In order to perform each of the following six functions, the lock must rst be placed in Programming Mode:
*If no input within 10 seconds, Yellow LED goes out, Red LED ashes and lock exits Programming Mode.
1. Press and hold EMTEK button for 3 seconds
2. Yellow LED ashes, then remains solid*
3. Enter Programming Code
4. Green LED ashes, then 2 beeps
5. Yellow LED remains solid
(awaiting button press; see following table)
If You Wish To Press Button Actions Indicators
Change
Programming Code
(6 digits)
1
Enter New
Programming
Code
(6 digits)
Re-Enter New
Programming
Code
(6 digits)
• 1 Green LED ash
• 1 beep
• 1 Green LED ash
• 1 beep
• 2 Green LED ashes
• 2 beeps
Add User Code
(4 digits)
(Store up to 20 User Codes)
2
Enter New User
Code
(4 digits)
Re-Enter New
User Code
(4 digits)
• 1 Green LED ash
• 1 beep
• 1 Green LED ash
• 1 beep
• 2 Green LED ashes
• 2 beeps
Delete User Code 3Enter User Code
to be Deleted
Re-Enter User
Code to be
Deleted
• 1 Green LED ash
• 1 beep
• 1 Green LED ash
• 1 beep
• 2 Green LED ashes
• 2 beeps
**Enable/Disable All User Codes 4Entering‘4’disables all Users
(enables all if disabled)
• 2 Green LED ashes
• 2 beeps
Delete All User Codes 5Re-Enter Programming Code
• 1 Green LED ash
• 1 beep
• 2 Green LED ashes
• 2 beeps
Turn Beeper On/O 6Entering‘6’turns OFF (or ON)
• 1 Green LED ash
• 1 beep
• 2 Green LED ashes
• 2 beeps
**Also referred to as “vacation mode”. This command temporarily disables all user codes (metal key override will still work).
How to Program
Programming Your Lock
