Emerson SITETPI-E V3 Manuel utilisateur

SITETPI-E V3

Product Specification/Installation Sheet

Description

The Liebert SiteTPI-E is an Ethernet-

ready device intended to interface

specifically to a SiteScan Web system.

It is a 32-bit microprocessor-based

device designed to monitor third-party

equipment via an EIA-485/232

Modbus interface.

Logically the device sits on the

Ethernet network, providing the

interface to SiteScan Web. This

effectively creates a router/gateway

and third-party interface in a single

device. Screw terminal blocks are

provided to terminate power,

communication and input signal

wiring.

Module Dimensions and Layout

Module

Address

Format

On Off

Power

CONTROL MODULE

24V ac/dc

Ground

EIA-485

EIA-232

485-4w

485-2w

Archive Valid

Port S1 receive

Port S1 transmit

BACnet receive

BACnet transmit

Battery low

Status

Module

2 wire 4 wire

Rx -

Net-

Net+

n/c

Tx -

Tx +

Rx +n/c

EIA-232

DCD

DTR

Signal Ground

Ext. Batt.

Int. Batt.

External

Battery

Gnd

+3V

Blinking Dot = 'Run'

Port S1

Class 2

Use Copper Conductors Only

24Vac, 24VA, 1A, 50-60 Hz

Without Keypad Display:

26Vdc, 10W, 0.4A

Open Energy

Management Equipment

88FO

E143900

TYPE: 002001

Power

LED

Error Codes:

0 = Download required

1 = Control Program Error

2 = RAM full

3 = Comm setup error

4 = System error

8 = Formatting

Chase = OK

Option

Comm

IP Addr

Default

Assigned +100

Address

Enable

Disable

on S1

Off

MSTP

Enable

Disable

on S2

PTP

Shield

Net -

Net +

Port S2

Local Access

Rnet

10/100 BaseT

Ethernet Port E1

BACnet

100 LAN LINK

Gnd

Rnet +

Rnet -

+12V

BACnet

Over ARCNET156 KBaud

BT485

EIA-485

EIA-232

485

n/c

Net+

Net-

232

DTR

DCD

Signal Gnd

EIA- Tx

BT485

Made in USA

3V Lithium Battery

CR-123A

Enhanced Access

Port on S2

and Rnet

10's 1's

SiteTPI-E

™

Ethernet

port

Port S1 Options

comm

Local access

port

2.5"

(64mm)

1.25"

(32mm)

7.5"

(190.5mm)

Diagnostic

LED indicators

Port S2

Rnet port

BACnet

port

2.5"

(64mm)

1.25"

(32mm)

11.295"

(286.9mm) 0.23"

(5.8mm)

Power

connector

Power Wiring Diagrams

Enclosure Dimensions

Enclosure Mounting

The enclosure may be mounted on a wall or on the floor. Refer to the following diagrams for

your application.

Enclosure Wall Mounting Diagram

Enclosure Floor Mounting Diagram

to change without notice.

® Liebert and the Liebert logo are registered trademarks of

Liebert Corporation. All names referred to are trademarks or

registered trademarks of their respective owners.

SL-28105 (2/06) Rev. 1

Liebert Corporation

1050 Dearborn Drive

P.O. Box 29186

Columbus, OH 43229

Telephone: 1-800-877-9222

Facsimile: 1-614-841-6022

www.liebert.com

Specifications

Diagnostic LEDs

Wiring Specifications

Ordering Information

Power 24VAC ±10%, 50 to 60Hz, 24VA, or 26VDC ±10%, 10W

Dimensions

W x D x H: in. (mm)

Module:

11.295 x 0.56 x 7.5 (286.9 x 14.2 x 190.5)

Enclosure (painted steel):

14.25 x 2.85 x 12 (362 x 72.4 x 304.8)

Communication

• One (1) Ethernet 10/100BaseT RJ-45 port

• One (1) Configurable Serial Port - EIA-232 or 485 (2- or 4-wire)

• 5-position Terminal Block

• One (1) CMnet EIA-485 Port - Control Module network screw terminals

• Switch-selectable baud rates ARC156 / 9600 or 38.4bps

• Recommended wire: MAGNUM Cable P/N A3-ARC-156-2

•BACnet Port (ARCNET156 or EIA-485 communication): In ARCNET156 mode, the port speaks

BACnet ARC156. In EIA-485 mode, DIP switch settings specify baud rate and protocol: BACnet

MS/TP or Modbus (RTU or ASCII).

•Port S1 (BMS connection): Normally configured for a Building Management System; may be

configured for EIA-485 or EIA-232. Supports BACnet MS/TP, BACnet PTP and Modbus (RTU or

ASCII) protocols.

