Denver TC-18C Manuel utilisateur
English -
1
INSTRUCTION MANUAL
Location of controls
(1) FUNCTION SWITCH
(CD/POWER OFF/RADIO)
(2) BAND SWITCH
(3) FM ANTENNA
(4) CD DOOR
(5) TUNING KNOB
(6) BASS BOOST BUTTON
(7) CD SKIP/SEARCH FORWARD
BUTTON
(8) CD SKIP/SEARCH BACKWARD
BUTTON
(9) CD PROGRAM BUTTON
(10) CD REPEAT BUTTON
(11) CD STOP BUTTON
(12) CD PLAY/PAUSE BUTTON
(13) CD LED DISPLAY
(14) CD PLAY/PAUSE LED
INDICATOR
(15) CD REPEAT LED INDICATOR
(16) CD PROGRAM LED
INDICATOR
(17) BATTERY DOOR
(18) FM STEREO LED INDICATOR
(19) SPEAKER LEFT
(20) SPEAKER RIGHT
(21) STEREO HEADPHONE JACK
(22) VOLUME CONTROL KNOB
(23) AC SOCKET
English -
2
AC Operation
Before operation please ensure that the VOLTAGE on the set corresponds to
the VOLTAGE of your local area. Unravel the AC Line Cord; insert one end
into the AC jack on the set and the other end into a standard AC outlet.
Remarks:
1.In case of malfunction due to electrostatic discharge (ESD), reset the unit by
reconnecting the AC cord again to resume to normal operation.
2. When not in use – Unplug the AC power cord completely from the AC socket.
BATTERY OPERATION
Disconnect the AC Cord Set completely. Open the BATTERY COMPARTMENT
DOOR and insert UM-2/ “C” size x 8 batteries (not supplied) making sure that
the indicated battery polarity is observed.
RADIO OPERATION
1. Slide the FUNCTION switch to the “RADIO” position.
2. Slide the BAND switch to the desired waveband.
3. Turn the TUNING KNOB to your desired radio station.
4. Adjust the sound level by rotating the VOLUME CONTROL KNOB.
5. To turn off the radio, simply slide the FUNCTION SWITCH to “POWER
OFF” position.
Note: Radio frequency is shown on the TUNING KNOB.
FM STEREO INDICATOR
When tune to a FM stereo broadcast the “FM ST.” LED indicator will light up.
In weak signal areas the FM Stereo signal may not be strong enough and can
cause excessive background noise. In this case, slide the BAND SWITCH to
“FM” position.
ANTENNA
For best reception, fully extend the FM Antenna to receive FM station.
BASS BOOST
To increase bass at all volume levels, slide the BASS BOOST BUTTON to “ON”
position to boost the low frequency tone for an emphasized bass sound. To
release the super bass, simply slide the switch to “OFF” position.
English -
3
CD OPERATION (CD-R/RW PLAYBACK COMPATIBLE)
PLAYING COMPACT DISC
GETTING STARTED
NOTE: Should skipping of tracks occur during CD playing try reduce the
volume.
When CD is playing, do not open the CD Door.
1. Open the CD DOOR by pulling up the CD DOOR. Put a CD into the CD
COMPARTMENT and close the CD DOOR. Set the FUNCTION SWITCH to
“CD” position.
2. When the CD DOOR is closed with a CD inside, the total number of tracks
of the disc will be shown on the CD LED DISPLAY and will go to “STOP”
mode.
3. If the CD DOOR is not closed or there has no disc inside, the DISPLAY
will show “ ” and go to “STOP” mode.
PLAY/PAUSE MODE
1. When the PLAY/PAUSE BUTTON is pressed during CD stop mode, the first
track will be played. The PLAY/PAUSE LED INDICATOR will be lighted.
The CD LED DISPLAY will show the specific number of tracks played.
2. For interruption while the CD is playing, press the CD PLAY/PAUSE
BUTTON once. The PLAY/PAUSE LED INDICATOR will flash continuously.
3. Though the sound stops, the disc will continue to spin. To re-start
playback, press the CD PLAY/PAUSE BUTTON once again. The music will
start from the exact position where it was interrupted.
4. To stop the CD, press the CD STOP BUTTON once whether the CD is in
Play or Pause mode.
