Dimplex Studio G DXSTG25 Manuel utilisateur



ContactDetails



Pleasenotethatsomeofthecontactdetailson

thisPDFdocumentmaynotbecurrent.



Pleaseusethefollowingdetailsifyouneedto

contactus:



Telephone:08448793588

Email:[email protected]



Thecustomersupportsectionofourwebsitealsofeaturesawide

rangeofinformationwhichmaybeofusetoyouandisavailable

24hoursaday.Itincludes:



•Operatingandinstallationinstructions

•Easy‘Howtouse’guidesforstorageheaters

•Serviceandrepairs

•Wheretobuyourproducts

•Literaturedownloads

•Heatingrequirementcalculator



Visit‐www.dimplex.co.uk/support

A division of GDC Group Ltd

Millbrook House Grange Drive Hedge End Southampton SO30 2DF

www.dimplex.co.uk

istered No: 1313016 En

land

VAT GB 287 1315 50004

EEE Producer Registration Number –

WEE/GE0057TS

Paper from sustainable sources

Installation and Operating instructions

Model: Studio G DXSTG25 Ceramic Tower Heater 08/51280/0 Issue 0

IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED

FOR FUTURE REFERENCE

1. IMPORTANT SAFETY WARNINGS

•The appliance must only be used as described in the instructions for use! Use for any other purpose

is forbidden! Any damage resulting from improper use and non-observance of the safety

information will invalidate any liability and warranty!

•All liability is disclaimed for any frost damage caused by a heating capacity that is insufficient for

the room size, bad heat insulation of the room, incorrect use or force majeure (e.g. power failure).

•Only connect the appliance to A.C. mains as specified on the rating plate!

•Never touch live parts! Danger to life!

•Never operate the appliance with wet hands! Danger to life!

•The appliance must be placed in a way that the control elements cannot be touched by persons who

are in a bath, shower, or any other water-filled receptacle.

•Do not use the appliance in rooms with bath, shower or swimming pool or in the vicinity of wash

basins or water connections!

•Do not expose the appliance to rain or other moisture! The appliance is not for outdoor use. The

appliance must only be stored indoors!

•Never use the appliance if the appliance or cord is damaged. Risk of injury!

•Check the power cord regularly for damage.

•If the power cord or the appliance is damaged to the extent that electrical parts are exposed,

disconnect it immediately from the mains and consult your retailer or manufacturer!

•Improper repairs can expose the user to considerable danger.

•The appliance may only be opened up and repaired by authorized qualified personnel.

•Do not store or use any flammable materials or sprays in the vicinity of the appliance when the

appliance is in use. Fire hazard!

•Do not use the appliance in flammable atmospheres (e.g. in the vicinity of combustible gases or

spray cans)! Explosion and fire hazard!!

•The appliance should not be used in areas which are a fire risk, such as garages, stables, or wooden

sheds.

•Important! Do not insert any foreign objects into the appliance openings! Risk of injury (electric

shock) and damage to the appliance!

•The appliance air inlet and outlet openings must not be obstructed in any way!

•Do not touch the air outlet grill whilst in operation or immediately after use. Risk of burns!

•WARNING: IN ORDER TO AVOID OVERHEATING, DO NOT COVER THE HEATER.

•The appliance is not intended for use by young children or infirm persons without supervision!

•Young children should be supervised to ensure that they do not play with the appliance!

•Attention! To avoid any danger due to unintentionally resetting the thermal cut-out, the appliance

must not be supplied via a timer.

•The appliance is not suitable for animal breeding purposes!

•The instruction leaflet belongs to the appliance and must be kept in a safe place. When changing

owners, the leaflet must be surrendered to the new owner!

•Disconnect from mains when not in use or cleaning.

•It is not recommended to use an extension cord.

•Do not locate the heater immediately below a socket-outlet.

•When the heater is turned on for the first time, it may release a slight, harmless odor. This odor is

a normal occurrence caused by the initial heating of the internal heating elements and should not

occur again.

