Dimplex DHCH20E Manuel utilisateur

For domestic household use only.

INSTRUCTION MANUAL

2kW DC Ceramic Tower Heater -

Electronic Controls

Model: DHCH20E

IMPORTANT

THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND

RETAINED FOR FUTURE REFERENCE.

Note also the information presented on the appliance

CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE INJURY AND/

OR DAMAGE AND MAY INVALIDATE YOUR WARRANTY

Please read the operating instructions carefully before using your product for

the first time and keep them in a safe place.

• When using electrical appliances, basic precautions should always be followed

to reduce the risk of fire, electrical shock and injury to persons, including the

following:

• If the appliance is damaged, check with the supplier before installation and

operation.

- Do not use outdoors.

- Do not use in the immediate surroundings of a bath, shower or a

swimming pool.

- Do not use this heater if it has been dropped.

- Do not use if there are visible signs of damage to the heater.

- Use this heater on a horizontal and stable surface, or fix it to the

wall, as applicable.

• Do not locate the appliance immediately below a fixed socket outlet or

connection box.

• This appliance is not intended for use by persons (including children) with

reduced physical, sensory or mental capabilities, or lack of experience and

knowledge, unless they have been given supervision or instruction concerning

use of the appliance by a person responsible for their safety.

• Children should be supervised to ensure that they do not play with the

appliance.

• Do not use this appliance in series with a thermal control, a program controller,

a timer or any other device that switches on the heat automatically, since a

fire risk exists when the appliance is accidentally covered or displaced.

• In the event of a fault, unplug the appliance.

• Unplug the appliance when not required for long periods.

• This product is intended for INDOOR RESIDENTIAL applications only.

• DO NOT cover cord with carpeting, throw rugs, runners, or similar coverings.

• DO NOT route cord under furniture or appliances. Take care to position the

cord away from traffic areas and where it will not be a tripping hazard.

• This appliance must not be used in a bathroom.

• The appliance must be positioned so that the plug is accessible.

• Although this appliance complies with safety standards, we do not recommend

its use on deep pile carpets or on long hair type of rugs.

• The appliance must be positioned so that the plug is accessible.

• If the supply cord is damaged it must be replaced by the manufacturer or

service agent or a similarly qualified person in order to avoid a hazard.

• Keep the supply cord away from the front of the appliance.

• Do not use this heater in small rooms when they are occupied by persons

not capable of leaving the room on their own, unless constant supervision is

provided.

• To reduce the risk of fire, keep textiles, curtains and or flammable material a

minimum distance of 1m from the air outlet.

• In order to avoid overheating, DO NOT COVER the appliance. Do not place

material or garments on the appliance, or obstruct the air circulation around

the appliance, for instance by curtains or furniture, as this could cause

overheating and a fire risk.

• This Heater carries the warning symbol indicating that it must not

be covered.

• In order to avoid a hazard due to inadvertent resetting of the thermal cut-out,

this appliance must not be supplied through an external switching device,

such as a timer, or connected to a circuit that is regularly switched on and off

by the utility.

• CAUTION: Some parts of this product can become very hot and cause burns.

Particular attention has to be given where children and vulnerable people are

present.

• Do not use this appliance with an extension lead or power board.

• Do not use this appliance in series with a thermal control, a program controller,

a timer or any other device that switches on the heat automatically, since a

fire risk exists when the appliance is accidentally covered or dis-placed.

WARNING: KEEP BATTERIES OUT OF REACH OF CHILDREN

• Swallowing may lead to serious injury in as little as 2 hours or death, due to

chemical burns and potential perforation of the oesophagus.

• If you suspect your child has swallowed or inserted a button battery

immediately call the 24-hour Poisons Information Centre on 13 11 26 (in

Australia) or 0800 764 766 (in New Zealand) for fast, expert advice.

• Examine devices and make sure the battery compartment is correctly secured,

e.g. that the screw or other mechanical fastener is tightened. Do not use if the

compartment is not secure.

• Dispose of used button batteries immediately and safely. Flat batteries can

still be dangerous.

