Danfoss LinkFT Manuel utilisateur

Danfoss Link™ FT

Floor Thermostat

Installation Guide

electricheating.danfoss.com

Installation Guide2

1 Introduction � � � � � � � � � � � � � � � � � � � � � 2

2 Placement of Danfoss Link™ FT � � � � � � � � � 4

2.1 Operation mode . . . . . . . . . . . . . . . . 4

2.2 Sensor combination. . . . . . . . . . . . . . 4

3 Installation � � � � � � � � � � � � � � � � � � � � � � 6

3.1 Conguration . . . . . . . . . . . . . . . . . . 7

4 Factory reset � � � � � � � � � � � � � � � � � � � � � 7

5 Technical specications � � � � � � � � � � � � � � 7

6 Warranty� � � � � � � � � � � � � � � � � � � � � � � � 9

7 Disposal instructions� � � � � � � � � � � � � � � � 9

1 Introduction

The Danfoss Link™ FT (Floor Thermostat) is a device for

switching the heating element ON/OFF.

In connection with a oor sensor it can also measure the

temperature in the oor (FTS).

Secondly you have the possibility to use the Danfoss Link™

FT as a on and o switch to other equipments manually or

by schedule.

Danfoss Link™ FT

Table of Contents

3Installation Guide

Installation scenario: Danfoss Link™ CC

Danfoss Link™ RS

Danfoss Link™ FT

ON/OFF

safety switch

LED

Push and hold

for 5 sec. to

install/connect

Danfoss Link™ FT

Installation Guide4

2 Placement of Danfoss Link™ FT

Installation and placement must be according to local

building regulations.

2�1 Operation mode

Danfoss Link™ FT supports two types of operation modes.

1. Heating regulation

1. On/OFF switching

When used in heating regulation mode you have to con-

sider the following advices for controlling the heating.

When used as simple ON/OFF mode do not connect oor

sensor.

2�2 Sensor combination

When installing the Danfoss Link™ FT you need to consider

the type of heating and thus which sensors should be used.

There are three options:

Danfoss Link™ FT

5Installation Guide

1. Comfort heating: Constant temperature on the oor

in bathrooms and other rooms where a comfortable

warm surface is required. Install the Floor sensor and

choose Floor regulation for the room when doing the

conguration.

2. Total heating: Control of room temperature in living

rooms etc. Install the oor sensor and a Danfoss Link™

RS. Choose Combined regulation when doing the

conguration on the Danfoss Link™ CC.

3. No oor sensor: A oor sensor is not present, and

cannot be installed. You must install a Danfoss Link™

RS. Choose Room regulation.

Be aware that temperature control is less accurate without

the oor sensor and that all Danfoss Link™ FTs in a room

need to have the same sensor conguration.

Danfoss recommends always installing a oor sensor.

Do not install oor heating system without a oor sensor

when the heating element is installed on or beneath wooden

surfaces and other surfaces sensitive to temperature!

Danfoss Link™ FT

Installation Guide6

3 Installation

1. To remove the front cover, gently press the release

tabs under the bottom of the thermostat with a screw-

driver. Then remove the front.

2. Connect the thermostat according to the connection

diagram.

DFT01

Sensor

N L NTC

LOAD

(Optional)

Mains 220-240V

50-60 Hz

Max. Load

15 (1) A

IP31

-10T30

Danfoss Link™ FT

7Installation Guide

3�1 Conguration

See Step-by-Step guide in Danfoss Link™ CC instruction

manual.

Green LED ON Standby

Red LED ON Heating

Green LED fast ash Inclusion or link test

Red LED short ash Inclusion not OK, goes to not

included.

Linktest not OK, goes to

missing link

RED LED slow ash Sensor failure

4 Factory reset

Turn o power on the safety switch on the front. Hold the

install button in while pushing ON the safety switch and

keep the install button pressed until the LED gives a red

ash (approx. 5 sec.)

