Enerzone Solution 2.3 Manuel utilisateur
READ AND KEEP THIS MANUAL FOR REFERENCE
Printed in Canada 46252I_A
SOLUTION 2.3
(EB00063 model)
Wood Stove
Owner's Manual
Part 2 of 2
INSTALLATION AND OPERATION
REQUIREMENTS
MOBILE
HOME
Safety tested according to ULC S627,
UL 1482 and UL 737 standards by an
accredited laboratory.
US Environmental Protection Agency
phase II certified wood stove compliant
with 2020 cord wood standard
CONTACT LOCAL BUILDING OR FIRE OFFICIALS ABOUT RESTRICTIONS AND INSTALLATION INSPECTION REQUIREMENTS
IN LOCAL AREA.
READ THIS ENTIRE MANUAL BEFORE INSTALLATION AND USE OF THIS WOOD STOVE. FAILURE TO FOLLOW THESE
INSTRUCTIONS COULD RESULT IN PROPERTY DAMAGE, BODILY INJURY OR EVEN DEATH.
ENGLISH
2021-06-18
PAGE COUVERTURE
ONLINE WARRANTY REGISTRATION
If the unit requires repairs during the warranty period, proof of purchase must be provided.
The purchase invoice must be kept. The date indicated on it establishes the warranty period.
If it can not be provided, the warranty period will be determined by the date of manufacture of the
product. It is also highly recommended to register the warranty online at
https://www.enerzone-intl.com/en/warranty/warranty-registration/
Registering the warranty will help to quickly find the information needed on the unit.
Dealer:
Installer:
Phone Number:
Serial Numbrer:
Page 3
Installation and Operation Requirements - Solution 2.3
ENGLISH
TABLE DES MATIÈRES
1. CERTIFICATION PLATE .......................................................................................................... 4
2. General Information ................................................................................................................ 5
2.1 Performances..................................................................................................................... 5
2.2 Specifications..................................................................................................................... 6
2.3 Dimensions ........................................................................................................................ 7
2.4 EPA Loading .....................................................................................................................12
3. Clearances to Combustible Material.................................................................................... 13
3.1 Clearances........................................................................................................................13
4. Floor Protection .................................................................................................................... 20
5. Reducing Wall and Ceiling Clearances Safely .................................................................... 21
5.1 Shield Construction Rules ..................................................................................................21
6. Installation of options on your product................................................................................ 24
6.1 Legs Installation (if present on your product) .......................................................................25
6.2 Pedestal Installation...........................................................................................................28
6.3 Decorative Panels..............................................................................................................30
6.4 Optional Airmate Installation...............................................................................................31
6.5 Optional Fresh Air Intake Kit Installation ..............................................................................32
6.6 Optional Fire Screen Installation ........................................................................................33
6.7 Optional Blower And Thermodisc Installation.......................................................................34
6.8 Air Tubes And Baffle Installation..........................................................................................35
6.9 Mobile Home Installation ....................................................................................................37
7. Maintenance/Parts Replacement......................................................................................... 38
7.1 Replacement.....................................................................................................................38
7.2 Gasket..............................................................................................................................39
7.3 Door .................................................................................................................................39
8. Exploded Diagram and Parts List ........................................................................................ 42
Enerzone Limited Lifetime Warranty ......................................................................................... 46
Page 4 Installation and Operation Requirements - Solution 2.3
ENGLISH
1. CERTIFICATION PLATE
Page 5
Installation and Operation Requirements - Solution 2.3
ENGLISH
2. General Information
2.1 Performances
Values are as measured per test method, except for the recommended heating area, firebox volume,
maximum burn time and maximum heat output.
Model Solution 2.3 (EB00063)
Combustion Technology Non-catalytic
Fuel Type Dry Cordwood
Recommended heating area (sq. ft..)1 500 to 2,100 ft2(47 to 195 m2)
Total firebox volume 2.4 ft3(0.068 m3)
Loading volume EPA 2.02 ft3(0.057 m3)
Maximum burn time18 hours
Maximum heat output (dry cordwood)2 75,000 BTU/h (22.0 kW)
Overall heat output rate (min. to max.)2 3 14,800 BTU/h to 28,600 BTU/h
(4.34 kW to 8.38 kW)
Average overall efficiency3
(Dry cordwood) 69 % (HHV)4 74 % (LVH)5
Optimum efficiency6 77 %
Optimum overall efficiency7 75 %
Average particulate emissions rate8 1.54 g/h (EPA / CSA B415.1-10)9
Average CO10 89.4 g/h
1Recommended heating area and maximum burn time may vary subject to location in home, chimney draft,heat loss factors, climate, fuel type
and other variables. The recommended heated area for a given appliance is dened by the manufacturer as its capacity to maintain a minimum
acceptable temperature in the designated area in case of a power failure.
2The maximum heat output (dry cordwood) is based on a loading density varying between 15 lb/ft3and 20 lb/ft3. Other performances are based on
a fuel load prescribed by the standard. The specied loading density varies between 7 lb/ft³ and 12 lb/ft3. The moisture content is between 19%
and 25%.
3As measured per CSA B415.1-10 stack loss method.
4Higher Heating Value of the fuel.
5Lower Heating Value of the fuel.
6Optimum overall efciency at a specic burn rate (LHV).
7The optimum heat transfer efciency is for the low burn rate and represents the appliance's ability to convert the energy contained in the wood logs
into energy transferred to the room in the form of heat and does not take into account the chemical losses during combustion.
8This appliance is ofcially tested and certied by an independent agency.
9Tested and certied in compliance with CFR 40 part 60, subpart AAA, section 60.534(a)(1(ii) and ASTM E3053-17. Based on ALT-125 sent by EPA on
February 28th, 2018.
