Eneo MPD-78M2713M0A Manuel utilisateur

User Manual

1/2.8" HD Dome Fix, Day&Night,

3840x2160, Infrared, WDR,

2.7-13.5mm, 12VDC, IP67

MPD-78M2713M0A

Safety Precaution

ULTRA CLEAR RESOLUTION CAMERA

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK).

NO USER SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

To prevent fire or shock hazard, do not expose the unit to rain or moisture.

To prevent electric shocks and risk of fire hazards, do NOT use other than

specific power source.

The symbol is intended to alert the user to the presence of important

operating and maintenance(servicing) instructions in the literature

accompanying the unit.

The symbol is intended to alert the user to the presence of uninsulated

"dangerous voltage" within the product's enclosure that may be of

sufficient magnitude to constitute a risk of electric shock to persons.

Warning :

This equipment has been tested and found to comply with the limits for a Class

A digital device, pursuant to part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference when the equipment

is operated in a commercial environment. This equipment generates, uses, and

can radiate radio frequency energy and, if not installed and used in accordance with

the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful

interference in which case the user will be required to correct the interference at

his own expense.

Caution :

Any changes or modifications in construction of this device which are not expressly

approved by the party responsible for compliance could void the user's authority

to operate the equipment.

Mains power quality should be that of a typical commercial environment. If the user

of the model requires continued operation during power mains interruptions, it is

recommended that the model be powered from an uninterruptible power supply

(UPS) or a battery.

ULTRA CLEAR RESOLUTION CAMERA

Safety Precaution

NOTICE

The image used in this instruction manual are processed to help comprehension

and may differ from actual video of the camera.

Avoid installing areas where has shock or vibration which results in the problems.

Pay attention to safety when laying the connection cable and observe that the cable

is not subjected to heavy loads, kinks or damage and no moisture can get in.

The warranty becomes void if repairs are undertaken by unauthorized persons.

Maintenance and repair have to be carried out only by authorized service centers.

Use only a mild detergent to clean the housing.

The camera should never be operated beyond the technical specifications.

This can lead to destruction.

The camera should never be operated in water.

ULTRA CLEAR RESOLUTION CAMERA

Contents

Safety Precaution

p.03~04

Contents

p.05

Features

p.06

Composition

p.07

Dimensions

p.07

Part Names

p.08

Installation Instructions

p.09~12

Operating Instructions

p.13~32

Specifications

p.33

ULTRA CLEAR RESOLUTION CAMERA

Features

Key Features

• 8Mega Pixel CAMERA, 3840x2160(15/12.5fps)

• The best low light performance with SONY’s STARVIS sensor

• Video output EX-SDI / HD-SDI / THD / CHD / AHD /

CVBS(960H) Selectable

• THD mode / AHD mode / CHD mode,

Video Transmission Distance over Coax.; 500M

• f= 2.7~13.5mm, 8 MP Motorized Zoom lens

• Motorized Zoom & Focus adjustment

• DIS (Digital Image Stabilization) function

• DOL(Digital OverLap) WDR

• ROI (Region of Interest) WDR mode:

- Proper compensation of exposure for each inside and outside

of interested area.

- Better contrast and No motion ghost effect

• Improved Noise figure with the enhanced 3D-NR

• Motion Detection, Privacy Mask, Defog, Sens-up,

D-Zoom, Sharpness, Mirror/Flip, BLC/HLC,

LSC (Lens Shading Compensation)

• OSD Menu for easy installation & maintenance

• Menu control by UTC(THD/AHD) through compatible DVR

• Circuit protection against faulty connection in power polarity

• Isolated power supply against ground loop problem

• Built-in 2pcs High power LED

• Flush mount (Option: Surface mount and Various adaptors)

• Double side Anti-Scratch Hard coated clear bubble dome

• IP67/IK10 Protection

• Power: AC24V/DC12V

Composition

ULTRA CLEAR RESOLUTION CAMERA

Dimensions

(unit : mm)

Mounting Template

Operating

InstructionDome Camera

Torque Wrench:

3mm (1pc)

Video Sub-out

Cable (1pc)

Mounting Screw:

4 x 30mm (3pcs)

Plastic Anchor:

6 x 30mm (3pcs)

Ø140 119

PCD Ø120

Ø102

3-Ø4.2

Ø100

ULTRA CLEAR RESOLUTION CAMERA

Part Names

BUBBLE DOME

3-AXIS GIMBAL

DOME COVER

SAFTY WIRE

FLUSH MOUNT

LENS

POWER CABLE

VIDEO OUTPUT

[ BOTTOM VIEW ]

POWER SUPPLY

CONNECTOR

POWER

CABLE

OSD Menu Control board

HD-SDIEX-SDI

ULTRA CLEAR RESOLUTION CAMERA

Installation Instructions

• Surface mount

• Pole mount adaptor

• Tilted mount

• Wall mount

(Requires additional

Surface mount)

• Tilted junction mount

■ Optional Mounting Accessories

1. Locate the mounting template at the installation position and drill the ceiling

or wall if needed.

