to connect the meter to the adaptor
and install 4 pcs AA batteries as spare power source. Or, you may
just use battery as power source.
2. Insert the Type K probes or thermistor probes into probe socket.
3. Power on the meter by pressing the “ ” key for 2 seconds
4. When the meter is on, pressing the “ ” key for 2 seconds
can turn the meter off.
5. Program the real time and alarm setting for the first time usage.
You may refer to page 10 in SETUP MODE.
Without the batteries as spare power source, all the parameters
will be reset after the adaptor power is removed.
6.The temperature default unit is ℃, to change it from ℃ to ℉, you
may refer to page 10 in SETUP MODE.
7. A” ----” will be displayed on LCD if the probe is not plugged.
8
LOW BATTERY ICON
1.When the battery is low, the low battery icon will appear
on the display. Suggest to change the batteries.
2.The Manual logging or Auto logging is invalid when the low
battery icon appears on the display.
3.When the low battery icon appears on the LCD, the reservation
function will not function.
4. If the low battery icon appears during the recording mode, the
data will be recorded until the power is too low to work normally.
In above condition, the logging will be terminated automatically
and return to normal measurement mode.
BURN OUT NOTIFICATION
If the sensor is not connected or is broken, the 「- - -」will be
displayed on LCD and the data in the SD card is blank.
2 .When the power is off, press “ ” key and “ ” key
simultaneously , “n” mark will appear on the LCD. It means
the auto power off function is now disabled.
3 .The auto power off will not work when the meter is on manual
logging and auto logging mode.
4. The default setting of the auto power off function is activated.