•Port S2 (MFR connection): Connection to manufacturer’s equipment; jumper enables EIA-485 or

EIA-232 mode. Supports BACnet MS/TP, BACnet PTP and Modbus (RTU or ASCII) protocols.

•Rnet: Local laptop and/or BACview access port. Conforms to the BACnet Advanced Application

Controller (B-AAC) Standard Device as defined in BACnet 135-2001 Annex L.

Environmental

Operating Range

20°F to 140°F (-29°C to 60°C); 10 to 90% relative humidity, non-condensing.

Note: Control modules should be installed within the building.

Memory 16 MByte non-volatile battery-backed SDRAM (with 12 MBytes available for use)

8 MByte Flash memory, 32-bit memory bus

Protection Built-in surge and transient protection circuitry

Battery 3V lithium battery P/N CR-123A; battery shelf life is 10 years with 720 hours of continuous operation

Fault Detection Hardware watchdog timer

Agency Listings UL916 (Canadian Std C22.2 No. 205-M1983), CE, FCC Part 15 - Subpart B - Class A

Indicator Description Indicator Description

BACnet transmit Blinks when data is transmitted Port S1 transmit Blinks when data is transmitted

BACnet receive Blinks when data is received Port S1 receive Blinks when data is received

Archive Valid N/A Battery low Blinks when the battery is low

Connection Supported Wire Types Maximum Wire Length Rating

Ethernet 10 BaseT CAT 5 328 ft. (100m) N/A

Port S1 ARCnet MAGNUM Cable P/N A3-ARC-156-2 3000 ft. (915m) N/A

Port S2 EIA-485 18-22 AWG Stranded & Shielded; 18 AWG* (recommended)

Non Plenum - Belden 9461; Plenum - Belden 88761 1000 ft. (300m) N/A

Port S2 EIA-232 18-22 AWG Stranded & Shielded; 18 AWG* (recommended)

Non Plenum - Belden 9461; Plenum - Belden 88761 50 ft. (15m) N/A

Quantity Part # Description

SiteTPI-E SiteScan Web Third-Party Interface Module - Ethernet Ready

Table des matières

Autres manuels Emerson Matériel réseau

Emerson

Emerson PACSystems RX3i Manuel utilisateur

Emerson

Emerson Nform And Interface Products Manuel utilisateur

Emerson

Emerson Liebert IntelliSlot Unity-DP Manuel utilisateur

Emerson

Emerson Centellis 2000 Guide de démarrage rapide

Emerson

Emerson Bristol Helicoid Gauges Instructions d'utilisation et de sécurité

Emerson

Emerson SiteLink-12E Instructions d'installation

Emerson

Emerson ATCA-F140 Guide de démarrage rapide

Emerson

Emerson PACSystems IPC 2010 Guide rapide de l'utilisateur

Emerson

Emerson AXP1620 Guide de démarrage rapide

Emerson

Emerson STXPBS001 Manuel utilisateur

Emerson

Emerson AXP 1410 Guide de démarrage rapide

Emerson

Emerson dixell Manuel utilisateur

Emerson

Emerson SI-EtherCAT Manuel utilisateur

Emerson

Emerson Liebert SiteLink-4 Manuel utilisateur

Emerson

Emerson NXL 400 Manuel utilisateur

Emerson

Emerson SiteI/O 10/0 Manuel utilisateur

Emerson

Emerson PACSystems VersaPoint Guide de l'utilisateur

Emerson

Emerson Liebert SiteLink-12 Manuel utilisateur

Emerson

Emerson ControlWave Remote Ethernet I/O Manuel d'utilisation

Emerson

Emerson ACC/ARTM-7221/SCSI Manuel utilisateur

Manuels Matériel réseau populaires d'autres marques

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Manuel utilisateur

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Manuel utilisateur

Yudor

Yudor YDS-16 Manuel utilisateur

D-Link

D-Link ShareCenter DNS-320L Manuel utilisateur

Samsung

Samsung ES1642dc Instructions d'utilisation

Honeywell Home

Honeywell Home LTEM-PV Instructions de montage

evertz

evertz 7700 Series Manuel utilisateur

D-Link

D-Link ShareCenter DNS-343 Manuel utilisateur

Asante

Asante AsanteBridge 1012 Manuel utilisateur

FireBrick

FireBrick FB2700 Manuel utilisateur

Audiovox Electronics

Audiovox Electronics ARWH2T Manuel utilisateur

ADC

ADC DSX-1 Manuel

NetComm

NetComm NF2 Manuel utilisateur

Alcatel-Lucent

Alcatel-Lucent 5620 Manuel utilisateur

Dell EMC

Dell EMC XC6420 Series Manuel utilisateur

Lanner

Lanner NCA-1020A Manuel utilisateur

Allied Telesis

Allied Telesis AT-TN121-A Manuel utilisateur

Arista

Arista CCA-ETM-Q12 Manuel utilisateur