PIPE(TUBE) CUTTER Of Best Technology
4 www.s-cutter.co.kr
12
Focus on the job.
Please note the fall, and cut piping pinch.
13
Manage the product carefully.
keep the product clean and efficient for safe operation.
Manage with the proper lubricant, apply a corrosion inhibitor to prevent corrosion when
not in use for a long time.
When replacing the management regulations and tools, comply with the instructions.
Check plugs and wires regularly and contact experts to repair the damage.
Check connection cables regularly and replace damaged parts.
Keep the control board dry and avoid getting oil or grease.
14
Remove power.
When not in use, checked, or replaced, turn off the switch.
(Press the emergency stop switch before work.)
15
Please check before operation.
Make sure that the tool(blade) has been tightened, blade direction and the direction of
rotation.
Make sure that the piping is tightened.
Make sure the piping direction of rotation. (Check reverse rotation switch Forward(CW))
Make sure that the cutting, beveling speed and rotational speed.
16
Be careful of operating the machine accidently.
Do not carry when the power is connected.
When turning on, make sure that the operation switch is off.
17
Connecting wires outdoor
The wiring is licensed for the purpose of using the corresponding display.
18
Be cautious all the time.
Observe work process and process accordingly.
Do not use this product if the concentration is blurred,
Do not operate by force the cutting speed and rotational speed.
19
Make sure that there is no damage on the product.
Make sure that safety devices or slightly damaged parts operate perfectly before reuse.
Make sure that the product is not stuck or damaged.
The perfect operation is guaranteed only if all the parts are perfectly assembled and
adjusted.
Damaged safety devices or parts must be replaced or repaired in customer service
center unless it was mentioned differently.
20
Caution!
For your safety, use the parts and tools indicated on the manual or recommended by the
manufacturer.
Use of other parts or additional tools that are not recommended on the manual and
catalog may occur accidents.
21
Repair request to the experts
The product supplied is matched to the corresponding safety regulations.
The repairs should be referred to a qualified technician and if not, there is a risk of
accidents.
