DCS CMOSTK27 Manuel utilisateur
MODELS CMOSTK27 AND CMOSTK30
CONVECTION MICROWAVE TRIM KIT
PARTS INCLUDED:
Part Name Quantity Part Name Quantity
Trim Assembly 1 Strike & Catch Male 4
Base 1 Strike & Catch Female 4
Rear Duct 1 Mounting Bracket (L/R) 2
Forward Duct 1 Sheet Metal Screws 14
Tape Foam 2
BEFORE INSTALLING TRIM KIT, INSTALL THE CONVECTION DUCT (refer to diagram on following page):
1. Insert the rear section of the duct into the forward section of the duct and install 4 screws supplied.
2. Install foam tape on 2 edges of the rear section of the duct.
3. Remove and retain the 2 top screws located at the rear vertical edges of the Microwave.
4. Place the duct on top of the Microwave and reinsert the 2 screws removed in Step 3.
INSTALLING TRIM KIT
1. Cut opening in the cabinet face per the following dimensions:
AHeight: 19-3/16” + 1/16”,–0
BWidth: 25-3/4” + 1/16”,–0
Refer to diagram on the following page. The minimum cabinet depth is 20”.When installing the
Microwave and Trim Kit in combination with a Wall Oven or Warming Drawer, please follow the
recommendations in the Microwave Installation/Use & Care Manual.
2. Add adequate support in the bottom of the cabinet for trim kit base to rest on.
3. Mark a centerline on the front edge of the cabinet bottom.
4. Place trim kit base and align centerline mark to the triangular notch on the front edge of the base.
5. Drill 1/8” pilot holes and install screws through the base into the cabinet to prevent the base from
shifting.
6. Insert Microwave into opening on top of the base. The Microwave feet should sit in recesses on the
base for correct alignment.
5800 Skylab Road, Huntington Beach, CA 92647
Tel: 714.372.7000 • Fax: 714.372.7001
Customer Service: 888.281.5698
www.dcsappliances.com P/N 11394-01 Rev. A 03/04
7. Install the mounting bracket supports by resting the bottom
edges of the supports on the bottom of the cutout.The long
flange on the side supports should clear the side of the
cutout by approx. 1/16”.(see Fig 01.) Install top screws into
the cabinet face by first drilling 1/8” pilot holes.
(See Inserts 3 and 4.)
8. Install trim kit face by inserting top pins of trim into corre-
sponding sockets on the top corners of clip support plates
(See Insert 1 ).
9. Finish the assembly by inserting the bottom pins into the corre-
sponding sockets on front edge of the base (See Insert 3).
TRIM KIT
ASSEMBLY
MOUNTING
BRACKET
SUPPORT
FORWARD
CONVECTION
DUCT
REAR
CONVECTION
DUCT CABINET
BASE
CENTERING
NOTCH
LOCATE MOUNTING BRACKET
IN BOTTOM CORNERS
OF CUTOUT
VERTICAL
CLIP
ORIENTATION
ON MOUNTING
BKT.
HORIZONTAL
CLIP ORIENTATION
ON BASE
TOP PIN
OF TRIM
BOTTOM PIN OF TRIM
SCREW HOLE
FLANGE
1/8" HOLE FOR
MOUNTING
SCREW
CENTER
LINE
B
A
SCREW HOLE
FOAM TAPE ON
THIS FLANGE
FOAM TAPE ON
THIS FLANGE
INSERT 1
INSERT 2
INSERT 3
INSERT 4
1/16"
Fig. 01
Ce manuel convient aux modèles suivants
1
Autres manuels DCS Enceinte
