ECO Spot LED B90E Manuel utilisateur

ECO Spot LED B90E/B150E/B300E User Manual

Thank you for choosing an ECO Spot™ Gobo projector.

Please read this manual before installing or operating this fixture,

follow the safety precautions listed below and observe all warnings.

WARNING! - To prevent damage to the LED, always

connect the driver to the projector FIRST before

powering up the driver.

Package Contents

Projector with Projection Lens

External LED Driver

Test Gobo mounted

Thread ring with silicone seal for the projection lens

Safety Information

Electrical Safety

•Disconnect the fixture from AC power before handling it.

•Follow all local building and electrical codes and apply both, overload and

ground-fault protection.

•Do not use the fixture if the power cable or power plug is in any way damaged,

defective or wet, or if they show signs of overheating.

•The fixtures have power plugs for testing and for indoor use but exterior

installations usually require hard-wired connections. Follow all related codes.

ECO Spot

™ LED B90E/B150E/B300E

Exterior User Manual

•Place your fixture at a suitable place with good air flow.

•Keep flammable materials away from the fixture.

•Minimum distance to flammable material = 1 ft (0.3m).

•Provide a minimum clearance of 4 in (10cm) around air vents.

•Do not look directly into the lamp; it can result in eye damage.

•Always unplug the unit from the power mains before any service is done.

•Light fixtures should be installed and maintained only by qualified personnel with

experience in lighting equipment and general electrical experience.

ECO Spot LED B90E/B150E/B300E User Manual

LLC Page 2

Outdoor Use

The projector and external driver are designed for outdoor use. The rear, perforated

cooling part of the projector including the fan is rated for water exposure. To extend the

projector life, an external hood can be placed above the projector but this measure is not

mandatory.

Handling Instructions

Warranty

One Year from Date of Purchase. Keep your receipt for reference and contact your dealer

in case of warranty issues.

Projection Lenses

The projector accommodates interchangeable projection lenses to allow optimizing the

projection size and resulting brightness at varying distances. The more narrow the lens,

the smaller and brighter the image will be at a given distance.

Focusing

Gobo Rotator

If the fixture is equipped with a gobo rotator, it can be turned on/off with the silver push-

button on the front plate underneath the lens. There are no controls for rotating speed or

direction. Even when not used, the gobo rotator comes handy for straightening the gobo

image after a gobo was installed.

•Before the initial start-up, please unpack and carefully check for damage caused

during transportation.

•When suspending the fixture above ground level, verify that the structure

can hold

at least 10 times the weight of all installed devices.

•Verify that all external covers and rigging hardware are securely fastened and use

an approved means of secondary attachment such as a safety cable.

•Power up the projector.

•If the fixture is equipped with a gobo rotator, turn it on and then off again once

the gobo projects in the desired position.

•Loosen the outer ring around the lens that acts as a water seal.

•Focus the projection by twisting the lens in and out until

the image is well focused.

When used for the first time, the lens will often need to be twisted outwards many

rotations to reach the focusing point. When in doubt, keep going.

•Re-tighten the outer ring with the seal to ensure the lens won’t leak water.

ECO Spot LED B90E/B150E/B300E User Manual

Multi-functional Yoke

Gobo Placement

The Projector uses M-Size gobos, (see Specifications for Gobo Dimensions).

The yoke can slide over the fixture body to accommodate a wide range of pointing

directions. It can serve as stand or can be mounted to a wall, ceiling or truss.

•Pointing position UP: With the long-hole pointing towards the back of the

projector, the main pointing position is UP.

•Pointing position DOWN: Remove the yoke screws and flip the projector so the

long-hole points to the front plate.

•If the projector is on, turn it off.

•Even though this is a LED projector, the gobo gets hot, please wait a few minutes

for the gobo to cool down if the projector was on.

•Unscrew the thumbscrews to remove the front cover with the projection lens.

Keep the rubber seals and re-use them with the thumb screws to prevent leakage.

•Push the two pins of the gobo retaining ring together and pull out the retaining

ring. Carefully remove the old gobo and replace it with the new gobo.

•If you have a glass gobo, place the more reflective side towards the light bulb.

•Replace the retaining ring and make sure it evenly pushes the gobo all the way

back.

•Replace the front cover and rubber seals and tighten the thumb screws well.

•Adjust the focus by twisting the projection lens in or out.

•Re-tighten the lens retaining ring towards the front plate so the silicone ring

makes a water tight seal.

ECO Spot LED B90E/B150E/B300E User Manual

LLC Page 4

Power Supply

90-265V, 50/60Hz

B90E: 110W, B150E: 180W, B300E: 360W

Ambient Operating Temperature

-13 to 104°F (-25 to 40°C)

Dimensions / Weight

Fixture Body: 7.5in x 5.5in x 14.5in

(190mm x 140mm x 370mm)

Total Length: 18in (460mm) with 25deg.

lens, 20in (510mm) with 15 deg. lens

Yoke Base: 6.4in x 7.8in (163 x 198mm)

Yoke Height: 7.5in ( 190mm) (from base

to center)

Total Height: 10in ( 254mm) (from base

to top)

Weight: B90E:12lbs (5.4kg), 150E:13lbs

(6kg), B300E: 17lbs (7.7kg)

Gobo Dimensions

Metal or Glass Gobos and Dichroic filters

Standard Gobo Size: M-Size

Outer Diameter (OD): 66mm

Image Diameter (ID): 48mm

Max Thickness:4mm

LED Lamp

Rated Bulb life:40,000h

Color Temperature:6,000k, +/-500k

Rated luminous flux:

B90E: 7,500lm, B150E: 12,000lm,

B300E: 20.000

Effective luminous flux:

B90E: 6,200lm, B150E: 8,900lm,

B300E: 11,500lm

CRI: 75

Lens Options

The projector can be equipped with

standard ECO Spot projection lenses.

A larger focal length (f) makes a smaller

projection angle and therefore a smaller

but brighter image. Currently these

lenses are available:

IP-Ratings

LED Driver: IP65, Fixture: IP55

•Medium-Narrow f=115mm 25º

•Medium f=140mm 20º

•Semi-Narrow f=140mm 15º

Ce manuel convient aux modèles suivants

Autres manuels ECO Spot Projecteur

ECO Spot

ECO Spot LEDB90 Manuel utilisateur

ECO Spot

ECO Spot C20PCE Manuel utilisateur

Manuels Projecteur populaires d'autres marques

iEmmet

iEmmet MP-312 Manuel utilisateur

Epson

Epson VS400 Manuel utilisateur

Sony

Sony VPL-HS10 Marketing Specifications & Features Manuel utilisateur

Sony

Sony VPL-HW65ES Manuel de service

Toshiba

Toshiba TLP-791U Manuel utilisateur

Philips

Philips LC1341 Guide de référence

Panasonic

Panasonic PTL735NTU - LCD PROJECTOR-NETWORK IB Manuel utilisateur

NEC

NEC NP600S EDU Manuel utilisateur

BenQ

BenQ SH753P Manuel utilisateur

Eiki

Eiki EK-623U series Manuel utilisateur

Epson

Epson PowerLite Pro Cinema 6020UB Manuel utilisateur

Epson

Epson PowerLite Home Cinema 705HD Manuel utilisateur

Christie

Christie LHD700 Manuel utilisateur

Navitar

Navitar FX Manuel utilisateur

InFocus

InFocus LitePro 560 Manuel utilisateur

Sony

Sony SRX-R815P Manuel utilisateur

Vivitar

Vivitar DP1500 X Manuel utilisateur

Acer

Acer C20 Series Manuel utilisateur