2. PRODUCT FEATURES

•2 heat power selections

•Touch control panel

•Remote control

•Timer (1-12 hours)

•Oscillation function (76°)

•LED function indicators

•LCD display

•Overheat protection

•Tip-over protection

•Removable air filter for easy cleaning

•Temperature setting from 15°C to 35°C

3. ASSEMBLY INSTRUCTION

•Open the packing, remove the unit and unscrew to open the base locknut.

•Fit the glass base onto the bottom of the unit and securely screw the base locknut.

•The unit is now assembled and should be placed upright; always ensure it is placed on a flat floor

or surface for use.

4. PARTS DESCRIPTION

5. OPERATING INSTRUCTION

Firstly, plug in the appliance to a power source matching that on the units rating label.

Power switch (located below the removable air filter at the rear of the unit)

Press the power button to “I” position. You should hear a beep sound; the heater is now ready for

use. Pressing the button to “0” position turns off the heater.

Control Panel and display window

STANDBY

Press the standby “ ” key, the power indicator light will turn ON. The heater begins operation

at low heat power - (LED indicator on the heating function shows “LOW”).

Press this key again and all functions will stop. The LED indicator turns off and the unit is back

in standby mode.

HEAT

When the unit is operated at low heating power, press the “ ” key, the high heating power

will be turned on, and the LED indicator will show “HIGH”.

Pressing this key allows for the selection of either low heat or high heat power options.

OSC (Oscillation)

When the unit is operating, press the “ ” key, the heater body will begin turning left and right

automatically up to 76°. The LED indicator of this oscillation function will be turned on.

Press this key again, the oscillation function will stop and the LED light will turn off.

MODE

When the unit is in operation, press the “ ” button to set the timer or thermostat.

Note: when the set key “ ”has been pressed to set the timer or change the required

temperature, the LED light will flicker for approx 5 seconds.

During this 5 second interval changes can be inputted by pressing the “+” or “-” keys.

However if after pressing the set key “ “ no further buttons are pressed the unit will return to

display the room temperature and to make further changes the process needs to begin again.

A: Setting the timer:

Press the key, the light will show “0 H”, then press the “+” or “-“keys to set the working time,

(within a range of 1-12 hours).

The time can increase or decrease in intervals of 1 hour/each by pressing the “+” or “-“keys. The

display will show the final time you have set.

B: Setting the thermostat:

When the timer has been set (if desired), press the “ ” again. The LED displays 25℃, now

you can adjust the thermostat to your required temperature setting. The temperature setting is

increased or decreased in intervals of 1°C/each press of the “+” or “-“keys. The display will show

the final temperature you have set. Range 15 - 35°C)

When the room temperature is ≤-10℃, the LCD display will show as “LO”

When the room temperature is > 40°C, the LCD display will show as “HI”.

When the room temperature is between -10℃to 40℃, then the LCD display will show the

corresponding temperature by number.

6. REMOTE CONTROL

(Picture 1)

(Picture 2)

Battery replacement in the remote control

•Slide out the battery holder at the rear of remote control. (Picture 1)

•Insert a 3V Li battery (CR 2032) into the tray of the door, battery text facing up.(Picture 2)

•Slide the battery holder back into the remote control; it is now ready for use.

Operation of the remote control

Remote control panel

There are six function keys on the remote control and their functions match those on the control

panel of the heater.

When operating the remote control, always point the remote towards the display window of the

heater; the signal distance is approx. 6 meters.

7. CLEANING AND MAINTENANCE

Make sure the power switch is turned off and the plug is disconnected from the power socket before

cleaning or any maintenance. Otherwise, it may cause electric shock.

1. Cleaning the unit surface:

Clean the surface with damp cloth (or add some mild detergent). Do not use corrosive detergent or

solvent to clean, such as Petrol, Tina, etc. Never wash the unit directly with water or a soaked cloth.

2. Clean the air filter (recommended monthly, if required)

•Remove the air filter for cleaning as shown in the following diagram.

•Do not use any chemicals for cleaning the filter.

•Use a soft cloth/duster to wipe away the dust. If you use water for cleaning, please make sure the air

filter is completely dried before placing the filter back into the unit.

Recycling: For electrical products sold within the European Community. At the end of

the electrical products useful life it should not be disposed of with household waste.

Please recycle where facilities exist.

Check with your Local Authority or retailer for recycling advice in your country.

