ADJUSTMENT AND CAMERA PAIRING SETTINGS
K1: Brightness adjustment button. Press the K1 button to change the brightness of
the screen, as shown on the image below, press K1 to increase brightness, once
brightness bar reaches max keep pressing K1 to reset brightness to 1.
K2: Screen image flipping button. Pressing K2 will cycle the image left, right , up and
down to match the camera orientation (depends on how you mount the camera).
K3: Press once to enter camera pairing mode, the screen will display as shown below.
LIMITED WARRANTY
DrivenTM warrants any products purchased in the U.S.A. from an
authorized DrivenTM dealer.
All Products are warranted to be free from defects in material and
workmanship under normal use and service for a period of one (1) year.
This warranty applies to the original purchase only.
DrivenTM will either repair or replace (at its own discretion) any unit that
has been found to be defective and under warranty provided the defect
occurs within the one (1) year warranty period.
This limited warranty does not exted to units that have been subjected to
misuse, abuse, neglect, or accident. In Driven’sTM judgment, products that
show evidence of having been altered, modied, or serviced without
Driven’sTM authorization, will be ineligible under this warranty.
To Obtain warranty service please contact your retailer or visit our
website at www.drivenelectronics.com
After camera and monitor has been
successfully paired, hold the K3 button for
3 seconds to toggle reversing lines on the
screen. This is shown in the picture:
TM