5. To turn off the CD, slide the FUNCTION SWITCH to “POWER OFF”
position.
REPEAT MODE
1. REPEAT 1:
When the REPEAT BUTTON is pressed once, the REPEAT LED INDICATOR
will light and flash continuously. This single track of music will be
repeated.
2. REPEAT ALL:
When the REPEAT BUTTON is pressed twice, the REPEAT LED
INDICATOR will stay lit. The whole disc can be played continuously.
3. TO CANCEL THE REPEAT FUNCTION
Press the REPEAT BUTTON until the lighted REPEAT LED INDICATOR is
turned off.
English -
4
SKIP AND SEARCH MODE
1. During play or pause mode, when CD SKIP FORWARD “>>” or CD SKIP
BACKWARD “<<” Button is pressed once, it will go to the next track or go
back to the beginning of the track.
2. During play mode, when CD SKIP FORWARD “>>” or CD SKIP
BACKWARD “<<” BUTTON is pressed and held, it will search the track
with audible high speed forward or backward playback.
Program Mode
1. During the CD stop mode, press the PROGRAM BUTTON once. The
PROGRAM LED INDICATOR will light up and blink continuously while the
LED DISPLAY will show the number of Program to be memorized starts
from first program “01” and blink continuously as well. Press the CD SKIP
FORWARD “>>” or CD SKIP BACKWARD “<<” BUTTON to your desired
musical track, the CD LED DISPLAY will show the appropriate track
number. Press the PROGRAM BUTTON to store the desired track in
memory.
2. Repeat above procedure until all desired tracks have been programmed.
A total of 20 tracks can be stored in memory. After complete
programming, LED DISPLAY will show “01” again and flash continuously.
3. To start the PROGRAMMED playback, press the CD PLAY/PAUSE BUTTON
once.
4. To check the program you have stored after complete programming,
press PROGRAM BUTTON once.
Note: While PROGRAM LED INDICATOR is lighted up and flashing, never
press the CD STOP BUTTON otherwise all programmed memory
will be cancelled automatically.
5. To cancel the PROGRAMMED play mode, simply open the CD DOOR or
press the CD STOP BUTTON once.
STEREO HEADPHONE JACK (PHONES/EARPHONES NOT INCLUDED)
For private listening, insert the plug of a stereo headphone into the STEREO
HEADPHONE JACK and adjust the VOLUME CONTROL KNOB accordingly.
During the use of a headphone the Speakers are automatically disconnected.
English -
5
WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THE APPLIANCE TO
RAIN OR MOISTURE. DO NOT REMOVE COVER; PILOT LAMPS SOLDERED IN
PLACE. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
Instructions on environment protection
Do not dispose of this product in the usual household garbage at
the end of its lifecycle; hand it over at a collection point for the
recycling of electrical and electronic appliances. The symbol on
the product, the instructions for use or the packing will inform
about the methods for disposal.
The materials are recyclable as mentioned in this marking. By
recycling, material recycling or other forms of re-utilization of old
appliance, you are making an important contribution to protect our
environment.
Please inquire at the community administration for the authorized disposal
location.
Table des matières
Autres manuels Denver Système stéréo portable
Denver
Denver TC-21 Manuel utilisateur
Denver
Denver TCD-57 Manuel utilisateur
Denver
Denver TDC-250 Manuel utilisateur
Denver
Denver TCD-34 Manuel utilisateur
Denver
Denver TCD-54 Manuel utilisateur
Denver
Denver TC-17C Manuel utilisateur
Denver
Denver TCU-211 Manuel utilisateur
Denver
Denver TCD-47 Manuel utilisateur
Denver
Denver TC-13C Manuel utilisateur
Denver
Denver TCM-220 Manuel utilisateur
Denver
Denver TCP-39 Manuel utilisateur
Denver
Denver TC-19C Manuel utilisateur
Denver
Denver TC-25 Manuel utilisateur
Denver
Denver TCD-29 Manuel utilisateur
Denver
Denver TC-28 Manuel utilisateur
Denver
Denver TCP-38 MK2 Manuel utilisateur
Denver
Denver TDA-60 Manuel utilisateur
Denver
Denver TCD-31 Manuel utilisateur
Denver
Denver TCP-34 Manuel utilisateur
Denver
Denver TC-28 Manuel utilisateur
