Dquad FIXATION Manuel utilisateur
FIXATION 5 INCH ASSEMBLY INSTRUCTIONS
For the best flight performance and to prevent premature carbon fiber failure, it is recommended to follow the
assembly instructions and to apply medium threadlocker to and adequately tighten all frame bolts.
INSERT THE ARMS INTO THE BOTTOM PLATE ARM CHANNELS
Set the arms in the milled arm channels on the bottom plate. If you are finding it difficult to fully seat an
arm, due to carbon fiber manufacturing tolerances it may be necessary to lightly file the edge of the arm
where it meets the bottom plate and main plate arm channels.
Now take the main plate and test that the arms fit in and seat fully into the main plate
arm channels. Lightly file the edge of the arms if necessary.
INCLUDED PARTS:
(1) Fixation sticker
(1) Bottom plate - 3mm
(1) Main plate - 20x20 and 30x30 - four press
nuts inserted - 3mm
(2) Camera plates - 2mm
(4) 5.1 inch arm - 5mm
(1) Race top plate - 2.5mm
(1) HDZero top plate - 2mm
(4) M3x10mm countersunk titanium bolts
(4) M3x14mm countersunk titanium bolts
(4) M3x6mm button head titainium bolts
(4) M3x25mm button head titanium FC stack bolts
(12) M3x8mm button head titanium motor bolts
(4) M3 nylon FC stack nuts
(1) Large Dquad lipo strap
(4) M3x25x5mm aluminum standoffs - black
(1) Lite grip lipo pad
STEP_01
MOUNT THE ARMS TO THE MAIN AND BOTTOM PLATE
Sandwich the arms between the main and bottom plate. Add a drop of threadlocker and insert the four
M3x10mm countersunk bolts through the inner holes on the bottom plate, through the arms and screw
them into the four press nuts that are mounted into the main plate.
Make sure the arms are fully seated into the main and bottom plate arm channels before going on
to the next step.
STEP_02
SANDWICH ARMS BETWEEN PLATES
COMPLETED ARM INSTALLATION
FULLY SEATED ARMS
INSERT M3X10MM COUNTERSUNK BOLTS
PERFECTION MINI 3 INCH ASSEMBLY INSTRUCTIONS
INSTALL STANDOFFS AND CAMERA PLATES
Use four M3x14mm countersunk bolts. Apply a drop of threadlocker to each and bolt the
four aluminum standoffs to the main plate.
Install the camera plates in the camera slots located on the main plate.
STEP_03
INSTALL TOP PLATE
Use four M3x6mm button head bolts. Apply a drop of threadlocker to each and bolt the
top plate to the four standoffs.
STEP_04
PERFECTION MINI 3 INCH ASSEMBLY INSTRUCTIONS
INSTALL ACCESSORIES
Install four M3x25mm FC bolts, Lite Grip lipo pad and any desired TPU accessories
which are available for purchase or free downloadable 3d files on dquad.net.
You’re finished - enjoy!
STEP_05
Table des matières
Autres manuels Dquad Accessoires pour drones et quadricoptères
