DigiFarm AGCO C1000 Guide de référence
MD5007
rev 6
DigiFarm Technical Support
319.531.7574
support@digifarm.com
DigiFarm
Quick Reference Card
AGCO C1000 & RV50
AGCO C1000 Display Setup
1 Connect the RV50 cable to the AGI 4 via the
adapter cable and black connector on the back of
the receiver
2 Navigate to the Wrench icon, then System, then Correction level
3 Select Cellular Network; checkmark “Use external radio”; then select the checkmark on the right
4 Set the Correction type to
“RTCM3.X”; Serial Port to “D”; Baud
Rate to match the Beacon; Parity to
“None”; & NMEA Rate to 10
seconds
MD5007
rev 6
DigiFarm Technical Support
319.531.7574
support@digifarm.com
DigiFarm
Quick Reference Card
AGCO C1000 & RV50
*Note- If this unit was ordered with a subscription, it will be preprogrammed and plug and play ready.
The following instructions will not be needed.
Log into the device via WAN static IP (166.XXX.XXX.XXX:8080) or LAN connection (192.168.1.1:8080) on Port
8080.
Username: digifarm
Password: digifarm
You will then be directed to the page shown below. On this page you can select a receiver preset based on
the receiver type you have, then enter your username and password. Save device info at the bottom then
select the reboot icon at the top of the screen.
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels DigiFarm Matériel réseau
Manuels Matériel réseau populaires d'autres marques
Matrix Switch Corporation
Matrix Switch Corporation MSC-HD161DEL Manuel utilisateur
B&B Electronics
B&B Electronics ZXT9-IO-222R2 Manuel utilisateur
Yudor
Yudor YDS-16 Manuel utilisateur
D-Link
D-Link ShareCenter DNS-320L Manuel utilisateur
Samsung
Samsung ES1642dc Instructions d'utilisation
Honeywell Home
Honeywell Home LTEM-PV Instructions de montage
