Directed XPRESSSTART ONE Manuel utilisateur

DIGITAL RemoTe sTART sysTem

www.xpResskIT.com mADeIN THeUsA

XPRESSSTART Mercedes Solution

Operating Instructions

Introduction

Thank you for purchasing a XPRESSSTART system for your vehicle. In order to enjoy

the beneﬁts of this system we recommend that you review the following manual.

Please visit www.xpresskit.com for additional support or contact your authorized

dealer.

Valet Mode:

When servicing your vehicle the system should be placed in valet mode. Valet mode

prevents the system from remote starting and allows proper servicing.

Valet mode is controlled via the valet switch typically located at the underside of

the driver dashboard. The valet switch is a 1” round toggle switch with a white dot

marking the “ON’ position on one side and no white dot marking the “VALET” po-

sition on the other side. To engage valet mode, depress the blank side of the switch.

To turn off valet mode, depress the side of the switch with the white dot.

Note: When the system has been placed in valet mode, it is necessary to re-initialize

the starter system before the vehicle can be remote started again. To re-initialize the

system, ﬁrst turn off valet mode and then simply start the vehicle with either the key

or using the KeylessGo Push Start Button and allow the vehicle to run for one (1)

minute. The vehicle can now be remote started.

Operation:

Your XPRESSSTART system can be operated in a number of ways. This includes

using the factory remote control key fob, an optional 1-way or 2-way long range

remote control, or the SmartStart smartphone application. For instructions on how

to use the long range remote or SmartStart controllers, refer to the operating /user’s

manual for those systems.

To start the vehicle using the factory key fob, press the panic button once for ½ sec-

ond and release. The vehicle parking lights will ﬂash once to conﬁrm and then the

engine will start within 5 seconds. Once the engine has started the parking lights

will ﬂash once every 5 seconds. The starter system will continue to run the engine

for 15 minutes. After 15 minutes the vehicle will shut down. The vehicle can be

remote started up to 5 times between normal key or push button start operation.

To shut down the vehicle engine, press the panic button again.

To perform driver takeover, insert the key into the ignition and turn to the ‘RUN’ po-

sition. The parking lights will ﬂash three times to indicate that the XPRESSSTART has

shut down but the engine will remain running. For vehicles equipped with Keyless-

Go (push-to-start) function, press the ‘START’ button once. The parking lights will

ﬂash three times to indicate that the XPRESSSTART has shut down but the engine

will remain running.

The vehicle security system remains intact while the engine is remote started. The

KeylessGo and key fob locking and unlocking will still function and the gear shift

will remain locked until either a valid key is inserted into the ignition or the ‘START’

button is pressed while a valid key is present in the vehicle. If the foot brake is

depressed or the hood is opened while remote started, the engine will immediately

shut down.

Troubleshooting:

When the remote start function terminates, the parking lights will ﬂash a speciﬁc

number of times to indicate the reason for shutdown:

3 ﬂashes: Normal Shutdown

5 ﬂashes: Exceeded maximum number of remote starts

6 ﬂashes: Foot brake was depressed

7 ﬂashes: Hood opened

8 ﬂashes: Engine RPM too high

9 ﬂashes: Engine failed to start

10 ﬂashes: Communication Error

If you encounter any problems, the vehicle and remote starter system can always be

reset using the following procedure:

1. Turn off ignition

2. Close doors and lock with the factory key fob

3. Wait 5 minutes

4. Unlock doors with factory key fob

5. Insert key into ignition and start vehicle

6. Wait 1 minute

7. Turn off ignition

QRGMBRS 2012-10

Autres manuels pour XPRESSSTART ONE

Table des matières

Autres manuels Directed Démarreur à distance

Directed

Directed Clifford 5606X Manuel utilisateur

Directed

Directed Xpresskit DBALL2 Manuel utilisateur

Directed

Directed AS-RFK2300 Manuel utilisateur

Directed

Directed Python 4218P Manuel utilisateur

Directed

Directed Viper 4105V Manuel utilisateur

Directed

Directed XPRESSSTART ONE Guide d'installation

Directed

Directed SmartStart DSM200 Series Manuel utilisateur

Directed

Directed DS4+ Manuel utilisateur

Directed

Directed AS-1774 Manuel utilisateur

Directed

Directed 3000 series Manuel utilisateur

Directed

Directed AS-3472TW Manuel utilisateur

Directed

Directed SmartStart 5000 Series Manuel utilisateur

Directed

Directed AstroStart RS-625 Manuel utilisateur

Directed

Directed DS4+ Manuel utilisateur

Directed

Directed Xpresskit DBALL2 Manuel utilisateur

Directed

Directed 5906 Manuel utilisateur

Directed

Directed PS-3180E Manuel utilisateur

Directed

Directed PS-3655EFM Manuel utilisateur

Directed

Directed 2102T Manuel utilisateur

Directed

Directed Xpresskit DBALL2 Manuel utilisateur

Directed

Directed Smart Start ASRF-1510 Manuel utilisateur

Directed

Directed XpressSTART Mercedes Solution Manuel utilisateur

Directed

Directed XpressKit DBALL Manuel utilisateur

Directed

Directed XpressKit Manuel utilisateur

Manuels Démarreur à distance populaires d'autres marques

AstroStart

AstroStart 803U Manuel utilisateur

Durite

Durite 0-649-20 Manuel

EINHELL

EINHELL BT-PS 1000 Manuel

Linear

Linear ACCESS AK-21 Caractéristiques techniques

Soundstream

Soundstream TARANTULA RS.2 Manuel utilisateur

Jaycar Electronics

Jaycar Electronics MB3752 Manuel utilisateur

Ultra Start

Ultra Start 72 Series Manuel utilisateur

ADS

ADS FLASHLOGIC FLRSVW1 Manuel utilisateur

Selecta

Selecta JS012 Manuel utilisateur

Black Widow Security

Black Widow Security BW RAS 400 Manuel utilisateur

Vector

Vector Power City DK080706 Supplément

Code Alarm

Code Alarm CA-535 Manuel utilisateur

Ozito

Ozito OJS-800 Manuel utilisateur

Profi-Partner

Profi-Partner 46387 Manuel utilisateur

EZ STARTER

EZ STARTER EZ-45 Manuel utilisateur

Viper

Viper 4204 Manuel utilisateur

Essex Electronics

Essex Electronics KE-1701 Manuel utilisateur

EINHELL

EINHELL EGS 3600 Manuel