DOM Tronic Pro Manuel utilisateur
Tronic Pro
Assembly
Drilling template
ASSEMBLY
Right hand door Left hand door
TRONIC PRO : Drilling template
ø8,1
ø4,5
2,5
For housing
the screw head
Right hand door Left hand door
TRONIC PRO : Drilling template
ø8,1
ø4,5
2,5
For housing
the screw head
Accessories
ASSEMBLY
ø5x29.5
C
D
E F
ø3.5x9.5 Strike plate
M3x18
Right door assembly
ASSEMBLY
ø3.5
ø22
1
A
2
18 + x mm
18 mm
panel thickness
AA
Section A-A
3
5 6
4
!Warning: Connect blue part
to the side of the legde
Right door
Right door
Right door assembly
ASSEMBLY
B
12
ø3.5
ø22
Le door assembly
ASSEMBLY
AA
Section A-A
18 mm
panel thickness
3
5 6
4
!Warning: Connect blue part
to the side of the legde
Le door
Le door
Le door assembly
ASSEMBLY
1
2
IMPORTANT
The battery pack must remain
connected during the release
of the batteries. Otherwise,
the internal clock will lose the
time configuration.
Verify that the cable is properly
connected (straight and untill
the bottom).
Relase the batteries thanks to
T20 Torx Security screw located
on the opposite of the battery case
Verify that the batteries are in
the right polarity (as indicated
in the battery box).
Don’t push any key during the wire
assembly process.
Important notes
ASSEMBLY
T20 Torx security
Important notes
ASSEMBLY
3
4
Verify that the screws are not fastened
too tight (<20kgf/cm2).
Verify that the latch works smoothly in
and out, without any frinction with the
door frame.
Autres manuels pour Tronic Pro
1
Table des matières
Autres manuels DOM Serrure de porte
DOM
DOM ELS signalling Manuel utilisateur
DOM
DOM ix Gamma Manuel utilisateur
DOM
DOM ENiQ Pro Manuel du propriétaire
DOM
DOM GUARD S Manuel utilisateur
DOM
DOM ENIQ Guardian Manuel utilisateur
DOM
DOM Unitecnic 1250 Manuel utilisateur
DOM
DOM Unitecnic 1150 Manuel utilisateur
DOM
DOM ENiQ EasyFlex Manuel d'installation et d'exploitation
