E-line ELI-SIP2-NVR32 Manuel utilisateur
- 1 -
About this Document
Purpose
This document describes the features, hardware installation, network access, network
configuration, routine maintenance, fault analysis, and troubleshooting of the Network
Video Recorder (NVR).
Intended Audience
This document is intended for:
Technical support engineers
Maintenance engineers
Symbol Conventions
The symbols that may be found in this document are defined as follows.
Symbol
Description
Alerts you to a high risk hazard that could, if not avoided,
result in serious injury or death.
Alerts you to a medium or low risk hazard that could, if
not avoided, result in moderate or minor injury.
Alerts you to a potentially hazardous situation that could,
if not avoided, result in equipment damage, data loss,
performance deterioration, or unanticipated results.
Provides a tip that may help you solve a problem or save
time.
Provides additional information to emphasize or
supplement important points in the main text.
Important Statement
Users are required to enable and maintain the lawful interception (LI) interfaces of
video surveillance products in strict compliance with relevant laws and regulations.
Installation of surveillance devices in an office area by an enterprise or individual to
monitor employee behavior and working efficiency outside the permitted scope of the
local law and use of video surveillance devices for eavesdropping of illegal purposes
constitute behaviors of unlawful interception
.
- 2 -
Contents
1 Specification .........................................................................................................- 3 -
2 NVR networking solutions................................................................................- 5 -
3 Hard drive .............................................................................................................- 7 -
3.1 Hard disk recommended ............................................................................................. - 7 -
3.2 Days of recorded ........................................................................................................ - 7 -
3.3 Installation .................................................................................................................. - 8 -
4 Basic operation ...................................................................................................- 10 -
4.1 Front panel description ............................................................................................. - 10 -
4.2 Rear panel description .............................................................................................. - 11 -
4.3 Startup ...................................................................................................................... - 12 -
4.4 Shutdown ................................................................................................................. - 13 -
4.5 Login ........................................................................................................................ - 13 -
5 Quick setup.........................................................................................................- 15 -
6 Live Video ...........................................................................................................- 21 -
7 Video Playback ..................................................................................................- 25 -
7.1 Video Playback ......................................................................................................... - 25 -
7.2 Video Backup ........................................................................................................... - 26 -
8 F.A.Q ....................................................................................................................- 30 -
- 3 -
1 Specification
System
CPU
SOC
Operation
system
Embedded Linux 2.6
features
Embedded CMS system, fully functional friendly interface, easy to use;
Original "quick configuration" feature that enables NVR configuration and
management operations easy to get started.
Original "camera private network enables Plug-and-play camera access auto
detection and schedule setup for fast rapid use.
Real-time fault alarm mechanism to timely reporting of hard disks, networks,
fault information, such as camera disconnection; Embedded WebServer using
Flash technology to support common browsers real-time monitoring and
playback
Video
Ability to
decode
Support H.264 High profile Level5.0 decode
Support resolution up to 5 megapixel
Real-time
video
Single screen: 5 megapixel /3megapixel /1080P/720p/D1 resolution
Quad display of 1080P/720p/D1 resolution
Split screen 1/4/8/16.for D1 resolution
Audio format
G711_A/G711_U
record
Record info
Support 32ch recording, Maximum recording bandwidth is 144Mbps
Support resolution: 5 mega,3 mega, 1080p, 720p/D1 resolution.
HDD
Support four 1.5/3.0Gbps SATA hard disks，Maximum capability of single
hard disks is 4TB.
recording
days
4 hard disks, maximum 4*4TB hard disk support.
Playback
Support 4ch 1080P playback at the same time.
Backup
Support U drive, mobile HDD, network backup disk.
- 4 -
display
interface
One VGA output interface, one HDMI output interface, support homology
display
resolution
1024x768、1280x720、1920x1080
Network
interface
Two RJ45 10/100/1000Mbps network port
Network
protocol
RTP/RTCP，TCP/UDP，HTTP，DHCP，DNS，NTP
others
Environment
temperature
10℃—50℃
Environment
humidity
5%-90%
power supply
AC110/220V，47-63HZ，Maximum consumed power is 200W.
consumption
Low-power design, Maximum motherboard power consumption 15w (without
USB interface), with 4*4T hard disk increases 40W power consumption.
Size
chassis：440mm x 435mm x 89.8mm（L*W* H）
weight
Net weight 6.805kg，with packaging 8.975kg
USB interface
2*USB2.0 host interface；Respectively as backup and USB mouse.