10 Carbon monoxide.
Page 6 Installation and Operation Requirements - Solution 2.3
ENGLISH
2.2 Specifications
Maximum log length11 20 in (508 mm) east-west
Flue outlet diameter 6 in (150 mm)
Recommended connector pipe diameter 6 in (150 mm)
Type of chimney ULC-S629, UL 103 HT (2100 °F)
Minimum chimney height 12 feet
Baffle material C-Cast
Approved for alcove installation Yes
Approved for mobile home installation12 Yes
Type of door Simple, glass with cast iron frame
Type of glass Ceramic glass
Particulate emission standard13 EPA / CSA B415.1-10
USA standard (Safety) UL 1482, UL 737
Canada standard (Safety) ULC-S627
11 North-south: ends of the logs visible, East-west: sides of the logs visible.
12 Mobile homes (Canada) or manufactured homes (USA): The US Department of Housing and Urban Development describes “manufactured homes”
better known as “mobile homes” as follows; buildings built on xed wheels and those transported on temporary wheels/axles and set on a permanent
foundation. In Canada, a mobile home is a dwelling for which the manufacture and assembly of each component is completed or substantially
completed prior to being moved to a site for installation on a foundation and connection to service facilities and which conforms to the CAN/CSA-
Z240 MH standard.
13 Tested and certied in compliance with CFR 40 part 60, subpart AAA, section 60.534(a)(1(ii) and draft ASTM WK47329-14. Based on ALT-125
sent by EPA on February 28th, 2018.
Page 7
Installation and Operation Requirements - Solution 2.3
ENGLISH
2.3 Dimensions
2.3.1 Stove Dimensions with Square Legs
13 1/2"
343mm
27"
686mm
O
6"
153mm
9 5/8"
245mm
Figure 1: Top View
25 5/8"
651mm
10 5/8"
270mm
16 5/8"
422mm
28 1/4"
718mm
29 1/2"
748mm
23 5/8"
601mm
30 3/4"
781mm
28 3/8"
721mm
21 3/4"
554mm
26 1/4"
667mm
Figure 2: Front View Figure 3: Side View
Page 8 Installation and Operation Requirements - Solution 2.3
ENGLISH
2.3.2 Stove Dimensions with Legs
13 1/2"
343mm
27"
686mm
O
6"
9 5/8"
245mm
Figure 4: Top View
25 5/8"
651mm
10 5/8"
270mm
16 5/8"
422mm
25 1/4"
641mm
29 1/2"
748mm
23 5/8"
601mm
31 3/4"
807mm
29 3/8"
747mm
19 1/8"
486mm
26 1/4"
667mm
Figure 5: Front View Figure 6: Side View
Page 9
Installation and Operation Requirements - Solution 2.3
ENGLISH
2.3.3 Stove Dimensions with Round Legs
13 1/2"
343mm
27"
686mm
25 5/8"
651mm
O
6"
153mm
10 5/8"
270mm
16 5/8"
422mm
26 5/8"
675mm
9 5/8"
245mm
29 3/8"
746mm
23 5/8"
601mm
30 7/8"
784mm
28 1/2"
724mm
21"
532mm
KIT DE PATTES AC01293
ET AC01294
26 1/4"
665mm
Figure 7: Top View
25 5/8"
651mm
10 5/8"
270mm
16 5/8"
422mm
26 5/8"
675mm
Figure 8: Front View Figure 9: Side View
29 3/8"
746mm
23 5/8"
601mm
30 7/8"
784mm
28 1/2"
724mm
21"
532mm
26 1/4"
665mm
Page 10 Installation and Operation Requirements - Solution 2.3
ENGLISH
2.3.4 Dimensions with pedestal
13 1/2"
343mm
27"
686mm
9 5/8"
245mm
O
6"
153mm
Figure 10: Top View
10 5/8"
270mm
16 5/8"
422mm
29 1/2"
748mm
23 5/8"
601mm
32 3/4"
833mm
30 3/8"
773mm
17"
432mm
26 1/4"
667mm
Figure 11: Front View Figure 12: Side View
Autres manuels pour Solution 2.3
2
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels Enerzone Poêle à bois
Enerzone
Enerzone EB00011 Manuel utilisateur
Enerzone
Enerzone Solution 1.8 Manuel utilisateur
Enerzone
Enerzone Destination 1.6 Manuel utilisateur
Enerzone
Enerzone Solution 2.3 Manuel utilisateur
Enerzone
Enerzone Solution 1.6 AGENCY PHASE II CERTIFIED WOOD Manuel utilisateur
Enerzone
Enerzone Solution 2.9 Manuel utilisateur
Enerzone
Enerzone EB00002 Manuel utilisateur
Enerzone
Enerzone Solution 1.3 Manuel utilisateur
Enerzone
Enerzone EB00060 Manuel utilisateur
Enerzone
Enerzone Euromax EP00070 Manuel utilisateur
Enerzone
Enerzone Solution 2.3 Manuel utilisateur
Enerzone
Enerzone Destination 1.6 Manuel utilisateur
Enerzone
Enerzone Solution 1.6 Manuel utilisateur
Enerzone
Enerzone Solution 2.3 EB00012 Manuel utilisateur
Enerzone
Enerzone Solution 3.4 Manuel utilisateur
Enerzone
Enerzone Solution 1.3 Manuel utilisateur
Enerzone
Enerzone SOLUTION 1.7 Manuel utilisateur
Enerzone
Enerzone Harmony 2.3 Manuel utilisateur
Enerzone
Enerzone Solution 1.6 AGENCY PHASE II CERTIFIED WOOD Manuel utilisateur
Enerzone
Enerzone EB00032 Manuel utilisateur