2. Open the dome cover by loosening screws(4x12mm). Use the torque wrench

supplied.

3. Set the camera’s viewing angle.

4. Put the dome cover to the dome base unit and tighten the assembly screws.

- Place the dome base unit on pre-drilled position and fix it through using mounting

screws (4x30mm).

- Route the power source cable and connect cables.

- In the case of installation with optional mounting accessories(Surface mount

or Tilted mount), the power cable should be fixed to the flush mount by using

the fixing screw and cable holder as illustrated.

Mounting Screw

(4x30mm)

Plastic Anchor

(6x30mm)

Torque

Wrench

ULTRA CLEAR RESOLUTION CAMERA

Installation Instructions

■Option 2.

Installation with Surface mount / Tilted mount

■Option 1.

Installation with Flush mount / Tilted Junction mount

Cable Holder

Video Output

Cables

①Cable is unfixed on the Dome base.

② Connect the power cable to their repective connections.

① Cable is unfixed on the Dome base.

②Tie up the VIDEO OUTPUT cables with cable holder.

③ Tie up the POWER SUPPLY cable with cable holder as illustrated.

④Connect the wiring connector to their repective connections.

Cable Holder

Power Supply

• In the case of installation with Flush/ Surface/ Tilted mount, IP protection

rating is not guaranteed.

• If power/video connectors are exposed to water or rain, separate protection

shield is essential.

CAUTION

Table des matières

Autres manuels Eneo Caméra de sécurité

Eneo

Eneo FASTRAX III Manuel utilisateur

Eneo

Eneo Minitrax HDD-1012PTZ1080 Manuel utilisateur

Eneo

Eneo VKC-13100F2810IR Manuel utilisateur

Eneo

Eneo VKCD-1338 Manuel utilisateur

Eneo

Eneo INP-72A0018MIA Manuel utilisateur

Eneo

Eneo PXB-2080Z03 D Manuel utilisateur

Eneo

Eneo VKC-1424-36 Manuel utilisateur

Eneo

Eneo HDD-2000MIR720 Manuel utilisateur

Eneo

Eneo VKC-1331A Manuel utilisateur

Eneo

Eneo ISM-72F0021W0A Instructions d'installation

Eneo

Eneo 213021 Manuel utilisateur

Eneo

Eneo IEP-63M2812M0A Manuel utilisateur

Eneo

Eneo HDD-2080MIR Manuel utilisateur

Eneo

Eneo ISM-52F0046MPA Manuel utilisateur

Eneo

Eneo VKC-1370/12-24 Manuel utilisateur

Eneo

Eneo VKCD-13100F2810 Manuel utilisateur

Eneo

Eneo MPD-62M2812P0A Manuel utilisateur

Eneo

Eneo NXD-1502M Manuel utilisateur

Eneo

Eneo IPD-52F0028MAA Manuel utilisateur

Eneo

Eneo ICB-62M2712M0A Manuel utilisateur

Eneo

Eneo IPD-75M3610M0A Manuel utilisateur

Eneo

Eneo VKC-1415 Manuel utilisateur

Eneo

Eneo IND Series Manuel utilisateur

Eneo

Eneo IPD-73M2812MWA Manuel utilisateur

Manuels Caméra de sécurité populaires d'autres marques

Okina USA

Okina USA SIR36-870VF650LP Manuel utilisateur

Divio

Divio NDR155PA Manuel utilisateur

Canon

Canon VB-C500D Manuel utilisateur

Easy Access

Easy Access EasyGuard Manuel utilisateur

Vivotek

Vivotek FD9389-EHV-v2 Manuel utilisateur

TUYA

TUYA COSMO W2 Manuel utilisateur

Eusso

Eusso UNC7500-IR Guide de configuration

urmet domus

urmet domus 1096/204 Manuel utilisateur

VC VC20 series Manuel utilisateur

Axis

Axis Q1614 Manuel utilisateur

ieGeek

ieGeek DD201 Manuel utilisateur

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Manuel utilisateur

Vicon

Vicon V662-D-1 Mode d'emploi

Grundig

Grundig GCH-K0274P Manuel utilisateur

Lorex

Lorex VANTAGE LBC7032 Manuel utilisateur

4xem

4xem WPT Manuel utilisateur

Samsung

Samsung SCV-3082 Manuel utilisateur

Vitek

Vitek VTC-C544 Manuel utilisateur