- 5 -
2 NVR networking solutions
This the NVR has two Ethernet ports LAN1 and LAN2. Supports the private network
of the cameras, and 2nd one for WAN local remote connections. LAN2 is used for
network devices for automatic detection within the NVR software.
Option One：Private Network Setup
Camcorder network is a network exists only network cameras and NVR, there is no
other network equipment, and this network is dedicated to the NVR and network
cameras, audio and video transmission. Dedicated camera network must be connected
with the NVR LAN2, and ensure that the LAN2 camera network functions are enabled
(factory default enabled detailed configuration, see "Network Video Recorder User
Manual quick configuration through LAN1 access NVR.
10M/100M/1000Mbps RJ45 Internet port
For connecting the Internet or local network, And NVR need to search the camera by
manually.
The camera dedicated network topology shown in Figure 2-1
Figure 2-1 camera dedicated network
- 6 -
Option II：Open network.
The open network refers to the network in addition to the network cameras and NVR,
there can be other network devices, network topology can be free to organize, just need
to ensure communication between the NVR and network camera is smooth. In the use
of the network, LAN2 needs to turn off the camera dedicated network.
Open network, the need to manually search for and add network cameras, see detailed
operation quickly configure.
Open network topology shown in Figure 2-2.
Figure 2-2 open network topology
- 7 -
3 Hard drive
Formatting will clear all clear video data on disks, please pay attention to this
function
Before removing a hard disk from the NVR during operation, unload the disk,
otherwise. The disk may be damaged.
Please supply stable power supply, otherwise the disk may be damaged or loss of
data.
Maximum capacity of single hard drive is 4TB.
Suggest to use more than two hard drive to achieve the performance balance,
3.1 Hard disk recommended
Given the current market of different brands, the uneven quality of the different models
of hard, recommended to use Seagate or Western Digital brands which are designed for
security/server applications offering 24x7 reliable operations.
Recommended model: Western Digital’s WD AV-GP and Seagate’s SV-35 SERIES
3.2 Days of recorded
Calculate recording days:
Firstly： Use the formula 1 to calculate the recording capacity q that one channel
record need each hour
q= d ÷8×3600÷1024 (formula 1)
Secondly: calculate the recording days
w– Single capacity of single hard drive, Unit ( MByte)
n – Hard drive count
h – Recording time within a day
- 8 -
c – Recording approaches of NVR
For example: calculate detail recording day
Calculate recording days
Hard drive
capacity
Video stream
cameras
Days recorded
4×4TB
D1 1.5Mbps
32
30 days
4×4TB
720p 3Mbps
32
15 days
4×4TB
1080p 4.5Mbps
32
10 days
3.3 Installation
The hard specific installation steps are as follows:
Step 1 Take out the screws of the cover and the cover
- 9 -
Step 2 Hard drive inset to the PCB SATA interface,
Step 3 Fixed hard drive with 4 screws,
Repeat the step2, step3, untill all the hard drive are installed, and then cover the upper
cover,fix the screw.s
End----
- 10 -
4 Basic operation
4.1 Front panel description
Figure 4-1 Front panel
Table 4-1 Front panel
No
Name
Description
1
KB/MOUSE
For connecting external mouse, keyboard.
2
BACKUP
For connecting U drive and mobile HDD.
3
HDD 1～4
1～4 hard drive work indicating lamp (blue)
Long light when it’s alive, the blue light flashes when it
reading and writing data.
4
SYS
NVR running indicator lamp (red), long light when it is
behaving normally.
5
PWR
NVR power indicate lamp (red), long light after startup.
6
POWER
Power on/off button
Hard drive working indicate light correspond to the internal hard drive, which is shown
in the following table.
HDD1
HDD2
HDD3
HDD4
Table des matières
Autres manuels E-line Matériel réseau
Manuels Matériel réseau populaires d'autres marques
Matrix Switch Corporation
Matrix Switch Corporation MSC-HD161DEL Manuel utilisateur
B&B Electronics
B&B Electronics ZXT9-IO-222R2 Manuel utilisateur
Yudor
Yudor YDS-16 Manuel utilisateur
D-Link
D-Link ShareCenter DNS-320L Manuel utilisateur
Samsung
Samsung ES1642dc Instructions d'utilisation
Honeywell Home
Honeywell Home LTEM-PV Instructions de montage
