OPERATING INSTRUCTIONS
1. Clamp can securely, use caution not to crush can.
2
3. Shake aerosols cans a of one minute.
4. shake aerosol can if temperature exceeds 100. F
5. Recommended air pressure 100 -140 PSI.
. Quickly open control valve. If shaker fails to start close valve for 5
seconds then reopen.
MAXIMUM
DO NOT
To start shaker:
OPERATION
1. To adjust shaking speed slightly open or close air control valve (#2401).
2.
.
3. For Quart & Pint cans close control valve until shaker runs .
4. For gallon cans open control valve slightly to achieve full stroke.
RUNNING AIR PRESSURE HIGHER THAN REQUIRED FOR THE SIZE OF CAN WILL
RESULT IN SHORTER LIFE SPAN OF SHAKER AND WILL NOT INCREASE EFFICIENCY
QUIETLY
SPEED CONTROL
LUBRICATION
1. Use air tool oil in motor never use motor oil or grease in motor.
2.
3. use oils that contain petroleum distillates.
4. Grease shafts once every 10 hrs. or every 30 days ( ).
5. Oil main shaft once every 30 days with air tool oil (10 drops).
6. Failure to follow lubrication specifications will cause premature failure of the
machine and VOID the warranty.
ONLY
ADJUST OILIER TO 1 DROP OF OIL EVERY 30 SECONDS
DO NOT
1 PUMP
Specifications and Recommendations
Air Consumption
Air Pressure
Air Tool Oil
Capacity
Grease
Oil Consumption
Shaking Speed
Shaking time
Approximately 3.5 cfm
1 -140 PSI
Non-detergent, rust inhibiting, 5w to 10w
1 pint - 1 gallon
lithium or calcium based multipurpose chassis grease
Up to 00 cycles per minute
2-3 minutes average with quart
00
1 drop air tool oil every 30 seconds
10
ASSEMBLY
1. Connect automatic oilier (#2403) to bulk head fitting (#2405) in motor cover (#2406)
USE OF THREAD SEALING COMPOUND IS RECOMMENDED.
2. Then connect air control valve (#2401) using brass nipple (#2404) as shown in
diagram on page 3.
3.
Mount shaker securely to optional shaker stand (#2465) using bolts (#2459). Shaker
stand must be firmly mounted to floor using suitable fasteners (not Inc). Shaker may
also be mounted to a sturdy bench or other platform by replacing bolts (#2459) with
suitable fasteners.
4. FAILURE TO INSTALL AND ADJUST OILIER AS PER INSTRUCTIONS WILL RESULT IN
DAMAGE TO THE SHAKER AND WILL VOID THE WARRANTY.
USE CAUTION NOT TO ALLOW BULK HEAD FITTING TO TURN WHEN INSTALLING
AIR CONTROL VALVE.
CAUTION: SHAKER MUST BE FIRMLY SECURED AS FOLLOWS
