www.ener-j.co.uk
1. K10D controller uses TRIAC components. Supports incandescent lamp, tungsten lamp and mostly all LED lamp which
supports TRIAC dimming. If flickering occurs during dimming, we recommend replacing the LED lamp. Segmented dimmers
and lamps with dimmers are not supported.
2. This controller can only pair with push button switch: after pairing is successful, quickly press the push button switch 3 times
and you will be able adjust lamp brightness. Press the switch once when you reach the level of brightness desired. Also can
use mobile APP or Alexa voice control to control brightness.
3. This controller has a brightness memory function. When turn on the lamp again, it maintains the last brightness level. If
paired with multiple switches, this controller can memorize the brightness level of each switch.
4. If you didn’t press switch key to confirm the brightness, the controller dims from the darkest to brightest for 2 cycles, and will
stop dimming when reaching maximum brightness after 2 cycles.
Instruction of Dimming Function
1. Ensure the receiver controller is connected to 100-250V AC
and power is ‘on’.
2. Press the function button for 3~5 seconds, (the indicator
light will flicker slowly) then release the button to enter
the pairing mode.
3. Press the “wireless switch” to be paired, when the
indicator light stops flashing, at this time the indicator
lights will come on or off with the press of switch,
indicating pairing a success.
4. Repeat above steps to add multiple switches. The receiver
can store up to 20 switch codes.
5. Repeat this process for each button on Double and Triple
switch.
Switch Pairing Method
Press the button for more than 6~7 seconds, the indicator
quickly flashes 10 times and at the same time, the relay
performs the turn-on/off action quickly, this indicates all
recorded codes have been deleted.
Clear pairing
Press button
for 3 seconds
Indicator(red)
Press to
complete the
code
Press button
for 6-7 seconds
Indicator(red)
1. How to use the item? Is it easy to install?
Super easy to install. In just 3 steps, you can add or relocate a wireless switch for your house within 5 minutes.
1. Install the receiver between the lamp to be controlled and the power supply,
2. Program the receiver and wireless switch,
3. The wireless switch can be placed where it matters, or carried with you.
2. If the switch is on and there is a power cut, will the switch still be on when power is restored? If not can the default action
be changed?
The default setting is off, so the switch will not stay on. This can prevent the sudden increase in voltage and current when the
power supply is restored from damaging the lamp.
The default setting can be changed by pressing and holding the receiver setting button for 16 seconds, and releasing your
finger when the indicator light stays on.
3. Will it cause signal interference if multiple wireless switches are installed in the home?
No. The signal between the paired switch and the receiver is independent and encrypted. Will not cause interference.
FAQ
