Epson ColorPage EPL-C8200 Manuel utilisateur
LProof Sign-off:
ABE K.Tsuno H.Kimura_______
H.Kimura _______
ABE J.Holmes _______
R4C4450 Quick Reference
Rev.C
A5 size QUICK.FM
7/18/00 Pass 0
2
22
2
Replacing Consumable Products
You must replace the following consumable products
when a notice message appears on the LCD panel or in
the EPSON Status Monitor 3 utility.
Replacing a toner cartridge
1. Confirm the color of the toner cartridge that needs
to be replaced by checking the LCD panel.
2. Open the front cover.
3. See which color currently appears in the cartridge
installation window.
If you can see the color that you need to replace, go
to step 5.
If you see a different color, go to the next step.
4. There is a switch located at the upper left. Push it
up, then release it. Turn the round knob located just
above the installation window clockwise until it
stops. The switch drops down to the lower position
automatically and the next cartridge slot appears
in the installation window. Repeat this step until
the cartridge that you want to replace appears.
Note:
If the knob cannot be turned, check if the switch is up.
Do not turn the knob by force.
Toner Cartridge (Yellow) S050016
Toner Cartridge (Magenta) S050017
Toner Cartridge (Cyan) S050018
Toner Cartridge (Black) S050019
Waste Toner Collector S050020
Photoconductor Unit S051061
Fuser Oil Roll S052002
R4C4450 Quick Reference
Rev.C
A5 size QUICK.FM
7/18/00 Pass 0
R
Proof Sign-off:
ABE K.Tsuno H.Kimura_______
H.Kimura _______
ABE J.Holmes _______
3
33
3
5. Turn the cartridge knob counterclockwise 90
degrees so that the
Osymbol on the knob is in the
position shown below. By turning the knob, the
cartridge extends slightly.
6. Pull the cartridge out of the slot.
7. Take a new cartridge out of its package, and gently
shake it back and forth and front to back as shown
below to distribute the toner evenly.
8. Hold the cartridge with the arrow side facing up.
Insert it all the way into the cartridge slot.
9. Turn the cartridge knob clockwise 90 degrees so
that the
Osymbol on the knob is in the position
shown below. By turning the knob, the cartridge is
inserted and locked into the slot.
cCaution:
Be sure to turn the knob all the way to the set
position. Otherwise, you may have toner
problems or leakage.
10. If you need to replace another cartridge, repeat
steps 3 to 9.
11. Close the front cover.
LProof Sign-off:
ABE K.Tsuno H.Kimura_______
H.Kimura _______
ABE J.Holmes _______
R4C4450 Quick Reference
Rev.C
A5 size QUICK.FM
7/18/00 Pass 0
4
44
4
Replacing the photoconductor unit
1. Turn off the printer.
Note:
Before replacing the photoconductor unit, be sure to turn
off the printer.
2. Open the front cover.
3. Turn the large lever counterclockwise 90 degrees.
4. Turn the small lever to the right.
5. Pull the photoconductor unit about 30 cm out of the
printer.
R4C4450 Quick Reference
Rev.C
A5 size QUICK.FM
7/18/00 Pass 0
R
Proof Sign-off:
ABE K.Tsuno H.Kimura_______
H.Kimura _______
ABE J.Holmes _______
5
55
5
6. Hold the handle at the top of the photoconductor
unit and gently pull it all the way out.
7. Take the new photoconductor unit out of its
package and unwrap the protective sheet while
holding the handle as shown below.
cCaution:
❏Be sure not to scratch or touch the surface
of the drum.
❏When replacing the photoconductor unit,
avoid exposing it to room light any longer
than necessary.
8. Hold the handle on top of the photoconductor unit
and place the unit on the guide rails. Insert it all the
way into the printer.
cCaution:
Be sure not to touch the surface of the drum.
9. Turn the small lever to the left.
LProof Sign-off:
ABE K.Tsuno H.Kimura_______
H.Kimura _______
ABE J.Holmes _______
R4C4450 Quick Reference
Rev.C
A5 size QUICK.FM
7/18/00 Pass 0
6
66
6
10. Turn the large lever clockwise 90 degrees.
11. Close the front cover.
Replacing the waste toner collector
1. Open the front cover.
2. Grasp the handle and tab of the waste toner
collector to release the lock.
