Epson OT-TB34 Manuel utilisateur

The OT-TB34 is an exclusive tear bar for the TM-C3400 to cut wrist band rolls from

General Data Company, Inc. (GD wristbands) manually at the perforation.

This guide explains how to install the tear bar in the TM-C3400.

1. Unlock the paper ejection guide with a

fine-tipped object.

2. Slide the paper ejection guide to as

narrow a position as possible.

3. Pull the release lever to open the roll

paper cover.

4. Insert two hooks of the tear bar into the

groove on the far side of the paper

ejection table.

5. Insert the other two hooks into the

groove on the near side.

6. Make sure that the tear bar is fully

inserted. If there is a gap between it and

the paper ejection table, press the bar

down to set it securely.

412390900

© 2012 Seiko Epson Corporation. All rights reserved.

Printed in Japan

Installation Guide

Installing the OT-TB34

Follow the steps below to install the tear bar on

the paper ejection table.

Paper ejection table

no gap

no gap

7. Slide the paper ejection guide to as wide a position as possible, and lock it.

Setting the Printer Driver

The following driver setting is required to cut GD wristbands at the perforation with the

tear bar, instead of cutting with the autocutter.

1. Select [No Auto Cut] and [Feed To Peel Off Position] in [Settings For Handling Media

After Print] in the [General] tab of the printer driver.

2. Disable the Cut button in [Panel Button Settings] in the [Maintenance And Utilities]

tab.

3. Click [OK] to complete the setting.

Installing GD Wristbands

1. Load the wrist band roll completely inside the printer with the printable side up

(black marks down).

2. Pass the wrist band through the tear bar.

3. Close the roll paper cover with care to keep the wrist band through the tear bar.

4. The wrist band is fed automatically when the roll paper cover is closed or the printer

is turned on.

For initial setting of the printer or details on making paper changes, see "Installing Paper"

in the TM-C3400 User's Manual.

Note:

Pulling the wrist band horizontally when cutting it may misalign it from its correct printing

position. Be sure to cut the wrist band while pulling it upward.

Cautions

Depending on the area, the interface cable may be included with the product. If so, use that cable.

Seiko Epson Corporation shall not be held liable for any damage resulting from electromagnetic

interference that occurs from the use of any interface cables other than those designated as Epson approved

products.

EPSON is a registered trademark of Seiko Epson Corporation in Japan and other countries/regions.

General Notice: Other product and company names used herein are for identification purposes only and

may be trademarks of their respective companies.

Table des matières

Autres manuels Epson Étiqueteuse

Epson

Epson LabelWorks LW-Z700FK Manuel utilisateur

Epson

Epson TM-T88 ReStick Guide de configuration rapide

Epson

Epson LabelWorks LW-400 Manuel utilisateur

Epson

Epson Labelworks LW-Z900 Manuel utilisateur

Epson

Epson LabelWorks LW-700 Manuel utilisateur

Epson

Epson Labelworks LW-Z900 Manuel utilisateur

Epson

Epson TM-C710 Manuel utilisateur

Epson

Epson TM-H6000II Manuel utilisateur

Epson

Epson LabelWorks LW-700 Manuel utilisateur

Epson

Epson TM-L90 series Manuel utilisateur

Epson

Epson TM-C3500 Series Manuel utilisateur

Epson

Epson LabelWorks LW-400 Manuel utilisateur

Epson

Epson LABELWORKS PX Series Manuel utilisateur

Epson

Epson LabelWorks LW-1000P Manuel utilisateur

Epson

Epson LabelWorks LW-700 Manuel utilisateur

Epson

Epson LABELWORKS LW-Z710 Manuel utilisateur

Epson

Epson LABELWORKS PX Manuel utilisateur

Epson

Epson ColorWorks CW-C6000 Series Manuel utilisateur

Epson

Epson TM-T88V-i Manuel d'utilisation et d'entretien

Epson

Epson SecurColor TM-C3400 Manuel utilisateur

Epson

Epson Labelworks LW-Z900 Manuel utilisateur

Epson

Epson TM-C7500 Series Manuel d'utilisation et d'entretien

Epson

Epson LabelWorks LW-Z900FK Manuel utilisateur

Epson

Epson LW-PX400 Manuel utilisateur

Manuels Étiqueteuse populaires d'autres marques

Brother

Brother P-Touch 2420PC Manuel utilisateur

newell

newell Dymo LabelManager 210D Manuel utilisateur

Brother

Brother TD-4000 Manuel utilisateur

U-Line

U-Line BROTHER H-8754 Manuel utilisateur

Tharo Systems

Tharo Systems H-435+ Manuel utilisateur

Brother

Brother E300 Manuel utilisateur

Godex

Godex RT700 SERIES Manuel utilisateur

ID Technology

ID Technology 252 Manuel utilisateur

Labelmate

Labelmate MC-11 Manuel utilisateur

CAB

CAB XD4M/300 Manuel utilisateur

Avery Dennison

Avery Dennison Pathfinder 6057 Manuel de service

Brother

Brother P-touch PT-9700PC Manuel utilisateur

TSC

TSC PEX1000 Series Manuel utilisateur

Adkins

Adkins Label Master Manuel utilisateur

Primera

Primera 510212 Manuel utilisateur

Brady

Brady BradyPrinter S3100 Manuel utilisateur

DuraLabel

DuraLabel LabPRO Manuel utilisateur

Novexx Solutions

Novexx Solutions XLP 604 Manuel utilisateur