Edelbrock 5761 Manuel utilisateur

EDELBROCK CAT-BACK EXHAUST SYSTEM

For 2000-2002 DODGE DURANGO

4.7L, 5.2L & 5.9L, 2 & 4 wheel drive

Catalog #5761

INSTALLATION INSTRUCTION

Please study these instructions carefully before installing your new Cat-Back Exhaust System. If you

have any questions or problems, contact ourTechnical Hotline at: 1-800-416-8628 from 7 am - 5 pm,

Monday through Friday, Pacific Standard Time or e-mail us at: [email protected].

SUGGESTED TOOLS FOR INSTALLATION:

3/8" ratchet set with SAE and metric sockets

9/16” and 15mm wrenches

Jackstands and jack

Liquid penetrant and rubber lubricant

DISASSEMBLY

1. Raise vehicle and support with proper jackstands for the weight, leaving the suspension hanging.

2. Use caution around hot exhaust systems to avoid burns.

3. Use penetrating oil on all nuts and bolts.

4. Remove the bolts and clamps from the system and lubricate the rubber hangers.

5. Use a long pry bar to pull the rubber hangers off of the pipe hangers.

6. Remove the old system. In some cases, you will find it easier to cut the overaxle pipe to remove

it.

ASSEMBLY

1. Slip the intermediate pipe onto the catalytic converter outlet pipe with the 2-1/2” clamp and just

snug them so you can adjust the pipe easily on the catalytic pipe. Engage hanger onto rubber

factory mounts.

2. Slip the muffler onto the intermediate pipe with a 3” clamp on the front. The offset of the muffler

is the (rear) outlet. Snug the clamp so you can adjust the pipes.

3. Install a 3” U-clamp hanger assembly on the front of the overaxle pipe and engage it into the

stock rubber hangers. Snug the clamps.

4. Install tail pipe hanger, engage into rubber mount. Do not tighten at this time.

Note: You will find there are two different tail pipe hanger assemblies in this system. This was

done because the Durango has two different rear frame configurations. Use whichever hanger

assembly allows you to position the tail pipe under rear bumper properly. With the correct hanger

in place, you can adjust the height of the tail pipe by sliding the hanger forward or back. Tail pipe

gets very hot and can burn plastic bumper if too close.

5. Working from the front of the system, align and tighten each pipe. Check for clearance to body,

frame, and driveline as you tighten the system from front to rear.

6. Using the 3/8 nut supplied in kit, re-install grounding strap to U-clamp of cat-back system.

7. Check for leaks and correct if any is found.

WARNING: Exhaust gas contains carbon monoxide, a deadly invisible gas. Correct any

leaks before driving!

PostScript Picture

(Edelbrock B/W Logo.eps)

KIT CONTENTS

RPM SERIES CAT-BACK EXHAUST

CATALOG #5761

Qty.Part # Description

125-3174 Intermediate Pipe

125-5506 Muffler

123-3151 Overaxle Pipe Assembly

123-4026 Hanger Assembly

123-4027 Hanger Assembly

123-4028 Hanger Assembly

146-5186 3” U-Clamp

146-5185 2-1/2” U-Clamp

Please complete and mail your warranty card. Be sure to write the mode number in the “Part #”

space.

Thank you.

WARNING: Support your vehicle with proper

jackstands or ramps rated for the total vehicle

weight. Place stands so that the rear axle is

allowed to hang free for easy system removal.

WARNING: These cat-back systems are

engineered to fit stock catalytic converters or

equivalent replacements. If your original

system has been modified, Edelbrock will not

warranty fit or performance.

Clamp Hanger Assembly

Overaxle Pipe Assembly

Clamp Hanger Assembly

Intermediate Pipe Assembly

Autres manuels Edelbrock Pièce automobile

Edelbrock

Edelbrock 2161 Manuel utilisateur

Edelbrock

Edelbrock 66492 Manuel utilisateur

Edelbrock

Edelbrock 5247 Manuel utilisateur

Edelbrock

Edelbrock 5756 Manuel utilisateur

Edelbrock

Edelbrock Predator Carburetor Manuel du propriétaire

Edelbrock

Edelbrock 6501 Manuel utilisateur

Edelbrock

Edelbrock 71922 Manuel utilisateur

Edelbrock

Edelbrock Performer Series 8059 Manuel utilisateur

Edelbrock

Edelbrock Performer 60039 Manuel utilisateur

Edelbrock

Edelbrock 3562 Manuel utilisateur

Edelbrock

Edelbrock Qwikdata 91195 Manuel utilisateur

Edelbrock

Edelbrock 65692 Manuel utilisateur

Edelbrock

Edelbrock 63-0081 Manuel utilisateur

Edelbrock

Edelbrock 2994 Manuel utilisateur

Edelbrock

Edelbrock 5202 Manuel utilisateur

Edelbrock

Edelbrock 5486 Manuel utilisateur

Edelbrock

Edelbrock 7890 Manuel utilisateur

Edelbrock

Edelbrock Performer Multipoint 3501 Document technique

Edelbrock

Edelbrock 2475 Manuel utilisateur

Edelbrock

Edelbrock 90 V6 200 Manuel utilisateur

Edelbrock

Edelbrock 5721 Manuel utilisateur

Edelbrock

Edelbrock Performer 1602 Manuel utilisateur

Edelbrock

Edelbrock 70402 Manuel utilisateur

Edelbrock

Edelbrock 68752 Manuel utilisateur

Manuels Pièce automobile populaires d'autres marques

Dakota Digital

Dakota Digital 650277 Manuel utilisateur

bosal

bosal 037031 Manuel utilisateur

Vintage Air

Vintage Air 571063 Manuel utilisateur

GFB

GFB EX38 Manuel utilisateur

bosal

bosal 028091 Manuel utilisateur

Dodge

Dodge 8W-43 Guide de démarrage rapide

ICI

ICI Magnum FBM10DGN Manuel utilisateur

Volant Perfomance

Volant Perfomance 19435 Manuel utilisateur

BENDIX

BENDIX GEN 4 GEN 5 ABS Manuel utilisateur

Vintage Air

Vintage Air 571065 Manuel utilisateur

Rugged Ridge

Rugged Ridge 11503.13 Manuel utilisateur

BENDIX

BENDIX CYCLONE DURADRAIN TRAILER WATER Manuel utilisateur

Porsche

Porsche 968 - ASSEMBLY INSPECTION PROCEDURE AND MAINTENANCE... Mode d’emploi

Sumitomo

Sumitomo FINE CYCLO FC-A 15 G Manuel utilisateur

Toshiba

Toshiba 48-1250 A Manuel utilisateur

aldes

aldes EHT2 Manuel utilisateur

Go Rhino

Go Rhino 24371T Manuel utilisateur

BBK

BBK 18950 Manuel utilisateur