2. Insert the camera cable into the video input port (11).
3. Press and hold the power button (9) for approximately
three seconds; the power (9) and connection (8)
indicators illuminate when the device is switched on.
The power indicator identies that the device is
active; the connection indicator identies that the
device is broadcasting a Wi-Fi signal.
Important: If the camera cable is not connected to the
Wi-Fi unit, the unit will switch o automatically after
two minutes.
4. Access the Wi-Fi settings of your smart device and
connect to the network named “Wi Check-xxxx”
where “xxxx” is a variable alphanumeric code.
5. Launch the Wi Check app on your device and grant
the required device permissions.
The connection indicator will ash when the
endoscope is connected to your smart device and the
camera feed is displayed on the screen.
6. Use the buttons in the app to change the resolution of
the video feed, ip or rotate the feed, and to capture
and browse photos and videos.
7. To switch o the camera, press and hold the power
button for three seconds.
Important: This app is developed and managed by a third
party and may be changed without warning. Draper Tools is
not responsible for changes made to the app. All details are
correct the time of publication.
5.3 Notes on Use
• The object must be within 40–100mm of the camera
lens to appear in focus; if the subject is blurry, the
camera may be too close or too far from the object.
• This product is suitable for examining small objects
and recesses only and cannot be used for surveillance
or medical purposes.
• To adjust the brightness of the LEDs, adjust the
brightness control wheel (2).
• If the Wi-Fi connection to the camera is interrupted,
your smart device may automatically connect to other
Wi-Fi networks.
− If this occurs, the device must be manually
reconnected to the product network.
− Draper Tools recommends “forgetting” all other
nearby networks on your smart device before using
this product to ensure that the device reconnects
to the product automatically if signal is interrupted.
• Device connectivity may be adversely aected by
signicant trac or interference from other Wi-Fi
networks.
• The product app is compatible with most iOS and
Android devices but may not work with every device.
• This product MUST be used in accordance with local
regulations.
6. Using the Accessories
6.1 The Mirror Attachment
For operations where a front-facing camera in not
appropriate, the mirror attachment (E) can be installed
onto the end of the camera head to change the
viewing angle.
To install the mirror attachment, carefully screw it
onto the threaded end of the camera.
1
Fig.
Important: DO NOT force the mirror onto the camera and
take care not to damage the threads.
Important: Ensure that the protective lm has been
removed from the mirror attachment before use.
6.2 The Hook and Magnet Extensions
The hook (B) and magnet (C) extensions can be attached
to the camera head to move or retrieve damaged or
obstructive objects in the path of the camera.
2
Fig.
(E)
(B)
(C)
