Enwork Skyline Manuel utilisateur
Skyline Removable Bracket Panel Topper Installation Guide – Rev A.
SKYLINE REMOVABLE TOPPER
SCREEN INSTALLATION GUIDE
SCREENS
TI0051
WARNING:
Acrylic screens scratch and scuff easily. After removing
protective lm, immediately and carefully install the screen.
DO NOT remove protective lm from acrylic screens, then stack
them in a pile or against each other. Experience shows this will
cause marring and scratching.
INSTALLATION GUIDE
1) PARTS AND FASTENERS INCLUDED
Screen Panel
Tape
Binding Bolt Pair
PNM-1948 Bracket
PNM-1947 Bracket
Thumb Screw
2) TOOLS AND SUPPLIES REQUIRED
2x Phillips Screw Drivers
INSTALLATION GUIDE
Sandwich the Acrylic or Acoustic Panel Screen
between the Brackets, aligning the holes in the
screen and the bracket. Attach them all together
with the Binding Bolt pair as seen in FIGURE 1.
The screen may be non symmetrical (as shown) or
symmetrical.
Each screen will use (3) PNM-1947 brackets and (1)
PNM-1948 bracket as shown in FIGURE 2.
Attach (2-PNM 1947 brackets to one end. Attach
(1) PNM-1947 bracket and (1) PNM-1948 bracket to
the other end.
Take (2) pieces of tape. Both pieces should go onto
the PNM 1947 Bracket Pair seen on the left in
FIGURE 3.
Peel one side of the tape pieces off and stick them
down centered onto Bracket bases.
Clean the worksurface with Isopropyl Alcohol.
Peel the second backer off the tape pieces and
place the assembly in its desired location. Hold the
assembly down rmly for 30 seconds to activate
the tape.
NOTE: The tape cure time is 24 hours. Please
allow tape to cure before using screen.
FIGURE 1
FIGURE 2
FIGURE 3
3) ASSEMBLY:
INSTALLATION GUIDE
Screw the Thumbscrew tightly under the table to
secure the screen.
FIGURE 4
3) ASSEMBLY:
Specications subject to change without notice.
Rev 09.2020
1.800.815.7251
www.enwork.com
12900 Christopher Dr. Lowell, MI 49331
Table des matières
Autres manuels Enwork Écran de projection
