Esco 10964 Manuel
ESCO – Equipment Supply Company
15270 Flight Path Drive Brooksville, FL 34604 ●Phone: 800-352-9852 ●Fax: 352-754-4508
Website: www.esco.net ●Email: [email protected]
Calibration Procedure – DIGITAL WALL MOUNTED TIRE INFLATOR
Model #10964
NOTE: Make sure the inflation unit is disconnected from the power supply before
starting Step 1.
Step 1: Connect the inflator Inlet to a >100 PSI air source.
Step 2:
Press and hold the Target pressure control buttons (“+” and “–“) on the faceplate of the
10964 Inflator.
Step 3:
Turn on the inflator and when the LCD display shows “06A” code release control
buttons (“+” and “–“)
Step 4:
Press the “i/SET” unit option button until the “CAL” code is shown on the inflator’s LCD
display.
ESCO – Equipment Supply Company
15270 Flight Path Drive Brooksville, FL 34604 ●Phone: 800-352-9852 ●Fax: 352-754-4508
Website: www.esco.net ●Email: [email protected]
Step 5:
Connect the inflator Outlet to a second stable >100 PSI air source.
Step 6:
The current air pressure will be shown on the inflator’s LCD display.
Step 7:
Once the air pressure reading is steady and holding its position press the “i/SET” unit
option button once on the inflator.
The display screen will show a reading of “100 PSI”, at this point shut off the air source
and calibration is complete.
Table des matières
Autres manuels Esco Outils électriques
Esco
Esco 10964 Manuel utilisateur
Esco
Esco 40805 Manuel utilisateur
Esco
Esco Pro Series Manuel utilisateur
Esco
Esco 10107 Manuel utilisateur
Esco
Esco 10963 Manuel utilisateur
Esco
Esco 10104 Manuel utilisateur
Esco
Esco 10965 Manuel utilisateur
Esco
Esco 20408 Manuel utilisateur
Esco
Esco 10961 Manuel utilisateur
Esco
Esco 10961 Manuel utilisateur