CAUTION: No obvious symptoms

Unfortunately, it is not obvious when a button or coin battery is stuck in a

child's oesophagus (food pipe).

There are no specific symptoms associated with this. The child might:

• cough, gag or drool a lot

• appear to have a stomach upset or virus

• be sick

• point to their throat or stomach

• have a pain in their abdomen, chest or throat

• be tired or lethargic

• be quieter or more clingy than usual or otherwise 'not themselves'

• lose their appetite or have a reduced appetite

• not want to eat solid food/be unable to eat solid food

These types of symptoms vary or fluctuate, with the pain increasing and then

subsiding.

A specific symptom to button and coin battery ingestion is vomiting fresh

(bright red) blood. If the child does this seek immediate help. The lack of clear

symptoms is why it is important to be vigilant with 'flat' or spare button or

coin batteries in the home and the products that contain them.

Exposed to the

weather outdoors

Near water If the power cable

wires are frayed or cut

Where small children

may be left unattended

No extension leads or

power boards

Where there is risk

of fire or close to

a naked flame

Where the power

cable may be

damaged

On a slope or

uneven surface

Where it may be

damaged by

chemicals

If there is a risk

of water falling on

the unit

Where there is a risk

of interference by

foreign objects

This product is not

made for DIY repair

Model no. DHCH20E

Power supply

220-240V~, 50Hz

Rated power

2000W

Heat settings

Thermostat 10-35°C

Timer 0-8hrs

Oscillation Y

Weight (net) 2.7kg

Dimensions (w x d x h) 170 x 200 x 530mm

Specifications

For greater precision, please always refer to the rating label placed on the product.

Parts

Base

Air Outlet

Handle

Control Panel

& Display

Power Switch

Control Panel & Remote

Safety Features

This appliance incorporates a number of safety devices. In addition to the ‘Important

Safety Advice’ section your attention is drawn to the following;

Overheat Protection

The heater is fitted with a temperature limiter which will turn OFF the heater should it

overheat for any reason. The product will return to normal operation after the cause

of the overheating has been rectified.

Temp

Down

Temp

Oscillation

Timer Heat Power

Power

Temp Up

Temp

Down

Timer

Oscillation

Heat

Operation

Note: Before inserting the plug into an electrical outlet, make sure that the elec-

trical supply in your area matches that on the rating label of the unit.

1. When the unit is plugged in, turn the POWER SWITCH on at the back of the

unit to enter standby mode.

2. When in standby mode, press the POWER button once on the control panel

to make the LED display show the room temperature. Press the POWER but-

ton again to access the rest of the functions.

3. To enter low heat mode, press the HEAT button once. The heater will work at

1200W, and the heat symbol ( ) will show on the display. To enter high heat

mode, press the HEAT button again. The heater will work at 2000W, and two

heat symbols will show on the display ( ) ( )

4. To use the timer, press the TIMER button. Each time you press this button, the

timer will increase by 1 hour, from 1-8 hours.

5. To adjust the room temperature, use the TEMP UP and TEMP DOWN buttons.

These will increase or decrease the temperature by 1°C. The unit ranges from

10-35°C. If the room temperature is up to 4°C lower than the set temperature

of the unit, the unit will work on high heat mode. If the room temperature is

only 2°C lower or less, the unit will work on low heat mode. When the room

temperature reaches the set temperature, the heating function will stop and

the fan will run until the room temperature is lower again, and the unit will

take action as above.

6. Press the OSCILLATION button to allow the unit to swing left to right. Press

this button again to stop.

Note: Press the On/Off button to turn off the unit. The heating will stop immedi-

ately and the fan will operate for approximately 30 seconds before switching off

completely, allowing the unit to cool down.

Display Lights

After 10 minutes of operation, if no further function has been activated, the unit

will enter sleep mode and all display lights will switch off. To exit sleep mode,

click any button.

Remote Control

Cleaning

Over time, dust can accumulate on the heater which can effect performance.

It is recommended to clean the unit at least once a month.

1. Turn the unit OFF and disconnect the appliance from the power supply.

2. Remove any dust build up with a soft brush.

3. Wipe the surface of the unit with a soft damp cloth. Mild detergent can be

used for any stubborn marks.

