Ekwb EK-Quantum Vector D-RGB Upgrade Kit Manuel utilisateur

INSTALLATION MANUAL

EKQuantum

Vector D-RGB Upgrade Kit

- 2 -

This product is intended for installation by expert users only. Please

consult with a qualiﬁed technician. Improper installation may result

in damage to your equipment. EK Water Blocks assumes no liability

whatsoever, expressed or implied, for the use of these products or their

installation. The following instructions are subject to change without

notice. Please, read the manual carefully before beginning with the

installation process.

- 3 -

TABLE OF CONTENT

DISCONNECT THE LEDs 4

REPLACE THE STICKOUT 4

ATTACHING THE NEW STICKOUT AND D-RGB LED 5

PLEXI VERSION 5

ACETAL VERSION 5

ATTACHING THE D-RGB TERMINAL COVER 6

IMPORTANT INFORMATION 6

CONNECTING THE D-RGB LED STRIP 7

SUPPORT AND SERVICE 8

SOCIAL MEDIA 8

- 4 -

DISCONNECT THE LEDs

First, disconnect the cable between the Terminal Cover and Stickout.

After that, remove the Terminal Cover from the FC Terminal.

Remove the Stickout from the water block and store the screws for

later use.

If you have the Acetal version of the water block, do not

forget to remove the RGB LED from the Acetal part.

REPLACE THE STICKOUT

Stickout

Stickout Screws

- 5 -

ATTACHING THE NEW STICKOUT AND D-RGB LED

Stickout

PLEXI VERSION

Take the Stickout and D-RGB LED from the box.

Remove the protective foil from D-RGB LED and attach the LED to the

Stickout.

After this, use the stored screws to secure the Stickout to the Plexi part.

D-RGB LED

Stickout

ACETAL VERSION

Take the Stickout and D-RGB LED from the box.

Remove the protective foil from D-RGB LED and attach the LED to the

Acetal. D-RGB is oriented towards the Stickout.

After this, use the stored screws to secure the Stickout to the Acetal part.

D-RGB LED

- 6 -

IMPORTANT INFORMATION

Do not forget to connect the D-RGB LED cable of the Stickout

to the cable of the Terminal Cover.

In case you have 2 (two) Stickouts:

First, connect the Stickout cables and then you can connect

them to the Terminal Cover cable!

Take the pre-assembled D-RGB Terminal Cover from the box and

attach it to the FC Terminal.

ATTACHING THE D-RGB TERMINAL COVER

- 7 -

CONNECTING THE D-RGB LED STRIP

Plug the 3-pin connector from the water block’s D-RGB LED light in

the D-RGB HEADER on the motherboard. The LED will work if the pin

layout on the header is as follows: +5V, Digital.

Please ensure that the arrow indicated on the connector is

plugged into the +5V line as indicated on your motherboard.

If you connect the LE Diode to the 12V RGB HEADER you

can damage the LEDs.

D-RGB Header

RGB Header

For assistance please contact:

http://support.ekwb.com/

EKWB d.o.o.

Pod lipami 18

1218 Komenda

Slovenia - EU

EKWaterBlocks

@EKWaterBlocks

ekwaterblocks

EKWBofﬁcial

SUPPORT AND SERVICE

SOCIAL MEDIA

Table des matières

Autres manuels ekwb Accessoires informatiques

ekwb

ekwb EK-FC 5870 Series Manuel

ekwb

ekwb EK-Supreme LTX CSQ Series Manuel

ekwb

ekwb EK-Pro GPU Quick Disconnect Kit Manuel utilisateur

ekwb

ekwb EK-FC 6970 V2 Mode d’emploi

ekwb

ekwb EK-FC R9-290X Matrix Series Manuel

ekwb

ekwb EK-FC R9-290X SE Series Manuel

ekwb

ekwb EK-FC GV100 PRO Manuel utilisateur

ekwb

ekwb EK-FC6990 Manuel

ekwb

ekwb EK-FC970 GTX Series Manuel

ekwb

ekwb EK-FC Strix RTX 2080 Ti Backplate Classic Manuel utilisateur

ekwb

ekwb EK-FB Manuel

ekwb

ekwb EK-FC1080 GTX Ti Aorus Series Manuel utilisateur

ekwb

ekwb EK-Classic DP Side PC-O11D G1 D-RGB + DDC 3.2... Manuel utilisateur

ekwb

ekwb EK-FB ASUS Strix X470 RGB Series Manuel utilisateur

ekwb

ekwb EK-FC Titan X Pascal Series Manuel utilisateur

ekwb

ekwb EK-DCP Manuel

ekwb

ekwb EK-FC R9-285 Series Manuel

ekwb

ekwb EK-FB ASUS ROG R6E Monoblock Manuel utilisateur

ekwb

ekwb EK-FC Titan SE Series Manuel

ekwb

ekwb EK-DBAY D5 Manuel

ekwb

ekwb EK-FC570 GTX SE Series Manuel

ekwb

ekwb EK-Supremacy EVO RGB Manuel utilisateur

ekwb

ekwb EK-FB GA Z270X Monoblock Series Manuel utilisateur

ekwb

ekwb EK-FC Radeon Vega Strix Series Manuel utilisateur

Manuels Accessoires informatiques populaires d'autres marques

Motorola

Motorola ATRIX Manuel utilisateur

HP USB Media Docking Station Manuel utilisateur

Cherry

Cherry B.UNLIMITED 3.0 Manuel utilisateur

Logitech

Logitech IO2 Manuel utilisateur

ARM

ARM DSTREAM-ST Manuel utilisateur

Bartec

Bartec TC 7 Series Manuel utilisateur

Philips

Philips SPC3540 Manuel utilisateur

Logitech

Logitech mk220 Manuel utilisateur

SilverStone

SilverStone LC02 Manuel utilisateur

Flexispot

Flexispot ML2B Manuel utilisateur

Hamlet

Hamlet UNIVERSAL COVER 101 KBT2 Manuel utilisateur

Adam Equipment

Adam Equipment RS-485 Manuel utilisateur

Vivo

Vivo MOUNT-KB05-4DW Manuel utilisateur

Kvaser

Kvaser Memorator Professional Manuel utilisateur

DRC

DRC D-Imaging Manuel utilisateur

Sven

Sven Base 305 сombo Manuel utilisateur

Hama

Hama 108310 Manuel utilisateur

SpeechWare

SpeechWare FlexyMike FMK03 Manuel utilisateur

ekwb EK-Quantum Vector D-RGB Upgrade Kit Manuel utilisateur

Manuels Accessoires informatiques populaires d'autres marques