3
1. Mount the surface mounng plate to the wall surface with screws and wall anchors
(not supplied).
2. Mount the switch to the plate with the two short #6-32 screws provided.
3. Install a decorator style faceplate (Leviton 80401 or equivalent, not supplied) over
the switch.
4. Test operaon of the switch. The paddle should return to a neutral posion aer
release. An audible click is expected.
These models come supplied with clear double sided tape, you can also remove the front
cover of the switch and use the screw guides on the back plate of the switch to mount
with screws and wall anchors (not supplied).
These models have round removable covers on the back (twist o, using small holes
for leverage). There are keyholes behind the covers. Use with pre-installed screws (not
supplied) - measure 6 cm center to center when placing screws.
The keycard switchis acvated with an 85.60 x 53.98 mm (3.37 x 2.125”) card as specied
by ISO/IEC7810 - ID-1 (thickness of 0.76 mm (0.03”).
For wall mounng, the keycard switch faceplate must be removed before mounng.
For proper operaon, the provided rear surface mounng plate must be used when
mounng.
1. Remove the faceplate screws and faceplate assembly (includes front cover and
insert with key depression tag).
2. There are four mounng holes in the rear mounng plate to aach the switch to a
wall surface with screws and wall anchors (not supplied). Note: the keycard switch
can be oponally wall box mounted with the barrier paron accessory (sold
separately).
3. Reinstall the faceplate assembly. DO NOT OVER TIGHTEN THE SCREWS.
4. Test operaon of the switch by inserng a card and extracng. There should be an
audible click with each inseron and extracon.
The linking process requires the controller or receiver to be mounted, powered and
within range of the switch to be linked. Each receiver can support up to 20-30 switches,
depending on receiver model.
1. Acvate LEARN or LINK mode at the receiver, if necessary refer to the
manufacturers documentaon.
2. Wall and handheld switches: triple click quickly. For keycard switches: insert a
room card into the switch three (3) mes quickly.
3. Deacvate LEARN mode at the receiver. Test operaon of the switch by switching
and .
