Epson 400 Series Manuel utilisateur

EPSON®USB/Parallel Adapter

User’s Guide

CPD-7424R2

EPSON Stylus®COLOR 440 EPSON Stylus COLOR 1520®

EPSON Stylus COLOR 600 EPSON Stylus COLOR 3000

EPSON Stylus COLOR 640 EPSON Stylus Photo 700

EPSON Stylus COLOR 660 EPSON Stylus Photo EX

EPSON Stylus COLOR 800 EPSON Stylus Pro 5000

EPSON Stylus COLOR 850 EPSON Stylus Pro 9000

usb4.book Page i Wednesday, October 6, 1999 2:07 PM

EPSON and EPSON Stylus are registered trademarks of SEIKO EPSON

CORPORATION.

General Notice: Other product names used herein are for identification purposes only

and may be trademarks of their respective owners. EPSON disclaims any and all rights

in those marks.

usb4.book Page ii Wednesday, October 6, 1999 2:07 PM

iii

FCC Compliance Statement

For United States Users

This equipmenthas been tested and found to complywith the limits for aClassB digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses, and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

or television reception. However, there is no guarantee that interference will not occur in

a particular installation. If this equipment does cause interference to radio and

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures.

◗Reorient or relocate the receiving antenna.

◗Increase the separation between the equipment and receiver.

◗Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

◗Consult the dealer or an experienced radio/TV technician for help.

usb4.book Page iii Wednesday, October 6, 1999 2:07 PM

WARNING

The connection of a non-shielded equipment interface cable to this equipment will

invalidate the FCC Certification of this device and may cause interference levels which

exceed the limits established by the FCC for this equipment. It is the responsibility of

the user to obtain and use a shielded equipment interface cable with this device. If this

equipment has more than one interface connector, do not leave cables connected to

unused interfaces. Changes or modifications not expressly approved by the

manufacturer could void the user’s authority to operate the equipment.

For Canadian Users

This Class B digital apparatus meets all requirements of the Canadian Interference-

Causing Equipment Regulations.

Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur

le materiel brouilleur du Canada.

usb4.book Page iv Wednesday, October 6, 1999 2:07 PM

Contents

Introduction 1

Getting Started on a Macintosh 2

Setting Up the Computer 2

Setting Up the Printer 3

Connecting the Cable 3

Installing the USB Printer Software 7

Installing Your Creative Software and Electronic Manual 10

Getting Started on a Windows 98 System 11

Setting Up the Computer 11

Setting Up the Printer 15

Connecting the Cable 15

Installing the USB Printer Software 18

Enabling Windows Print Manager 22

Checking Your Installation 24

Installing Your Creative Software and Electronic Manual 25

Appendix 27

USB/Parallel Adapter Specifications 27

System Requirements 28

usb4.book Page v Wednesday, October 6, 1999 2:07 PM

Introduction

The EPSON USB/Parallel Adapter Kit lets you use smart cable technology to

connect your EPSON printer to an Apple®iMac,

™Power Macintosh®G3, or

Microsoft®Windows®98 computer. It supports the following printers:

* The software in this kit supports these two printers for Windows 98 only. To

connect one of them to an iMac or G3 using your EPSON USB/Parallel

Adapter, you have to install the software that came with your printer. See

your printer’s setup instructions.

To install the EPSON USB/Parallel Adapter, turn to one of these sections:

◗“Getting Started on a Macintosh” on page 2

◗“Getting Started on a Windows 98 System” on page 11

◗EPSON Stylus COLOR 440 ◗EPSON Stylus COLOR 1520

◗EPSON Stylus COLOR 600 ◗EPSON Stylus COLOR 3000

◗EPSON Stylus COLOR 640 ◗EPSON Stylus Photo 700

◗EPSON Stylus COLOR 660 ◗EPSON Stylus Photo EX

◗EPSON Stylus COLOR 800 ◗EPSON Stylus Pro 5000*

◗EPSON Stylus COLOR 850 ◗EPSON Stylus Pro 9000*

usb4.book Page 1 Wednesday, October 6, 1999 2:07 PM

If you have any problems installing the cable or software, contact your

EPSON dealer or EPSON technical support as described in the Where to

Get Help section of your printer documentation.

