Ergo Desktop Wallaby Junior Manuel utilisateur
Mounting and Adjusting your Monitor height - Follow the instructions below to
mount your monitor. Then place your monitor on the unit without tightening the
set screw mentioned in step 2. Is the monitor height right for you in the seated and
standing position? If not, remove the monitor by sliding part A out of part B(men-
tioned below), and adjust the height of part B by loosening each of the notated
four bolts BY ONLY HALF A TURN, with the provided 7/16 wrench{H}. Adjust to
your height and tighten the 4 bolts securely. Use 4 black caps to cover the exposed
bolts once completed.
The Wallaby Junior
The Wallaby Junior is designed to hold your monitor mounted in a
xed position, and will travel up and down with your keyboard and
mouse on the work surface. Your Wallaby Junior is shipped in the
down position with work surface brake tightened. The mount may
need adjusted to your desired height for both the seated and
standing postition.
The Wallaby Junior has (1) spring that assists in raising your unit to the
standing position and works best when your monitor and
keyboard are in place. This reduces the amount of pressure needed
to lower the unit.
Always push down with both hands on the horizontal rear rail when
lowering the work surface.
The STabilizaTion leg
Your adjustable height desk top unit comes with an adjustable leg that can be used
to give you maximum stability when you are using “The Kangaroo” in the standing
position.
Raise the Kangaroo work surface to your desired standing height and tighten the work
surface brake.
Place the adjustable leg under the work surface and loosen the adjustable leg brake.
Only loosen the brake by a turn or two, too much and the brake will disengage from
the slot.
Extend the adjustable leg until it engages the bottom of the work surface and then
tighten the adjustable leg brake.
The leg is shipped with the extension section installed to give you additional height
adjustment. If this is too tall for your application, simply unscrew the extension
selection.
always remember to remove the stabilization
leg before lowering your work surface
A Extension selection
B Screws into here
To raise the Wallaby Junior, loosen the main brake(A) and lift the main
work surface on the sides(C & C).
To lower the Wallaby Junior, loosen the main brake(A) and lean into the
unit using your upper body weight pushing down with both hands on
the horizontal bar at the rear of the main work surface (B & B).
hoW To uSe The Wallaby Junior
A. Main Brake
B. Work Surface Rail
C. Main Work Surface
C. Lift Here C. Lift Here
B. Push down hereB. Push down here
A. Main Brake
Table des matières
Autres manuels Ergo Desktop Support et étagère
Ergo Desktop
Ergo Desktop KANGAROO JUNIOR Manuel utilisateur
Ergo Desktop
Ergo Desktop THE KANGAROO PRO JUNIOR Manuel utilisateur
Ergo Desktop
Ergo Desktop Dual Kangaroo Manuel utilisateur
Ergo Desktop
Ergo Desktop The Hybrid Kangaroo Manuel utilisateur
Ergo Desktop
Ergo Desktop MyMac Kangaroo Pro Manuel utilisateur
Manuels Support et étagère populaires d'autres marques
Salamander
Salamander Acadia AC/W/L400/WH Manuel utilisateur
Fohhn
Fohhn VAT-09 Guide de l'utilisateur
ricoo
ricoo FS0522 Manuel utilisateur
AMSOIL
AMSOIL BMK-22 Guide rapide
Kargo Master
Kargo Master 48220 Manuel utilisateur
Milestone AV Technologies
Milestone AV Technologies SIMPLICITY SLF2 Manuel utilisateur
