Introduction
www.emsdiasum.com
Toll Free: 1-800-523-5874
Electron Microscopy Sciences
Tel: 215-412-8400 sFax: 215-412-8450
WARNINGS
Safety Warnings
• Never use Tester on live circuits.
• DO NOT use a damaged Tester.
• Inspect the Tester case before using
• Inspect the Pin Holder – ensure that the gold-plate is not damaged
• To prevent the pin tip from damage, DO NOT use the Tester as tweezers
• DO NOT apply external voltage between the two pins.
• DO NOT use in an environment with explosive gas, vapor, or dus
• There are situations where hazardous condition may exist, even though the Tester is not
used to measure DC/AC Voltage or current.
Specications
• 3000 count LCD display
• Full automatic measurement: Auto scanning the Resistance/Capacitance/Diode.
• Function selection by one FUNC Push Button
• Data Hold function
• Continuity Checking function
• Over Load Indication (OL)
• Low Battery Indication
• Power Supply: 3V Lithium Battery (CR2032)
• Test Pins are gold-plated
• Auto Power OFF: If the Tester is idle for more than 10 minutes, Tester automatically turns the power off.
• Operating temperature and Humidity: 0 ~ 40oC (32 ~104oF) and < 80% RH
• Storage temperature and Humidity: -10 ~ 50oC (14 ~ 122oF) and <70%RH
• Safety Class: IEC1010-1, CAT II
• EMC: According to CE regulation 89/336
• Dimension (L x W x H): 170 x 31 x 17 mm; Weight: approx. 48.6 g
• Environmental condition: Indoor use only, up to an altitude of 2000 meters
Carefully read and understand this manual before using the Tester.
Precise, non-magnetic tips reliably contact smallest SMD (surface mount device). The Quick Test tweezers gives users an
easy way to sort and evaluate loose components and to perform on-board measurements and debugging. Surface mount
devices are usually tiny and without wire leads, making it much more difcult to test and identify SMD than conventional
components. Precise tips, made of non-magnetic steel, are able to pick and reliably contact even the smallest SMD compo-
nents, or take measurements from the device already mounted on a board. The probe can also be used to test conventional
components with wire leads too short to insert into the test terminals.
Features:
• Measures AC/DC voltage, resistance, continuity & diode test
• Auto Scanning Mode/Auto range
• Testing pins gold plated to reduce resistance and prevent rust
• Uses Lithium battery CR2032, included
• Will automatically identify whether component is a resistor, capacitor or diode
