Dancover 2m Series Manuel utilisateur
for
Storage Tent
3m Series PVC
Manual
22-01-2020
Safety Advice
Attention
In some countries approval is needed to set up a tent larger than 75 m2. It is your responsibility
to comply with local rules and regulations and to ensure that the tent is assembled correctly.
In case of bad weather conditions, it is your responsibility to ensure the tent is safely secured
and that the tent does not cause damage to others.
Do not use open re, welding equipment or other sources which can ignite, inside or close to the
tent.
The tent must be safely secured. We recommend you secure your tent with straps and pegs as
soon as it is assembled.
Make sure to check if the tent is covered by your home contents insurance.
Tents must be evacuated under extreme weather conditions.
In the event of snow, always remove snow from the roof of the tent regularly to prevent snow
from building on the roof, as heavy snow can cause the tent to collapse.
In the event of rain, there is a risk of rain puddles building up on top of the roof of the tent.
Heavy rain puddles can cause the roof to collapse. It is your responsibility to ensure rain
puddles do not build up. As a precaution, make sure the roof of the tent is stretched out
properly and adequately over the side frames of the tent and remove rain water regularly.
Do not unpack or repack your tent in freezing temperatures. In case of temperatures below
zero, always unpack and repack your tent indoors to avoid the risk of cracking parts.
The tent must be totally dry before you repack and store it to avoid mildew.
Note: Dancover warranty applies only to the normal use of the Product, normal wear and tear
excepted, in accordance with written use instructions or manual. The warranty does not apply
to damage caused by accident, abuse, misuse, or modification of the Product.
Warranty Information
Please visit dancovershop.com for information on warranty.
Please always check our website for the latest safety advice and manual.
Warning
1.
In order to avoid being rusted by air, oil is covered on the surface of the
pipes, before set up
the tent, please remove the oil carefully frist to keep the
cover clean.
2. Take note that the tent needs to be handled care fully to avoid damage.
3. Do not force the frame as they may be damage in the process.
4. Tents are meant as temporary shelter and must be e
vacuated under
extreme weather conditions.
Please select a suitable site for the tent to avoid the damage to underground
sprinkler systems, water, gas or electrical lines.
3m Storage tent manual
Part
No. 3x6m 3x8m
1
Middle leg
1880mm
Ø50
4 6
2
Frame pole
1880mm
Ø38
11 16
3-1
Frame pole
1880mm
Ø38
2 2
3-2
Frame pole
1880mm
Ø38
2 2
4
Frame pole
1455mm
Ø50
8 10
5Groundbar
pipe 4 4
6
Diagonal
support
1158mm
Ø25
4 4
7
Roof
support
1652mm
Ø25
4 5
8
Corner leg
1880mm
Ø50
4 4
91965mm
Ø38
Male doorbar
2 2
11 1140mm
Ø50
Pillar
1140mm
Ø50
Pillar
4 4
4 4
13
12
1070mm
Ø25
Ceiling rail
2 2
22-01-2020
14 2 2
15-1 3-way connector
54-42mm (A) 6 6
15-2 4-way connector
54-42mm (B) 6 9
16 3-way connector
for corner 2 2
17 3-way connector
for corner 2 2
18 3-way connector
for sidewall 8 10
23 Strengthen bar 6 8
24 Bracket 12 14
25 Groundbracket 6 8
26 Peg 400mm 12 16
27 Spiral peg 4 4
28 Long peg 12 14
29 Small peg 32 36
30 Bungeeball long 44 44
31 Rope 4 4
Part
No. 3x6m 3x8m
Ceiling rail
1070mm
Ø25
3m Storage tent manual
22-01-2020
32 Screw M6x30 14 16
35 M6 wingnut 14 16
37 Screw M8x50mm 50 60
38 Screw M8x60mm 48 56
39 M8 nut 98 116
40 Spanner 1 1
41 Steel tension bar 12 16
42 Turnbuckle 6 8
43 Tie down 4 4
44 Steel clip 20 24
45 Roof 1 1
46 Endwall 2 2
Part
No. 3x6m 3x8m
3m Storage tent manual
22-01-2020
3x6 3x8 3x6 3x8 3x6 3x8 3x6 3x8 3x6 3x8
Used for Part 4 and Part 7 8 10
Used for Part 13 and Part 14 2 2
Used for Part 12 and Part 13 2 2
Used for Part 12 and Part 14 2 2
Used for Part 3-1 and Part 6 2 2
Used for Part 3-2 and Part 6 2 2
Used for Part 6 and Part 8 4 4
Used for Part 11 and Part 12 4 4
Used for 3-way connector A 6 6 12 12
Used for 4-way connector B 12 18 12 18
Used for 3-way connector 16 4 4 2 2
Used for 3-way connector 17 4 4 2 2
Used for 3-way connector 18 16 20 8 10
Used for M6x30 14 16
Used for M8x50 46 56
Used for M8x65 44 52
14 16 14 16 46 56 44 52 90 108
M6x30
Screw
M6
Wing nut
M8x50
Screw (Ø42)
M8x60
Screw (Ø54)
M8
Nut
3m storage pro
Part 32
Part 35
Part 37
Part 38
Part 39
22-01-2020
A
A
A
AA
B
B
B
A
A
A
A
A
B
B
B
B
B
B
VI
Spread the wall panel and door panel attach to framework by using the bangee cords clasping the frame to grommets
that is construct over the wall panel and door panel to ensure stability. Also use the short pegs to x the doors to the
ground.
Autres manuels pour 2m Series
3
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels Dancover Tente
Dancover
Dancover GH18001 Manuel utilisateur
Dancover
Dancover Pagoda Tent EventZone Manuel utilisateur
Dancover
Dancover PE Series Manuel utilisateur
Dancover
Dancover Titanium Manuel utilisateur
Dancover
Dancover Tentzing Explorer Series Manuel utilisateur
Dancover
Dancover Pagoda Marquee UNICO 7x7m Manuel utilisateur
Dancover
Dancover Multipavillon 6x9m Manuel utilisateur
Dancover
Dancover PRO XL Manuel utilisateur
Dancover
Dancover Crestline 2L Manuel utilisateur
Dancover
Dancover TentZing CT168300 Manuel utilisateur
Dancover
Dancover Teepee Manuel utilisateur
Dancover
Dancover CombiTent SEMI PRO 6m Series Manuel utilisateur
Dancover
Dancover Garage tent 3,77x7,3x3,24m PVC Manuel utilisateur
Dancover
Dancover 3m storage pro Manuel utilisateur
Dancover
Dancover Semi PRO 4x8m Manuel utilisateur
Dancover
Dancover 5.4m Series Manuel utilisateur
Dancover
Dancover PRO XL Manuel utilisateur
Dancover
Dancover Multipavillon 6x6m Manuel utilisateur
Dancover
Dancover AC153200 Manuel utilisateur
Dancover
Dancover PRO EventZone 9m Series Manuel utilisateur
