DFI EC500-ADS Manuel utilisateur

www.dfi.com

EC500-ADS

Modular-Designed Embedded System

Quick Installation Guide

Package Contents

• 1 EC500-ADS System Unit

• 1 M.2 Slot Screws

• 1 Terminal Block 3 Pole For DC Input

• 1 Cable With 2 Wire Stripped And Tinned To DC Jack

Quick Reference | EC500-ADS 1

Product Overview

Front View

HDD LED

Power Button (w/ Status LED)

USB2.0 Type A

COM2

COM1

1245

78910 11

Antenna Holes

Reset Button

Remote Switch

COM4

COM3

DIO

Rear View

3-pole Terminal Block

HDMI/DP++ (Auto Detection)

USB3.1 Type A

LAN1~2

Grounding

5678910

Mic-In

Line-Out

VGA

COM6

COM5

Important:

Please be cautious when inserting an HDMI

cable into the HDMI/DP port. The HDMI

male connector shall align to the left of the

port as illustrated here. The insertion is fairly

effortless and please reframe from forcing

the insertion to prevent damage.

HDMI DP

Quick Reference | EC500-ADS 2

Removing the Chassis Cover

Please observe the following guidelines and follow the instructions to open the system.

Make sure the system and all other peripheral devices connected to it have been

powered off.

2. Disconnect all power cords and cables.

Step 1:

The 12 screws on each

side of the system are used to secure the

cover

the

chassis.

Remove the screws and put them in a safe place for later use.

Left View

Right View

Front View

Rear View

Quick Reference | EC500-ADS 3

Step 2:

Lift the cover to open the system.

Step 3:

The board can be easily accessed after the chassis cover is removed.

Quick Reference | EC500-ADS 4

Installing an Antenna

Before installing the antenna, please make sure that the following safety cautions are

wellattended.

1. Make sure the PC and all other peripheral devices connected to it has been

powered down.

2. Disconnect all power cords and cables.

Step 1:

There are antenna holes reserved on the front side of the system and covered by rubber

plugs. Please remove the plug prior to installing an antenna.

Step 2:

Connect the internal cable to the board's antenna connector, screw the antenna connector

through the antenna hole with washers and nuts, and screw on the antenna as illustrated

below.

Antenna ConnectorCableModule Connector NutWasher

Chassis Wall Antenna

Quick Reference | EC500-ADS 5

Installing an M.2 Card

M.2 E Key

M.2 B Key

M.2 Modules: M.2 B Key & M.2 E Key

M.2 Module: M.2 M Key

Remove four screws and put them in a safe place for later use.

After removing the screws, gently pull the SSD slot out of the system.

Quick Reference | EC500-ADS 6

Remove four mounting screws and put them in a safe place for later use.

Disassemble the heat dissipation plate to access the M.2 M Key.

M.2 M Key

Quick Reference | EC500-ADS 7

Installing the M.2 Module

Before installing the M.2 module into the M.2 socket, please make sure that the following

safety cautions are well-attended.

1. Make sure the PC and all other peripheral devices connected to it has been powered

down.

2. Disconnect all power cords and cables.

3. Locate the M.2 socket on the system board

4. Make sure the notch on card is aligned to the key on the socket.

5. Make sure the standoff screw is removed from the standoff.

M.2 Module M.2 Socket

Key

Stand-off

Notch

Quick Reference | EC500-ADS 8

Please follow the steps below to install the card into the socket.

Step 2:

Press the end of the card far

from the socket down until

against the stand-off.

Step 3:

Screw tight the card onto the

stand-off with a screw driver

and a stand-off screw until

the gap between the card and

the stand-off closes up. The

card should be lying parallel to

the board when it’s correctly

mounted.

Step 1:

Insert the card into the socket

at an angle while making sure

the notch and key are perfectly

aligned.

M.2 Module M.2 Socket

Key

Stand-off

Notch

Quick Reference | EC500-ADS 9

Autres manuels pour EC500-ADS

Table des matières

Autres manuels DFI PC industriel

Manuels PC industriel populaires d'autres marques

Chipsee

Chipsee PPC-A72-101 Manuel utilisateur

Advantech

Advantech UNO-2184G Manuel utilisateur

MSI

MSI MS-9A76 Manuel utilisateur

Stackrack

Stackrack THOR200 Manuel utilisateur

Moxa Technologies

Moxa Technologies DA-682C Series Manuel utilisateur

Nodka

Nodka eBOX-3000-ETC Manuel utilisateur

Siemens

Siemens SIMATIC IPC627E Manuel utilisateur

MSI

MSI MS-9A89 Manuel utilisateur

Artila

Artila Matrix-516 Manuel utilisateur

Siemens

Siemens SIMATIC Rack PC 840 V2 Manuel utilisateur

Advantech

Advantech IPPC-6152A Manuel utilisateur

Beckhoff

Beckhoff CX9020 Manuel utilisateur

Dell

Dell Embedded Box PC 5000 Manuel utilisateur

IBASE Technology

IBASE Technology ASB200-918 Series Manuel utilisateur

Lenovo

Lenovo ThinkCentre M90q Manuel du propriétaire

IXXAT

IXXAT Econ 100 Manuel utilisateur

Kontron

Kontron KBox A-151-TGL Manuel utilisateur

AXIOMTEK

AXIOMTEK ICO500-518 Series Manuel utilisateur