E-680
E-680
11
12
2.1 General
When the device is in normal operation state, the button can be used
to switch to the totalizer and the alarm pages. When the device is in
manual mode and the button is pressed, totalizer value is displayed.
In this page, simultaneously pressing and buttons reset totalizer.
Next to the totalizer page, alarm pages are reached. All alarms (Set 1,
Set 2) can be seen together in these pages. In the first alarm page,
alarms of the channels 1 to 16 are displayed and letter A is shown in the
last digit. In the second alarm page, alarms of channels 17 to 32 are
displayed and letter B is shown in the last digit. In the third alarm page,
status of the output relays R1 to R16 are displayed and letter O is shown
in the last digit. Figure 2.2. shows the display format of the alarm pages.
While in the totalizer or alarm pages pressing the button reverts to the
normal operation page. Alarm status of the channel which are not active
or closed for scanning are shown as empty.
(continue on next page)
Normal Operation State
Totalizer
(Only in manual
mode)
Auto. / Manual
Toggling
Alarm Page
1-16
Alarm Page
17-32
Relay Page
1-16
2.1 General
Figure 2.2. Alarm Pages
SET 1 alarm for the channels 1,2,3,5,7,8,9,11,13,14 and 15
SET 2 alarm for the channels 1,2,3,5,7,13 and 14
SET2
SET1
CHANNEL ALARM
MEASURED
VALUE
SET 1 alarm for the channels 17,18,19,21,23,24,25,27,29,30 and 31
SET 2 alarm for the channels 17,18,19,21,23,29 and 30
SET2
SET1
CHANNEL ALARM
MEASURED
VALUE
Output relays 1,3,5,6,7,13,15 are energized.
SET2
SET1
CHANNEL ALARM
MEASURED
VALUE
abdaddddA
654654654
abdaddddB
abdaddddO
01 100.0 c
abdgkkakA
abdgkkakB
ddad ddO
E-680
13
2.2 Configuration Pages
CoD= 0
PAGE= GCNF
Normal
Operation State
Parameters
Configuration
Password
$999 - 9999
GCNF, ACNF,ICNF
PRTC, CLBR
Configuration
Pages
When the device is in the normal operation state, pressing the and
buttons simultaneously enters the configuration mode. When the
configuration mode is entered, “COD” message is displayed for the
security code. Security code is entered by using the buttons and .
The factory setting of the security code is “10”. If the correct code is
entered, the user is authorized to change all the device settings including
the calibration. Otherwise, the rights are only restricted to the settings of
the “PRTC” page. After this process, PAGE = is written to first 5 digit of
display and the name of the page is displayed in the last 4 digit. To pass
between menus the and buttons are used. In order to return to the
normal operation state, the button should be pressed. In order to
access to any configuration page, the button is used and by pressing
this button, the parameters in this page are displayed one by one. In this
step, the parameter name is indicated in the first 4 digits of the display,
and the parameter value is indicated in the last 4 digit of led display. In
order to change the parameter values, the and buttons are used. To
exit from any page the button is used.
Configuration Pages