IMPORTANT

The control panel and other parts must not come into contact with water or

any other liquids.

Storage

If not using the unit for an extended period of time. After cleaning please:

• Ensure control switch is OFF and remove plug from the power outlet.

• Cover the unit and store it upright in a location where it will not receive direct

sunlight. NB- Prolonged exposure to direct sunlight will discolour the unit.

Remote control

WARNING: It takes time for the receiver to respond to the transmitter. Do not press the

buttons more than once within two seconds for correct operation.

1. To activate the remote control remove the battery isolation strip, which is used to

ensure your remote control reaches you fully charged.

2. To replace the remote control battery, turn over the remote control, and follow the

diagram embossed on the remote control

3. Only use CR2025 size batteries.

To replace the battery:

1. Remove the screw, push down on the battery cover located on the back of the remote

control. Slide the battery cover open.

2. Install 1 x 3V CR2025 Lithium battery in the battery holder. The positive (+) side of

the battery faces up.

3. Close the battery cover and replace the screw

Table des matières

Autres manuels Dimplex Chauffage

Dimplex

Dimplex EF 12/20 TI Manuel utilisateur

Dimplex

Dimplex CHESIL CLS20 Manuel utilisateur

Dimplex

Dimplex DXDF20 Manuel utilisateur

Dimplex

Dimplex XL12N Manuel utilisateur

Dimplex

Dimplex SAF6 Series Manuel utilisateur

Dimplex

Dimplex ML Series Manuel utilisateur

Dimplex

Dimplex BFH24R Manuel utilisateur

Dimplex

Dimplex PLX075NN Manuel utilisateur

Dimplex

Dimplex BFH24BWST Manuel

Dimplex

Dimplex THORNE & DERRICK AC6 Manuel utilisateur

Dimplex

Dimplex RAL15-AU Manuel utilisateur

Dimplex

Dimplex DGWH4031 Manuel utilisateur

Dimplex

Dimplex BLF3451 Manuel utilisateur

Dimplex

Dimplex Quantum series Manuel utilisateur

Dimplex

Dimplex DYOF15 Manuel utilisateur

Dimplex

Dimplex SLR 200WE Manuel utilisateur

Dimplex

Dimplex LPC Series Manuel utilisateur

Dimplex

Dimplex EUH02B21T Manuel utilisateur

Dimplex

Dimplex BFH24T Manuel utilisateur

Dimplex

Dimplex QM050RF Manuel utilisateur

Dimplex

Dimplex RPX075N Manuel utilisateur

Dimplex

Dimplex CXLS12N Manuel utilisateur

Dimplex

Dimplex DXUC2B Manuel utilisateur

Dimplex

Dimplex HL 185 T Manuel utilisateur

Manuels Chauffage populaires d'autres marques

oventrop

oventrop Regucor Series Manuel utilisateur

Blaze King

Blaze King CLARITY CL2118.IPI.1 Manuel utilisateur

ELMEKO

ELMEKO ML 150 Manuel utilisateur

BN Thermic

BN Thermic 830T Manuel utilisateur

KING

KING K Series Mode d’emploi

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Guide de démarrage rapide

Well Straler

Well Straler RC-16B Manuel utilisateur

EUROM

EUROM 333299 Manuel utilisateur

Heylo

Heylo K 170 Manuel utilisateur

Eterna

Eterna TR70W Manuel utilisateur

Clarke

Clarke GRH15 Mode d’emploi

IRSAP

IRSAP The Radiator Company Ovali Manuel utilisateur

Empire Heating Systems

Empire Heating Systems WCC65 Manuel utilisateur

Wetekom

Wetekom 92 86 43 Manuel utilisateur

Desa

Desa SPC170-F Manuel utilisateur

Watlow

Watlow Watrod Electric Tubular Heaters Manuel utilisateur

Haverland

Haverland ECO-DRY GPS Series Manuel de la liste des pièces

Stelpro

Stelpro ASILVC2060 Series Manuel utilisateur