Packaging
The unit is supplied in packaging to prevent it from
being damaged in transit. The raw materials in this
packaging can be reused or recycled.
When using the equipment, a few safety
precautions must be observed to avoid injuries
and damage.
앬Read the operating instructions carefully and
comply with them at all times. It is important to
consult these instructions in order to acquaint
yourself with the unit, its proper use and the
important safety regulations.
앬Keep this manual in a safe place, so that the
information is available at all times.
앬If you give the equipment to any other person,
make sure that you pass on these operating
instructions as well.
We can accept no liability for damage or
accidents which arise due to non-compliance
with these instructions.
1. Scope of use
The pressure sprayer is designed for spraying
common home and garden products. These include
pesticides, weed killers, and liquid fertilizers that
have been approved for use in the country of
purchase and are thus fully compatible with the
sprayer.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
equipment is used in commercial, trade or industrial
businesses or for equivalent purposes.
2. Safety information:
앬Pesticides may only be sprayed in outdoor areas
that are used for agricultural, forestry, or
horticultural purposes. Never spray pesticides in
or in the direct vicinity of open bodies of water
(including coastal waters).
앬Suitable measures must be taken to keep the
pressure sprayer out of the reach of children.
앬The pressure sprayer is not designed to spray
liquids that exceed the maximum permitted
operating temperature of 40 °C. Acidic, caustic,
and flammable liquids whose flash point is below
55 °C and impregnating agents may also not be
used.
Important! Atomized flammable liquids with a
flash point in excess of 55 °C are also highly
combustible.
앬Do not use your mouth to blow out plugged
nozzles or other small parts.
앬Only use a suitable nozzle wire or cleaning agent
to clean plugged nozzles.
앬Always follow the chemical manufacturerʼs
instructions when mixing and working with spray
solutions.
앬Only fill the tank with as much liquid as required.
앬Do not allow the liquid to escape the tank or
splash back when filling.
앬Never spray persons, animals, or into bodies of
water!
앬Always wear protective clothing when spraying
pesticides and insecticides to avoid direct
contact with the tiny droplets that form.
앬Do not eat, smoke, or drink while working with
pesticides.
앬When filling the tank from a building water supply
system, exercise caution if you submerge the
hose into the spray solution.
앬Only fill the tank with water from a lake or pond if
you are legally authorized to do so and if all
associated contamination can be avoided.
앬Note the direction of the wind and never spray
against it. Avoid accidentally spraying areas you
do not want to treat (overspray).
앬Thoroughly clean your hands and face after
spraying.
앬If you have not used the pressure sprayer for an
extended period of time, check it for possible
damage prior to reusing it.
앬Immediately replace defective parts.
앬Use only original replacement parts.
앬Do not leave the unit (filled or empty) in direct
sunlight.
앬Before placing the unit in winter storage,
thoroughly clean and dry it out so that it is not
damaged by frost.
앬We will not be liable for any damage that results
from improper repairs and/or improper handling
of the unit (e.g. using the unit in ways for which it
was not intended).
앬Opening the unit and performing maintenance
work on it is only permitted when the tank is
depressurized.
앬To relieve the pressure, pull up the funnel-
shaped knob connected to the overpressure
valve.
앬Please observe the safety data sheets for
chemical materials and preparations as per DIN
52 900, “DIN Safety Data Sheet for Chemical
Materials and Preparations” and AID leaflet
2079, “Befüllen von Pflanzenschutzgeräten”
10
GB
