- This light should be keep away from strong shaking during any transportation or movement.
-Don ’ t pull up the light by only the hea d, or it might cause damages to the mechanical parts.
- Don ’ t expose the fixture in overhea t, moisture or environment with too much dust when installing
it. And don ’ t lay any power cables on the floor. Or it might cause electronic shock to the people.
- Make sure the installation place is in good safety condition before installing the fixture.
-Make sure to put the safety chain and check whether the screws are screwed properly when
installing the fixture.
- Make sure the lens are in good condition. It
’
s recommended to replace the units if there are any
damages or severe scratch.
- Make sure the fixture is operated by qualified personnel who knows the fixture before using.
- Keep the original packages if any second shipment is needed.
- Don ’ t try to change the fixtures without any instruction by the manufacturer or the appointed
repairing agencies.
-It is not in warranty range if there are any malfunctions from not following the user manual to
operate or any illegal operation, like shock short circuit, electronic shock, lamp broke, etc.
4.
4.
4.
4. Mounting
Mounting
Mounting
Mounting and
and
and
and Installation
Installation
Installation
Installation
Cautions:
Cautions:
Cautions:
Cautions: For added protection mount the fixtures in areas outside walking paths, seating areas,
or in areas were the fixture might be reached by
unauthorized personnel.
Before mounting the fixture to any surface, make sure that the installation area can hold a
minimum point load of 10 times the device ’s weight.
Fixture installation must always be secured with a secondary safety attachment, such as an
appropriate safety cable.
Never stand directly below the device when mounting, removing, or servicing the fixture from a
ceiling, or set on a flat level surface (see illustration below). Be sure this fixture is kept at least
0.5m (1.5 ft) away from any flammable materials (decoration etc.).
Always use and install the supplied safety cable as a safety measure to prevent accidental
damage and/or injury in the event the clamp fails.
Mounting
Mounting
Mounting
Mounting points:
points:
points:
points: Overhead mounting requires extensive experience, including amongst others
calculating working load limits, a fine knowledge of the installation material being used, and
160-179 Gobo 5 shake slow to fast
180-199 Gobo 6 shake slow to fast
200 - 219 Gobo 7 shake slow to fast
220 - 255 Rot. gobo wheel cont. rotation slow to fast
7 5 5
Gobo 1
Rot.
0-127 Gobo indexing
128-189 Forwards gobo rotation from fast to slow
190-193 Gobo rotation stop
194-255 Backwards gobo rotation from slow to fast
8 6 6 Gobo 2
0 - 009 Open/hole
010 - 019 Gobo 1
020 - 029 Gobo 2
030 - 039 Gobo 3
040 - 049 Gobo 4
050 - 059 Gobo 5
0 60 - 069 Gobo 6
070-079 Gobo 7
080-089 Gobo 8
090-099 Gobo 9
100-111 Gobo 1 shake slow to fast
112-123 Gobo 2 shake slow to fast
124-135 Gobo 3 shake slow to fast
136-147 Gobo 4 shake slow to fast
148-159 Gobo 5 shake slow to fast
160-171 Gobo 6 shake slow to fast
172 -1 83 Gobo 7 shake slow to fast
184-195 Gobo 8 shake slow to fast
196-207 Gobo 9 shake slow to fast
208-255 Gobo wheel rotation from slow to fast
0- 031 Shutter closed
032 - 063 shutter open
