Dimplex CDFI-TMHEAT Manuel utilisateur

Owner’s Manual

Model

CDFI-TMHEAT

6910040159

To view the full line of Dimplex products, please visit

www.dimplex.com

7215510100R00

IMPORTANT SAFETY INFORMATION: Always read this manual rst

before attempting to install or use this heater. For your safety, always

comply with all warnings and safety instructions contained in this manual

to prevent personal injury or property damage.

2 www.dimplex.com

Table of Contents

Always use a quali ed technician

or service agency to repair

this heater.

!NOTE: Procedures and

techniques that are considered

important enough to emphasize.

CAUTION: Procedures and

techniques which, if not carefully

followed, will result in damage to

the equipment.

WARNING: Procedures

and techniques which, if not

carefully followed, will expose

the user to the risk of  re,

serious injury, or death.

Welcome & Congratulations . . . . . . . . . . . . . . . . . .3

IMPORTANT INSTRUCTIONS . . . . . . . . . . . . . . . .4

Heater Installation . . . . . . . . . . . . . . . . . . . . . . . . .6

Operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .13

Maintenance. . . . . . . . . . . . . . . . . . . . . . . . . . . . .14

Technical Support . . . . . . . . . . . . . . . . . . . . . . . . .14

Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .15

Welcome & Congratulations

Thank you and congratulations for choosing to purchase a Dimplex

electric heater.

Please carefully read and save these instructions.

CAUTION: Read all instructions and warnings carefully before

starting installation. Failure to follow these instructions may result in a

possible electric shock, re hazard and will void the warranty.

Please record your model and serial numbers below for future

reference: model and serial numbers can be found on the Model and

Serial Number Label of your heater.

NO NEED TO RETURN TO THE STORE

Questions with operation or assembly? Require Parts Information?

Product Under Manufacturer’s Warranty?

For Troubleshooting and Technical Support

OR Toll-Free 1-888-DIMPLEX (1-888-346-7539)

Monday to Friday 8:00 a.m. to 4:30 p.m. EST

Please have your model number and

product serial number ready. (See above)

S E R IAL No.

MODE L

MOD.

4 www.dimplex.com

When using electrical appliances,

basic precautions should always

be followed to reduce the risk of

fire, electric shock, and injury to

persons, including the following:

①Read all instructions before

using the heater.

②The heater is hot when in

use. To avoid burns, do not let

bare skin touch hot surfaces.

The surface around the heater

outlet becomes hot during heater

operation.

DANGER: High temperatures

may be generated under certain

abnormal conditions. Do not

partially or fully cover or obstruct

the front of this heater.

③Extreme caution is necessary

when any heater is used by or

near children or invalids and

whenever the unit is left operating

and unattended.

④Always disconnect the heater

when not in use.

⑤Do not operate any heater

after it malfunctions. Disconnect

power at the service panel and

have the heater inspected by

a reputable electrician before

reusing.

IMPORTANT INSTRUCTIONS

⑥ Do not operate any unit with a

damaged cord or if the heater has

malfunctioned, or if the heater

has been dropped or damaged

in any manner, contact

Technical Service at

1-888-346-7539.

⑦Do not use outdoors.

⑧Never locate heater over a

bathtub or other water container.

⑨To disconnect the unit, turn

the controls OFF, disconnect

power at the service panel.

⑩Do not insert or allow foreign

objects to enter any ventilation

or exhaust opening as this may

cause an electric shock or fire, or

damage to the heater.

⑪To prevent a possible fire, do

not block air intake or exhaust in

any manner.

⑫All electrical heaters have

hot and arcing or sparking parts

inside. Do not use in areas where

gasoline, paint, or flammable

liquids are used or stored.

⑬Do not modify the heater.

Use it only as described in

this manual. Any other use

SAVE THESE INSTRUCTIONS

IMPORTANT INSTRUCTIONS

not recommended by the

manufacturer may cause fire,

electric shock or injury to persons.

⑭Always use a certified

electrician should new circuits or

outlets be required.

⑮Always use properly

grounded, fused and polarized

outlets.

⑯Disconnect all power supply

before performing any cleaning,

maintenance or relocation of the

unit.