5 Technical specications

Operation voltage 220-240 V~ 50/60 Hz~

Standby power

consumption Max. 1 W

Danfoss Link™ FT

Installation Guide8

Relay:

• Resistive load

• Inductive load

230 V ~ 15 A / 3450 W

cos ϕ= 0.3 Max. 1 A

Sensing unit NTC 15 kOhm at 25°C

Sensing values:

• 0°C

• 20°C

• 50°C

42 kOhm

18 kOhm

6 kOhm

Regulation PWM

Ambient temperature -10° to +30°C

Sensor failure

monitoring

The thermostat has a built-

in monitoring circuit, which

will switch o the heating if

the sensor is disconnected

or short-circuited

Transmission frequency 868.42 MHz

Transmission range in

normal buildings Up to 30 m

Transmission power Max. 1 mW

IP class 31

Dimensions 85 mm × 85 mm × 21 mm

Danfoss Link™ FT

9Installation Guide

6 Warranty

7 Disposal instructions

Danfoss Link™ FT

Installation Guide10

Danfoss Link™ FT

Table des matières

Autres manuels Danfoss Thermostat

Danfoss

Danfoss HC75-3 Manuel d'utilisation

Danfoss

Danfoss ECL Comfort 210 Manuel utilisateur

Danfoss

Danfoss RET MD Guide de dépannage

Danfoss

Danfoss DEVIreg Smart Manuel utilisateur

Danfoss

Danfoss RET B + RF Mode d'emploi

Danfoss

Danfoss RET-B Manuel utilisateur

Danfoss

Danfoss SET3M Instructions de montage

Danfoss

Danfoss ECtemp 532 Manuel utilisateur

Danfoss

Danfoss RT51 Manuel utilisateur

Danfoss

Danfoss FMT230D Mode d'emploi

Danfoss

Danfoss ECL Comfort 210 Manuel utilisateur

Danfoss

Danfoss RTW-RA Manuel utilisateur

Danfoss

Danfoss Link DBR Manuel utilisateur

Danfoss

Danfoss RMT-24 Manuel utilisateur

Danfoss

Danfoss TS715Si Manuel utilisateur

Danfoss

Danfoss living connect Z Manuel utilisateur

Danfoss

Danfoss RT1-RF Manuel utilisateur

Danfoss

Danfoss GreenCon RC-T2 Manuel utilisateur

Danfoss

Danfoss DEVI DEVIreg Opti Manuel utilisateur

Danfoss

Danfoss TP5000 si range Manuel utilisateur

Danfoss

Danfoss TP75 Manuel utilisateur

Danfoss

Danfoss KP 61 Manuel utilisateur

Danfoss

Danfoss RET2000B-RF Manuel utilisateur

Danfoss

Danfoss RT 106 Manuel utilisateur

Manuels Thermostat populaires d'autres marques

EWELLY

EWELLY EW-181 Manuel utilisateur

Prolon

Prolon T1100 Instructions d'installation

Computherm

Computherm Q20 Manuel utilisateur

Heatmiser

Heatmiser neoStat Manuel utilisateur

Aube Technologies

Aube Technologies TH111GFCI-NP 240 VCA Manuel utilisateur

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Manuel utilisateur

Saswell

Saswell SAS920XWHB-7-S-RF Mode d’emploi

Aircalo

Aircalo TFP1-ET85P2 Manuel utilisateur

Honeywell

Honeywell CM721 Manuel utilisateur

Carrier

Carrier DEBONAIR 33CS Manuel utilisateur

Lennox

Lennox iHarmony Zone Thermostat Instructions de montage

Gemtech

Gemtech GT7000 Mode d’emploi

Rollei

Rollei Smartes 45000 Manuel utilisateur

Sinope

Sinope TH1300RF Manuel utilisateur

Honeywell

Honeywell RLV4305 Manuel utilisateur

Honeywell

Honeywell Prestige 2.0 THX9421 Manuel utilisateur

NuTone

NuTone NTBZ48 Instructions d'utilisation d'origine

Stelpro

Stelpro MAESTRO ASMT402AD Manuel utilisateur