Getting Started on a Macintosh

The instructions on the next few pages explain how to connect the USB/

Parallel Adapter cable to your iMac or G3 and how to install the printer

software that came on the USB Printer Software CD-ROM.

IMPORTANT:

To connect an EPSON Stylus Pro 5000 or 9000 to your Macintosh using the

adapter, install the software that came with your printer instead of the

software included in this kit. See your printer’s setup instructions.

For all other printers, you must use the USB Printer Software CD-ROM

included in this kit. Follow the instructions below.

Setting Up the Computer

If you have an iMac, you may need to update your system before installing

the EPSON USB/Parallel Adapter.

◗If your iMacis running OS 8.1, you mustinstallApple’s iMac Update 1.0.

◗If your iMac is running OS 8.5 or 8.5.1, Apple recommends that you

install iMac Update 1.1.

usb4.book Page 2 Wednesday, October 6, 1999 2:07 PM

Download the update for your system at http://swupdates.info.apple.com.

Contact Apple if you have problems installing the update.

To find out which operating system your iMac is running, select About This

Computer in the Apple menu.

Setting Up the Printer

If you’ve been using your EPSON printer with your computer, the printer is

probably set up already. If so, turn off your system and disconnectthe printer

from the computer. Then go to “Connecting the Cable” below to attach the

USB/Parallel Adapter cable to your system.

If you’re setting up a new printer, see the documentation that came with your

printer for instructions on unpacking it, installing ink cartridges, and loading

paper. Then return to this booklet for instructions on connecting the cable

and installing your printer software.

Connecting the Cable

You can connect the USB/Parallel Adapter directly to a USB port on your

Macintosh or to a USB hub connected to a port on the Macintosh. If you

have any printing problems when the printer is connected via a USB hub, try

connecting the printer directly to a USB port on the computer instead.

usb4.book Page 3 Wednesday, October 6, 1999 2:07 PM

1 Connect the adapter to an available USB port on the side of your iMac

as shown, or to a USB port on the back of your G3. If you’re using a

USB hub, plug it into an available USB port on your iMac or G3, then

plug the adapter into a USB port on the hub. If you have more than one

hub, connect the adapter to the first hub.

USB port

optional

USB hub

USB/Parallel Adapter

usb4.book Page 4 Wednesday, October 6, 1999 2:07 PM

You can also connect the adapter to one of the USB ports on your

Macintosh keyboard. If you’re using a USB hub, plug it into the USB port

on the keyboard, then plug the adapter into a USB port on the hub. If

you have more than one hub, connect the adapter to the first hub.

OR optional USB hub

USB/Parallel Adapter

USB port

USB/Parallel Adapter

usb4.book Page 5 Wednesday, October 6, 1999 2:07 PM

Autres manuels pour 400 Series

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Epson Adaptateur

Manuels Adaptateur populaires d'autres marques

PCB Piezotronics

PCB Piezotronics 090B274 Manuel utilisateur

Auvidea

Auvidea J20 Manuel du produit

Gossen MetraWatt

Gossen MetraWatt AT3-III E Manuel utilisateur

Akribis

Akribis ITF-21-BISS-MIT Manuel utilisateur

Tenda

Tenda W54U Manuel utilisateur

ROHO

ROHO AGILITY Manuel utilisateur

PROLiNK

PROLiNK WN2001 Manuel utilisateur

Hawking

Hawking HUF2 Manuel utilisateur

Airlink101

Airlink101 AWLC4030 Manuel utilisateur

NETGEAR

NETGEAR XAV101v1 - Powerline AV Ethernet Adapter Manuel utilisateur

Philips

Philips SWA4554S/10 Manuel utilisateur

JVC

JVC TS-C9D2B Manuel d'instructions

NETGEAR

NETGEAR A6100 Manuel utilisateur

D-Link

D-Link DWA-121 Manuel utilisateur

Philips

Philips SWA2037 Manuel utilisateur

Basalte

Basalte 0610-20 Manuel utilisateur

Yealink

Yealink EHS40 Manuel utilisateur

Balluff

Balluff BIC 1B0-IT1A7-Q40KFU-SM4A4A Manuel utilisateur