⑰ When transporting or storing

the unit, keep in a dry place, free

from excessive vibration and

store so as to avoid damage.

!NOTE: Changes or

modications not expressly

approved by the party responsible

for compliance could void

user's authority to operate the

equipment.

For Bathroom Use

If this unit is installed in a

bathroom it must be protected

by a GFI receptacle or circuit.

If receptacle is used it must be

readily accessible.

To prevent electrical shock this

unit is an electrical appliance

that is not watertight and must

be installed as to prevent water

from entering unit. This must be

installed away from showers,

tubs, etc. Never locate heater

where it may fall into a bathtub or

other water container.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

NO USER-SERVICABLE PARTS INSIDE

6 www.dimplex.com

Heater Installation

WARNING:

ANY

INSTALLATION AND

SERVICE WORK SHOULD BE

PERFORMED BY QUALIFIED

AND AUTHORIZED PERSONNEL.

ALL INSTALLATIONS MUST

COMPLY WITH ALL LOCAL

CODES AND BY-LAWS,

INSPECTED AND APPROVED

FOR OPERATION BY LOCAL

GOVERNIN

G AUTHORITY PRIOR

TO USE.

WARNING: Construction

and electrical outlet wiring must

comply with local building codes

and other applicable regulations

to reduce the risk of re, electric

shock and injury to persons.

!NOTE: A 15 Amp, 120 Volt

circuit is required. A dedicated

circuit is preferred but not

essential in all cases. A dedicated

circuit will be required if, after

installation, the circuit breaker

trips or fuse blows on a regular

basis when the heater is

operating. Additional appliances

on the same circuit may exceed

the current rating of the circuit

breaker.

Hardwire Installation

The heater is supplied in an

assembled state and is designed

to be permanently installed. The

unit comes ready for hardwire

installation.

WARNING: Do not attempt

to wire your own new outlets or

circuits. To reduce the risk of re,

electric shock or injury to persons,

always use a licensed electrician.

!NOTE: Please read all

instructions before installing.

1. For rough in framing, the

opening should follow the

recommended dimensions

located in Figure 2.

!NOTE: Dimensions provided

are minimum clearances and will

vary depending on type of support

framing and nishing options.

!NOTE: Framing should be

constructed to support 10 lbs

(4.5 kg).

WARNING: To reduce the

risk of re, do not store or use

gasoline or other ammable

vapors or liquids in the vicinity of

the heater.

Heater Installation

2. Allow at least 2 ft. (61 cm) of service cable for connecting

the power supply wire.

CAUTION: Keep min 6" clearance to the adjacent walls and min

18” clearance to the oor.

!NOTE: Use minimum 14 AWG supply cable with two insulated

copper conductors (white and black) and one bare ground wire.

!NOTE: The heater only exhausts from one direction. Note this

direction, see gure 7.

0.18"

(4.5mm)

7.6"

(192mm)

(201mm)

(128mm)

15"

(380mm)

Pilot light

0.4"

(10mm)

0.4"

(10mm)

1.3"

(34mm)

12.6"

(321mm)

3.4"

(86mm)

Figure 1

8 www.dimplex.com

326mm

12.83"

17mm

0.67"

17mm

0.67"

36mm

1.42"

128mm

5.04"

360mm

14.17"

ref

206mm

8.11" FINISHED CEILING

MOUNTING OPENING

FRAMING

FOR REF.

MOUNTING

HOLES

LOCATION

Heater Installation

Installation Options

The heater can be installed on its

own or with an Opti-myst cassette.

The unit needs to be installed so

that the heater outlet is horizontal

to the ground. The required

opening dimensions for the

heater are: 12.8" (326 mm) x 8.1"

(206 mm) x 3.5" (89 mm) deep.

!NOTE: The heater does not

require any additional venting.

!NOTE: Install the heater so

that the pilot light can be seen

5 ft (153 cm) from the oor and

10 ft (305 cm) from the unit.

