Distech Controls TS-RMP Series Manuel utilisateur

Hardware Installation Guide

TS-RMP Sensor Series

Stainless Steel Wall Plate Temperature Sensors

Figure 1: TS-RMP Series Stainless Steel Wall Plate Temperature Sensors

Product Description

This document describes the hardware installation procedures for the

TS-RMP Series Stainless Steel Wall Plate Temperature Sensors,

including one model with tamper proof screws.

The TS-RMP Series is a single gang, blank stainless steel wall plate

that incorporates a precision temperature sensor used to monitor room

temperatures where additional security is required. Additional options

are available that include manual override.

The TS-RMP Series can be flush mounted directly to a single gang

electrical box or directly to a wall. Insulating foam is adhered to the

back of the wall plate to provide a thermal barrier from internal wall

temperatures.

A pigtail is used for connection to the Building Automation System.

The TS-RMP Series can accommodate a wide variety of sensing

elements such as NTC thermistors, RTD elements, Nickel RTD

elements and IC sensors. A 10 kΩ, type 2, NTC thermistor is standard.

General Installation Requirements

For proper installation and subsequent operation of each device, pay

special attention to the following recommendations:

- Upon unpacking the product, inspect the contents of the carton for

shipping damages. Do not install damaged device.

- Avoid areas where corroding, deteriorating or explosive vapors,

fumes or gases may be present.

- Ensure that all equipment is installed according to local, regional,

and national regulations.

Personal injury or loss of life may occur if you do not follow a

procedure as specified.

Equipment damage or loss of data may occur if you do not

follow a procedure as specified.

Take reasonable precautions to prevent electrostatic

discharges to the controller when installing, servicing or

operating the controller. Discharge accumulated static

electricity by touching one’s hand to a well-grounded object

before working with the controller.

Wiring

All two-wire sensors are polarity insensitive.

Installation

Surface sensors can be mounted directly on a wall or to a wall box. For

the most accurate results, units should be mounted on an inside wall to

a wall box, away from any supply air exhausts and other sources of

heat or cold.

While all efforts have been made to verify the accuracy of information in this manual, Distech Controls is not responsible for damages or claims arising from the use of this

manual. Persons using this manual are assumed to be trained HVAC specialist / installers and are responsible for using the correct wiring procedures and maintaining safe

working conditions with fail-safe environments. Distech Controls reserves the right to change, delete or add to the information in this manual at any time without notice.

Distech Controls, the Distech Controls logo, and Innovative Solutions for Greener Buildings are trademarks of Distech Controls Inc. All other trademarks are property of their

respective owners.

2/2

TS-RMP Sensor Series_IG_10_EN

Figure 2.

Dimensions