8. After sales service

Your product is guaranteed for one year from the date of purchase. Within this period, we undertake to repair

or exchange this product free of charge provided it has been installed and operated in accordance with these

instructions.

Your rights under this guarantee are additional to your statutory rights, which in turn are not affected by this

guarantee. Should you require after sales information or assistance with this product please go to

www.gdcgroup.co.uk or ring our helpdesk on 0845 604 2330 (UK) or 01 842 4833 (R.O.I).

Please retain your receipt as proof of purchase.

CE This appliance complies with European Safety Standard EN 60335-2-30, and European Electromagnetic

Compatibility (EMC) EN 55014, EN 60555-2 and EN 60555-3. These cover the essential requirements of EEC

Directives 2006/95/EC and 2004/108/EC

Dimplex Customer Services UK: 0845 604 2330

Millbrook House Fax: 01489 773050

Grange Drive Email; customer.services@dimplex.co.uk

Hedge End

Southampton

S030 2DF Republic of Ireland 01. 842 4833

SO30 2DF

A division of GDC Group Ltd,

Website: www.gdcgroup.co.uk

[c] GDC Group Ltd

writing of GDC Group Limited.

Autres manuels pour Studio G DXSTG25

Table des matières

Autres manuels Dimplex Chauffage

Dimplex

Dimplex CXLSN Manuel utilisateur

Dimplex

Dimplex DXFF30TS Manuel utilisateur

Dimplex

Dimplex OFCB5 Manuel utilisateur

Dimplex

Dimplex OFRC15FA Manuel utilisateur

Dimplex

Dimplex PLXE Series Manuel utilisateur

Dimplex

Dimplex CPTS Manuel utilisateur

Dimplex

Dimplex FutuRad FutM2BT Manuel utilisateur

Dimplex

Dimplex KBE 50 Manuel utilisateur

Dimplex

Dimplex Saletto LPP050 Manuel utilisateur

Dimplex

Dimplex AC6RN Manuel utilisateur

Dimplex

Dimplex FX 20VE Manuel utilisateur

Dimplex

Dimplex DX 421 Manuel utilisateur

Dimplex

Dimplex Saletto LPP050E Manuel utilisateur

Dimplex

Dimplex DIR Series Manuel utilisateur

Dimplex

Dimplex PPC Series Manuel utilisateur

Dimplex

Dimplex B075E Manuel utilisateur

Dimplex

Dimplex SRX 080M Manuel utilisateur

Dimplex

Dimplex XL Manuel utilisateur

Dimplex

Dimplex FFIH15A31 Series Manuel utilisateur

Dimplex

Dimplex CXLS12N Manuel utilisateur

Dimplex

Dimplex FSR 15...35 GW Guide rapide

Dimplex

Dimplex DESC2T Manuel utilisateur

Dimplex

Dimplex DTD Manuel utilisateur

Dimplex

Dimplex OFRC10 Manuel utilisateur

Manuels Chauffage populaires d'autres marques

oventrop

oventrop Regucor Series Manuel utilisateur

Blaze King

Blaze King CLARITY CL2118.IPI.1 Manuel utilisateur

ELMEKO

ELMEKO ML 150 Manuel utilisateur

BN Thermic

BN Thermic 830T Manuel utilisateur

KING

KING K Series Mode d’emploi

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Guide de démarrage rapide

Well Straler

Well Straler RC-16B Manuel utilisateur

EUROM

EUROM 333299 Manuel utilisateur

Heylo

Heylo K 170 Manuel utilisateur

Eterna

Eterna TR70W Manuel utilisateur

Clarke

Clarke GRH15 Mode d’emploi

IRSAP

IRSAP The Radiator Company Ovali Manuel utilisateur

Empire Heating Systems

Empire Heating Systems WCC65 Manuel utilisateur

Wetekom

Wetekom 92 86 43 Manuel utilisateur

Desa

Desa SPC170-F Manuel utilisateur

Watlow

Watlow Watrod Electric Tubular Heaters Manuel utilisateur

Haverland

Haverland ECO-DRY GPS Series Manuel de la liste des pièces

Stelpro

Stelpro ASILVC2060 Series Manuel utilisateur