3. Pull out the waste toner collector.
4. Take out a new waste toner collector.
R4C4450 Quick Reference
Rev.C
A5 size QUICK.FM
7/18/00 Pass 0
R
Proof Sign-off:
ABE K.Tsuno H.Kimura_______
H.Kimura _______
ABE J.Holmes _______
7
77
7
5. Hold the handle of the collector and insert it into
the slot all the way until the tab clicks into place.
6. Close the front cover.
Replacing the fuser oil roll
1. Pull down the Face-up Tray.
2. Hold the handle of the fuser unit and pull it all the
way out.
wWarning:
Be careful not to touch the fuser which is marked
CAUTION! HIGH TEMPERATURE, or the
surrounding areas. If the printer has been in
use, the fuser and the surrounding areas may be
very hot.
3. Hold the handle of the fuser oil roll and pull it all
the way out.
LProof Sign-off:
ABE K.Tsuno H.Kimura_______
H.Kimura _______
ABE J.Holmes _______
R4C4450 Quick Reference
Rev.C
A5 size QUICK.FM
7/18/00 Pass 0
8
88
8
4. Take a new fuser oil roll out of its box, and remove
the cover and two shipping pins as shown below:
Note:
Do not touch the white roll surface.
5. Hold the roll handle and insert the fuser oil roll into
the fuser unit matching the green marks on the roll
and unit.
6. Push the roll down firmly until it clicks into place.
7. Push the fuser unit into the printer until it clicks.
R4C4450 Quick Reference
Rev.C
A5 size QUICK.FM
7/18/00 Pass 0
R
Proof Sign-off:
ABE K.Tsuno H.Kimura_______
H.Kimura _______
ABE J.Holmes _______
9
99
9
Clearing Jammed Paper
If jammed paper is torn and remains in the printer, or if
paper is jammed in a place not mentioned in this
chapter, contact your dealer.
wWarning:
Be careful not to touch the fuser, which is marked
CAUTION! HIGH TEMPERATURE, or the
surrounding areas. If the printer has been in use, the
fuser and the surrounding areas may be very hot.
Clearing the paper cassette
1. Pull the paper cassette out slowly until it stops. Be
careful not to tear the jammed paper.
2. Remove the jammed or crumpled paper. If the
paper is torn, be sure to remove all pieces.
3. Replace the paper in the paper cassette and close it.
4. Pull the paper path unit out slowly until it stops.
Be careful not to tear the jammed paper.
LProof Sign-off:
ABE K.Tsuno H.Kimura_______
H.Kimura _______
ABE J.Holmes _______
R4C4450 Quick Reference
Rev.C
A5 size QUICK.FM
7/18/00 Pass 0
10
1010
10
5. Pull out the jammed paper from the bottom of the
paper path unit.
6. Close the paper path unit firmly.
Clearing the MP tray
1. Pull the jammed paper out gently.
2. Pull the paper path unit out until it stops. Be careful
not to tear the jammed paper.
3. Open the unit cover by grasping the handle and
pulling up.
Autres manuels pour ColorPage EPL-C8200
4
Table des matières
Autres manuels Epson Imprimante
Epson
Epson Stylus Pro 7900 Manuel utilisateur
Epson
Epson Stylus Color 440 Mode d’emploi
Epson
Epson Stylus 1500 Manuel utilisateur
Epson
Epson B-310N - Business Color Ink Jet Printer Manuel utilisateur
Epson
Epson Stylus Color 660 Manuel utilisateur
Epson
Epson Stylus Photo 750 Manuel utilisateur
Epson
Epson XP-6100 Manuel utilisateur
Epson
Epson NX100 - Stylus All-In-One Manuel utilisateur
Epson
Epson PictureMate 238 Manuel utilisateur
Epson
Epson R200 - Stylus Photo Color Inkjet Printer Mode d’emploi
Epson
Epson 2000P - Stylus Photo Color Inkjet Printer Manuel utilisateur
Epson
Epson SC-S30600 Manuel utilisateur
Epson
Epson L1300 Manuel utilisateur
Epson
Epson SC-T5100 Series Manuel utilisateur
Epson
Epson AcuLaser CX37DN Guide Manuel utilisateur
Epson
Epson XP-610 Manuel utilisateur
Epson
Epson SC-T5400 SERIES Manuel utilisateur
Epson
Epson ActionPrinter 3250 Guide de référence
Epson
Epson Stylus Photo 720 Manuel utilisateur
Epson
Epson XP-8700 Series Mode d’emploi
