Dogtra E-Fence 3500 Manuel utilisateur
1
E-FENCE 3500
UNDERGROUND E-FENCE SYSTEM
Owner's Manual
Please read this manual thoroughly
before operating the Dogtra E-FENCE 3500.
2
CONTENTS
OVERVIEW .............................................................................................................
MAIN FEATURES OF THE E-FENCE 3500 .....................................................
SAFETY FEATURES ..............................................................................................
PACKAGE CONTENTS .........................................................................................
DESCRIPTION OF TRANSMITTER PARTS ......................................................
DESCRIPTION OF RECEIVER PARTS ...............................................................
RECEIVER FITTING ...............................................................................................
CHARGING THE RECEIVER ...............................................................................
CHANGING THE CONTACT POINT LENGTH ..................................................
TESTING THE SYSTEM PRIOR TO INSTALLATION .......................................
INSTALLATION ......................................................................................................
ADDITIONAL PARTS ............................................................................................
WIRE SPLICING .....................................................................................................
OPTIONAL ACCESSORIES .................................................................................
TROUBLESHOOTING GUIDE .............................................................................
GENERAL MAINTENANCE TIPS ........................................................................
WARRANTY AND REPAIR INFORMATION ....................................................
3
4
4
5
6
10
12
14
15
16
17
20
23
25
27
29
30
3
OVERVIEW
The Dogtra E-FENCE 3500 system gives you the ability to allow your dog the
freedom he wants within your specified boundaries. Dogtra’s containment system
contains your dog without the use of conventional fencing that can be chewed
through, jumped over or dug under.
The width of the signal field can easily be adjusted at the wall-mount transmitter.
The strength of the electrical stimulation can be adjusted on each separate
receiver with the Stimulation Selection Dial. In the "Pager + Stimulation" mode,
your dog will receive a Pager vibration, followed by stimulation when he
approaches the boundary area. In the "Pager Only" mode, your dog will receive a
Pager vibration only.
Accessories for the system such as additional wire, flags, lightning/surge
protector, and the European 220-volt battery charger are available by calling
Dogtra Company at (888) 811-9111.
4
· Wide range of stimulation for all breeds and temperaments
· Fully waterproof receiver
· 8 intensity levels on the receiver to control individual dog stimulation needs
· HPP (High Performance Pager) vibration warning before stimulation
· HPP (High Performance Pager) vibration only mode
· Wire breakage light with audible warning tone
· Long range signal with 40 acres maximum area coverage
· Advanced filtering system to prevent interference from outside sources
· Expandable to multiple dogs
· 2-hour rapid charge lithium polymer batteries
MAIN FEATURES OF THE E-FENCE 3500
· Dogtra’s E-FENCE 3500 system use state-of-the-art microcomputer
technology. The receiver has an automatic control that limits the stimulation to
eight seconds.
· Dogtra’s filtering system prevents accidental activation from outside sources
other than your transmitter.
SAFETY FEATURES
5
PACKAGE CONTENTS
Wall-Mount
Transmitter
Receiver 20ga Underground
Fence Wire (500 feet)
Boundary Training
Flags (50 each bundle)
Wire Splices
(4 ea.)
Transmitter
Power Adaptor
(24-volt 500mA)
Receiver
Charger (5-volt 1A)
Test Lamp
Enhanced
Contact Points
Male (2 ea.)
Plastic Contact
Points (2 ea.)
Contact Point
Extension Washer &
Adjustment Tool
Ground Wire
(green)
Plastic Anchors
(2 ea.)
Transmitter
Mounting
Screws (2 ea.)
Owner's
Manual
Training
Book
6
DESCRIPTION OF TRANSMITTER PARTS
On/Off
Indicator Light
Boundary Wire
Continuity Light
Field Width
Adjustment Knob
On/Off & Function
Selection Switch
Power Jack
Connector for
Ground Wire
Boundary Wire Connector Tabs
E-FENCE 3500
Transmitter
7
On/Off & Function Selection Switch
The On/Off & Function Selection Switch
has three functions. When the toggle
switch is in the up position, the unit will
give the dog a Pager vibration followed
by stimulation. When the toggle switch
is in the down position, only a Pager
vibration occurs (no stimulation). The
power is off when the toggle switch is
set to the middle position.
Field Width Adjustment Knob
This knob controls the width of the
signal field (the approximate distance
from the boundary wire to the location
where the receiver first activates).
Turning the knob clockwise increases
the field width, giving your dog a wider
area before the activation begins.
Turning it counter-clockwise decreases
the signal field, thus giving the dog a
shorter area prior to activation.
On/Off Indicator Light
When the On/Off & Function Selection
Switch is either in the up or down
position the on/off indicator light will
be on, indicating that the power is
on. When the switch is in the middle
position the light goes off, indicating
that the power is off. The indicator light
stays on even if a fuse is blown.
8
Boundary Wire Continuity Light
When the wires are connected
properly, the boundary wire continuity
light will be on. In the event that
the E-FENCE 3500 wire becomes
damaged or disconnected, the light will
automatically turn off and the warning
beep will sound.
Wire Connector Tabs
The easy-to-use push-release wire
connectors let you instantly connect
or disconnect the boundary wire leads.
Wires should have the plastic coating
stripped approximately a half-inch
before being inserted into the red
connectors on the bottom of the wall
mount transmitter. The system comes
with a ground wire to ground the unit.
Strip about a half-inch on each end of
the ground wire and insert one end
into the black connector on the bottom
of the wall transmitter. The other end
Option: A lightning/surge protector can be purchased if there are no grounding
options near the wall transmitter.
should be buried into the ground or wrapped around a water pipe and secured
with electrical tape.
9
Power Jack
Plug the 120-volt adaptor into a 120-volt
wall outlet and insert the adaptor plug
into the power jack of the transmitter.
Wall-Mount Transmitter
Use the (2) included screws to mount the transmitter to a wall securely near an
outlet. The unit will withstand freezing temperatures, but it is not waterproof.
Therefore, we recommend mounting the transmitter in a safe, dry sheltered
area such as a shed, garage or carport. Plastic anchors have been provided to
secure mounting onto drywall. Use a 1/4“ drill bit to make holes into the drywall.
Insert the anchors into the holes so that the open end faces out and mount the
transmitter by inserting the screws into the open end of the anchors. To power
the wall transmitter, plug the power adaptor into a standard 120-volt outlet and
connect it to the power jack of the transmitter.
10
DESCRIPTION OF RECEIVER PARTS
Stimulation
Selection Dial
Contact Points
Collar Strap
Battery Charging
Receptacle &
Rubber Plug
LED Indicator
Light
E-FENCE 3500
Receiver
Autres manuels pour E-Fence 3500
4
Table des matières
