Dancing Wings Hobby Night Devil Manuel utilisateur

Suggested Equipment

Motor: 2216 900-1100KV

ESC: 20A

Propeller: 9-10 inch

Servos: 9g*4

Battery: 3s 2200-2600mAh

Radio≥4CH

Speci�ication

Wingspan: 1000mm

Length: 820mm

Flying Weight≈730g

Accessories include

Power System（Optional）

Preparation Tool

A：wood sheets B1：steel wire pushrod

B2：cabon sheets C1：front landing gear

C2：middle landing gear D1-7：EPP sheets

E：screws,EZ-Connector,servo horn

F1：wireless remote switch (optional)

F2：JST extension wire G：wood sticks

H：propeller I：rubber band

How to Assemble

1.Paste the wood sheet A3 and A1 onto the D1 by foam

glue,pay attention to aim at the preserved holes and put

in the right direction.(paste the other side of D1 in same

way)

2.Take down the wood sheet A2,A4 and A5,and assem-

ble as picture shown.(Do not glue them now)

3.Paste together the ﬁnished D1 and components from

step 2,pay attention to the direction of wood sheets A4

and A2.Adjust and paste by glue 502.

Night Devil Instruction Manual

EPP Airplane

C2 I

D1 D2

A5X2

A2X2

fuselage head direction

pay attention to the gap direction

alignment hole

4.Assemble the motor and front landing gear onto the

A2 (as picture shown below),ﬁx the motor with screws,-

ﬁx the landing gear with screws and nuts,connect the

landing gear arm with steel wire pushrod,which insert

through the preserved hole on A4,and ﬁnally connect

with the servo.

6.Paste the D5 at the bottom of the fuselage by foam

glue,and pull the JST connector out of the wood sheets.

7.Assemble the landing gear as per the bottom preserved

hole,and ﬁx with screws.

8.Assemble the tail reinforcement,and paste with glue

502.

9.Paste the tail reinforcement at the tail of the fuselage

by foam glue,and pull the JST connector out of the hole.

5.Paste the A6 onto the A5 by glue 502,and assemble the

nuts in the preserved holes on the back side of the A5.

Night Devil Instruction Manual

EPP Airplane

upward

pay attention to the

gap direction nut

A9-1

A10

A11

steel wire push rod

nuts

insert

Wheel stopper A7

10.Paste the vertical and horizontal tail D3 (as picture

shown below)

11.Connect the both JST plug together respectively

from tail wing and fuselage tail.

12.Paste the D7 in the middle of the fuselage,insert the

push rod through the guiding tube,pull the tube through

the D7 hole till fuselage tail;The right push rod comes

out from the right side board and the Z-shape end face

the tail.

13.Paste the A8 onto the D4,take care to aim the

preserved hole,paste the D4 and tail wing onto the tail of

the fuselage by foam glue;The left push rod comes out

from the upper hole of the D4(as picture shown).

Night Devil Instruction Manual

EPP Airplane

right push rod comes out

left push rod comes out

14.Paste the D2 onto the head of the fuselage by foam

glue,insert the wood sticks through the preserved hole

of the cabin.

15.Install the servo inside the cabin,install the servo arm

and EZ-connector,and connect the EZ-connector with

push rod.

16.Install the horn on the horizontal and vertical

tail,connect the servo horn with Z-shape push rod.

17.Paste together the wing D6,insert the carbon sheet in

the preserved slot and ﬁx by foam glue.

18.Install the servo arm,paste the servo into the

preserved holes on the back of the wing by foam

glue,and insert the servo wires into the slot.

19.Install the servo horn onto the aileron,install the

EZ-connector onto the servo arm,plug the Z-shape push

rod into the servo horn,the other end connect with

EZ-connector.

wood sticks

alignment hole A8

Steering Wheel push rod

Steering Rudder

push rod

Elevator push rod

Embed the fortified carbon plate,

reinforce it with glue.

glue

22.Fasten the wing with rubber band onto the fuselage.

Adjust the C.G, C.G is 66mm from the leading

edge.Then start your flight.

C.G

≈66mm

Night Devil Instruction Manual

EPP Airplane

20.Install and ﬁx the propeller onto the motor.

21.Connection diagram for remote switch,electronics and LED plugs.

*connection diagram for remote switch

This is the battery cabin at the bottom of the

fuselage,you need to bind the battery by ribbon.