(Figure 3)

Figure 2

Example:

Distance from

oor

Distance from

front wall

54" 6"

36" 2"

THERMAL

CUTOUT

120V~ 60HZ

1 23

ON/OFF SWITCH

(PILOT LIGHT)

Relay Board

3001890100

HEATING ELEMENT

MOTOR

Heater Installation

5.0 ft (153 cm)

10.0 ft (305 cm)

Figure 3

Wiring

Distance

from oor

Distance from

front wall

10 www.dimplex.com

Heater Installation

Plugs into Opti-myst cassette

CDFI1000-PRO or

CDFI500-PRO, refer to

the cassette user’s guide.

Heater control

wire. Used when

controlled by the

Opti-myst cassette

CDFI1000-PRO or

CDFI500-PRO.

Cable

Plate

Figure 4

CAUTION: Use two

conductor, non-metallic sheath

cable with ground wire (3 wires

total) for the incoming power

supply. Use appropriate wire to

meet local and national electrical

codes for rated power.

1. On the back of the unit, remove

the cable clamp by removing

the screw at the top (Figure 4).

2. Install a 3/8"(10 mm) or 1/2 in.

(13 mm) cable connector, not

included, suitable for mounting

in a 7/8"(22 mm) hole, to the

cable plate and feed the supply

cable through the connector

and secure.

3. Remove the 3 wires from within

the unit.

4. Connect the black wire (live)

from the unit to the black wire

from power supply.

Table des matières

Langues :

Autres manuels Dimplex Chauffage électrique

Dimplex

Dimplex ZHE 050 Manuel utilisateur

Dimplex

Dimplex BUH19BWS Manuel utilisateur

Dimplex

Dimplex EMC4240 Manuel utilisateur

Dimplex

Dimplex Danube DNB20 Manuel utilisateur

Dimplex

Dimplex WFC 3NS Manuel utilisateur

Dimplex

Dimplex DLG1058 Manuel utilisateur

Dimplex

Dimplex WW 101 E Manuel utilisateur

Dimplex

Dimplex DGWH4031 Manuel utilisateur

Dimplex

Dimplex PUH1500 Manuel utilisateur

Dimplex

Dimplex Apollo APL100 Manuel utilisateur

Dimplex

Dimplex Lucia LUC20 Manuel utilisateur

Dimplex

Dimplex QSH-70 Manuel utilisateur

Dimplex

Dimplex ML2TA Manuel utilisateur

Dimplex

Dimplex PLX 500 Manuel utilisateur

Dimplex

Dimplex Opti-V VISTA VST130-I Manuel utilisateur

Dimplex

Dimplex Optiflame DF2608-LED Manuel utilisateur

Dimplex

Dimplex Quantum series Manuel utilisateur

Dimplex

Dimplex RITZ Manuel utilisateur

Dimplex

Dimplex DES 1821 Manuel utilisateur

Dimplex

Dimplex EF12 series Manuel utilisateur

Dimplex

Dimplex DX 512E Manuel utilisateur

Dimplex

Dimplex CUH05B31T Manuel utilisateur

Dimplex

Dimplex DLG1058 Manuel utilisateur

Dimplex

Dimplex BN Series Manuel utilisateur

Manuels Chauffage électrique populaires d'autres marques

Heatscope

Heatscope PURE Guide rapide

Sunbeam

Sunbeam Calentador SFH457A Manuel utilisateur

Dura Heat

Dura Heat DH2000C Manuel utilisateur

Harvia

Harvia K10.5GS Manuel utilisateur

Harvia

Harvia GL70 Manuel utilisateur

Heylo

Heylo DE 2 XL Manuel utilisateur

Heylo

Heylo DE 20 SH Manuel utilisateur

Harvia

Harvia PP70SP Manuel utilisateur

Tylo

Tylo SENSE SPORT Manuel utilisateur

Dirna

Dirna ecodirna SUN Mode d’emploi

Creda

Creda Heating Solution Manuel utilisateur

THERMEx

THERMEx Frame E Wi-Fi Series Manuel utilisateur

SHUFT

SHUFT UniMAX-R 1400VE EC Manuel utilisateur

HUUM

HUUM CLIFF Series Manuel utilisateur

Harvia

Harvia HL70S Manuel utilisateur

Radialight

Radialight SIRIO Manuel utilisateur

Polaris

Polaris PRE E 0715 H Manuel utilisateur

HeatQ

HeatQ HTL Manuel utilisateur