Digital Watchdog DWC-V4567WD Manuel utilisateur

ABOUT MANUAL

Before installing and using the camera, please read this manual carefully.

Be sure to keep it handy for future reference.

960H SNAP-IT

Outdoor Dome Camera

DWC-V4567WD

DWC-V4567WTIR

12132012

PRECAUTIONS

FCC COMPLIANCE

WARNING : Changes or modifications are not expressly approved by the manufacturer.

Do not open or modify.

Do not open the case except during maintenence and installation,

for it may be dangerous and can cause damages.

Do not put objects into the unit.

Keep metal objects and flammable substances from entering the camera.

It can cause fire, short-circuits, or other damages.

Be careful when handling the unit.

To prevent damages, do not drop the camera or subject it to shock or vibration.

Do not install near electric or magnetic fields.

Protect from humidity and dust.

Protect from high temperature.

Be careful when installing near the ceiling of a kitchen or a boiler room,

as the temperature may rise to high levels.

Cleaning :

To remove dirt from the case, moisten a soft cloth with a soft detergent solution and wipe.

Mounting Surface :

The material of the mounting surface must be strong enough to support the camera.

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC rules. These limits are designed to

provide reasonable protection against harmful interference when the equipment is

operated in a residential environment. This equipment generates, uses, and radiates

radio frequency energy; and if it is not installed and used in accordance with the

instruction manual, it may cause harmful interference to radio communications.

Table of Contents

Introduction

Installation

Camera OSD Menu and Glossary

Troubleshooting

Warranty Information

Specifications

Features

Parts and Descriptions

Dimensions

Included Accessories

Easy Installation

Mounting Installation

UTP System

9-13

18-34

36-37

38-39

Connecting to Monitors 15

Adjusting the Camera 16

Adjusting the 3-Axis Gimbal 17

EATURES*

DWC-V4567WD/ DWC-V4567WTIR

1/3” 960H High Resolution CCD

700 TV Lines

3.3~12mm Varifocal Auto Iris Lens

70ft Range IR with Intelligent Camera Sync [V4567WTIR Only]

True Day and Night [V4567WTIR Only]

Star-Light (Super Low Light Technology)

EWDR (Electronic Wide Dynamic Range)

3D-DNR (3D Digital Noise Reduction)

HME (Highlight Masking Exposure)

AGC / SMART BLC / AWB

Night-Up

Negative Imaging

Mirror Image Control

UTP / RS485 Built-in

Programmable Privacy Zones (6) & Motion Detection

Easy Icon Driven OSD Menu with Built-In Joystick

Auto Sensing 12VDC or 24VAC with Line Lock

Secondary Video-BNC Output

IP68 Certified (Waterproof)

PART & DESCRIPTIONS*

Lens

Power Input Connector

DC 12V /AC 24V Voltage

UTP

RS 485

Primary Video-BNC Output Connector

Camera Control Board

Bubble Dome Cover

Upper Case

Flush Mount Case

Surface Mount Case

Assembly Screws

#8 - 32 x 0.75

Secondary Video-BNC Output Connector

Safety Wire

Mounting Screws

NO IR IR

DIMENSIONS IN MILLIMETERS (INCHES)*

Flush Mount Top View

Surface Mount

137(5.39”)

101(3.97”)

17(0.66”)

28(1.10”)

54(2.12”)

98.8(3.88”)

139(5.47”)

118.8(4.67”)

36(1.41”)

29(1.14”)

53.8(2.11”)

121(4.76”)

INSTALLATION*

Included with Outdoor Dome Camera

1. User Manual

2. Mounting Template

3. Second Video Jack

4. Four (4) Screws and Four (4) Dry Wall Anchors

5. L-Wrench

6. TORX-T20 Bolt

7. DC Plug

8. TORX-T20 Wrench

1234

5678

EASY INSTALLATION*

SURFACE MOUNT INSTALLATION INSTRUCTIONS*

DC 12V

AC 24V

UTP

RS485

1. Use the camera’s mounting

template or your camera to

mark the holes as required.

2. Drill holes into the drywall and

insert the drywall mounts into

the holes.

3. Pull wires through and make

connections.

If you need to keep the wiring within the

within the camera

housing, refer to the diagram below.

4. Mount the surface mount

base (junction box) to the

wall.