Set the remote switch signal on the

second gear of any driving lever,move

the driving lever could turn on or oﬀ the

switch;Once connected,you could turn

on or oﬀ the LED lights during ﬂight.

F 2（ JST extension wire）

JST plug for

connecting the wing.

connect with LED JST connector

connect with remote

switch JST connector

connect the remote

switch power supply

(12V) with battery

F1(remote switch)

remote switch

3S Battery

ESC

JST connector

balancing

connector LED strips

Rx.

Table des matières

Autres manuels Dancing Wings Hobby Jouet

Dancing Wings Hobby

Dancing Wings Hobby GEEBEE Manuel utilisateur

Dancing Wings Hobby

Dancing Wings Hobby TCG16 Manuel utilisateur

Dancing Wings Hobby

Dancing Wings Hobby T20 Sport Scale Cessna 152 Manuel utilisateur

Dancing Wings Hobby

Dancing Wings Hobby 1.58M 1:6 Fokker-E Manuel utilisateur

Dancing Wings Hobby

Dancing Wings Hobby Tiger Moth DH82 2.15M Manuel utilisateur

Dancing Wings Hobby

Dancing Wings Hobby T09 AeroMax Manuel utilisateur

Dancing Wings Hobby

Dancing Wings Hobby TCG 14 Manuel utilisateur

Dancing Wings Hobby

Dancing Wings Hobby T40 Manuel de programmation

Dancing Wings Hobby

Dancing Wings Hobby CESSNA150 Manuel utilisateur

Dancing Wings Hobby

Dancing Wings Hobby Stearman PT-17 Manuel utilisateur

Dancing Wings Hobby

Dancing Wings Hobby XCG02 Manuel utilisateur

Dancing Wings Hobby

Dancing Wings Hobby K13 Beechcraft T-34 Mentor Manuel utilisateur

Dancing Wings Hobby

Dancing Wings Hobby Albatross D.III Manuel utilisateur

Dancing Wings Hobby

Dancing Wings Hobby 1.6M Fieseler Fi 156 Storch V2.0 Manuel utilisateur

Dancing Wings Hobby

Dancing Wings Hobby Sbach 342 Manuel utilisateur

Dancing Wings Hobby

Dancing Wings Hobby SCG30 Manuel utilisateur

Dancing Wings Hobby

Dancing Wings Hobby VX-08 Manuel utilisateur

Dancing Wings Hobby

Dancing Wings Hobby S21 Fieseler Fi 156 Storch V2.0 Manuel utilisateur

Dancing Wings Hobby

Dancing Wings Hobby STICK-06 Manuel utilisateur

Dancing Wings Hobby

Dancing Wings Hobby 0.8 Tiger Moth Manuel utilisateur

Dancing Wings Hobby

Dancing Wings Hobby Tiger Moth V2.0 Manuel utilisateur

Dancing Wings Hobby

Dancing Wings Hobby S20 1.2M Fokker-E Manuel utilisateur

Dancing Wings Hobby

Dancing Wings Hobby 1.8M 1:5 Savage Bobber Manuel utilisateur

Dancing Wings Hobby

Dancing Wings Hobby SCG38 Manuel utilisateur

Manuels Jouet populaires d'autres marques

marklin

marklin 37321 Manuel utilisateur

Canon

Canon PAPER CRAFT Manuel utilisateur

GREAT PLANES

GREAT PLANES Pitts M-12S Manuel utilisateur

NOCH

NOCH 14261 Manuel utilisateur

Hausler

Hausler 450 SE V2 Manuel utilisateur

Dynaflite

Dynaflite Daydream Manuel utilisateur

MiniacRC

MiniacRC MIGHTY MINI P40 WARHAWK Manuel

Kenner

Kenner Batman 63651 Manuel utilisateur

LEGO

LEGO 8527 Manuel utilisateur

iKarus

iKarus ECO 8 Manuel utilisateur

Multiplex

Multiplex EasyStar II Mode d’emploi

Walkera

Walkera 38 Mode d’emploi

Hasbro

Hasbro TRANSFORMERS BUMBLEBEE Manuel utilisateur

MD MXION SWD Manuel utilisateur

Mattel

Mattel Disney Pixar Cars Cozy Cone Spiral Rampway Manuel utilisateur

marklin

marklin 39671 Manuel utilisateur

Meccano

Meccano 15103 Manuel utilisateur

LEGO

LEGO TECHNIC 8735 Manuel utilisateur