REV. E 6/12
A. Safety Instructions
Before Punch is set up for operation, mount on work bench or stand*.
*IF PUNCH IS MOUNTED ON ITS OWN STAND, SECURE STAND TO FLOOR
B. Mounting Punches and Dies
After Punch is bolted to the work bench or stand the following procedure is
recommended:
1. Remove both right and left hand Stripper Arm from Ram Cap.
2. Insert Punch in Punch Holder and tighten set screw.
3. Insert Die in Die Holder, tighten set screw and mount on Punch. Do not tighten bolts
on Die Holder.
4. Pull handle down until Punch enters Die to line up Punch in center of Die. Tighten
bolts in Die Holder.
5. Test “lineup” of Punch and Die by inserting paper and punching by hand.
6. Select the notch in the Stripper V Plate that will provide the most support around the
Punch for stripping, and bolt to stripper Arms and mount on Ram Cap*. For Punches
5/16” in diameter and smaller a stripper Plate with three holes is provided. Special
stripper Plates for round, square, are available by special order.