5. Snap the camera module onto

the base by aligning the red

and black markings on the

base and the camera module.

6. Secure the three (3) assembly

screws.

7. Adjust the camera’s position

by using the 3-Axis Gimbal.

8. Tighten the three locking

screws with the L-Wrench

to secure the cover dome

over the camera.

Flush Mount Installation

For a flush mount housing, remove the surface mount base

(junction box). Cut a large hole on a flat surface for the top part

of the flush mount base. Use the three screws fixed to the base

to secure it to the surface of the wall or ceiling.

Follow steps 6 through 8 of the Surface Mount Installation

Instructions to complete the installation.

ST4X35

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Digital Watchdog Caméra de sécurité

Digital Watchdog

Digital Watchdog D1362D Series Manuel utilisateur

Digital Watchdog

Digital Watchdog MEGApix DWC-MV85WiAT Manuel utilisateur

Digital Watchdog

Digital Watchdog D4252 Series Manuel utilisateur

Digital Watchdog

Digital Watchdog MEGApix MPTZ5X Manuel utilisateur

Digital Watchdog

Digital Watchdog MEGApix Ai DWC-XSDE08Mi Manuel utilisateur

Digital Watchdog

Digital Watchdog MEGApix DWC-MT94WiAT Manuel utilisateur

Digital Watchdog

Digital Watchdog MEGApix DWC-MD44WA Manuel utilisateur

Digital Watchdog

Digital Watchdog MEGApix Flex DWC-PVX20WATW Manuel utilisateur

Digital Watchdog

Digital Watchdog Infinity C233W Manuel utilisateur

Digital Watchdog

Digital Watchdog Star-Light Plus DWC-B6563WTIR Manuel utilisateur

Digital Watchdog

Digital Watchdog DWC-PB753WTW Manuel utilisateur

Digital Watchdog

Digital Watchdog MEGApix DWC-MB72I4V Manuel utilisateur

Digital Watchdog

Digital Watchdog Star-Light DWC-V7253 Manuel utilisateur

Digital Watchdog

Digital Watchdog PowerPix DWC-B6361WTIR Manuel utilisateur

Digital Watchdog

Digital Watchdog MEGApix DWC-MV95Wi28TW Manuel utilisateur

Digital Watchdog

Digital Watchdog DWC-V3363D Manuel utilisateur

Digital Watchdog

Digital Watchdog MEGApix IVA Manuel utilisateur

Digital Watchdog

Digital Watchdog V1362DIR Manuel utilisateur

Digital Watchdog

Digital Watchdog DWC-D6351D Manuel utilisateur

Digital Watchdog

Digital Watchdog MEGApix Pano DWC-MBW8Wi2TW Manuel utilisateur

Digital Watchdog

Digital Watchdog Star-Light Plus DWC-D4583WTIR Manuel utilisateur

Digital Watchdog

Digital Watchdog Infinity OMNI-Plus B2382TIR Manuel utilisateur

Digital Watchdog

Digital Watchdog DWC-MB75Wi4TW Manuel utilisateur

Digital Watchdog

Digital Watchdog STAR-LIGHT Universal HD over Coax... Manuel utilisateur

Manuels Caméra de sécurité populaires d'autres marques

Okina USA

Okina USA SIR36-870VF650LP Manuel utilisateur

Divio

Divio NDR155PA Manuel utilisateur

Canon

Canon VB-C500D Manuel utilisateur

Easy Access

Easy Access EasyGuard Manuel utilisateur

Vivotek

Vivotek FD9389-EHV-v2 Manuel utilisateur

TUYA

TUYA COSMO W2 Manuel utilisateur

Eusso

Eusso UNC7500-IR Guide de configuration

urmet domus

urmet domus 1096/204 Manuel utilisateur

VC VC20 series Manuel utilisateur

Axis

Axis Q1614 Manuel utilisateur

ieGeek

ieGeek DD201 Manuel utilisateur

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Manuel utilisateur

Vicon

Vicon V662-D-1 Mode d'emploi

Grundig

Grundig GCH-K0274P Manuel utilisateur

Lorex

Lorex VANTAGE LBC7032 Manuel utilisateur

4xem

4xem WPT Manuel utilisateur

Samsung

Samsung SCV-3082 Manuel utilisateur

Vitek

Vitek VTC-C544 Manuel utilisateur