D-Link DWL-3140AP - Web Smart PoE Thin Access Point Manuel utilisateur
Quick Install Guide
DWL-3140AP
Wireless 108G Web Smart Thin AP with PoE
2D-Link DWL-3140AP Hardware Installation Guide
System Requirements
Package Contents
• Access Point
• CD
• Ethernet Cable
• 5V 1.2A Power Adapter
• Mounting Bracket
• Mounting Kit
• A Network with a D-Link DES-1228P Wireless
Switch
This access point can only be used with a D-Link DES-1228P
wireless switch. Please refer to the xStack user manual for
conguration of the access point.
3 D-Link DWL-3140AP Hardware Installation Guide
Installation Considerations
D-Link wireless devices allow you access your network using a wireless connection
from virtually anywhere within the operating range of your wireless network. Keep
in mind, however, that the number, thickness and location of walls, ceilings, or
other objects that the wireless signals must pass through, may limit the range.
Typical ranges vary depending on the types of materials and background RF (radio
frequency) noise in your home or business. The key to maximizing wireless range
is to follow these basic guidelines:
1. Keep the number of walls and ceilings between the D-Link access point
and other network devices to a minimum - each wall or ceiling can reduce
your adapter’s range from 3-90 feet (1-30 meters.) Position your devices
so that the number of walls or ceilings is minimized.
2. Be aware of the direct line between network devices. A wall that is 1.5
feet thick (.5 meters), at a 45-degree angle appears to be almost 3 feet (1
meter) thick. At a 2-degree angle it looks over 42 feet (14 meters) thick!
Position devices so that the signal will travel straight through a wall or
ceiling (instead of at an angle) for better reception.
3. Building Materials make a difference. A solid metal door or aluminum
studs may have a negative effect on range. Try to position access points,
wireless routers, and computers so that the signal passes through drywall
or open doorways. Materials and objects such as glass, steel, metal, walls
with insulation, water (sh tanks), mirrors, le cabinets, brick, and concrete
will degrade your wireless signal.
4. Keep your product away (at least 3-6 feet or 1-2 meters) from electrical
devices or appliances that generate RF noise.
5. If you are using 2.4GHz cordless phones or X-10 (wireless products such as
ceiling fans, lights, and home security systems), your wireless connection
may degrade dramatically or drop completely. Make sure your 2.4GHz
phone base is as far away from your wireless devices as possible. The
base transmits a signal even if the phone is not in use.
4D-Link DWL-3140AP Hardware Installation Guide
Please read the following before you begin:
1. Do not operate the DWL-3140AP access point near unshielded
blasting caps or in an otherwise explosive environment unless the
device has been modied for such use by qualied personnel.
2. Do not touch or move the DWL-3140AP access point when the
antennas are transmitting or receiving.
3. Do not hold any radio device so that the antenna is very close to
or touching the face, eyes, or other exposed body part while the
device’s radio antenna is transmitting.
4. Before using a wireless device in a hazardous location, consult
the local codes, national codes, and safety directors of the
location for usage constraints.
5. Do not connect or disconnect cables or otherwise work with the
DWL-3140AP access point hardware during lightning storms.
6. The DWL-3140AP access point is intended for indoor use only.
Do not install the device outdoors.
7. To reduce the possibility of connection interference caused by
dust, clean the CAT 5 connector pins before inserting a cable
into an DWL-3140AP access point.
Before You Begin
5 D-Link DWL-3140AP Hardware Installation Guide
Front Panel
Rear Panel
Power Receptor
Receptor for the supplied power
adapter.
6D-Link DWL-3140AP Hardware Installation Guide
Rear Panel
Power LED
A solid green light indicates
a proper connection to the
power supply.
Ethernet Port
Connects the DWL-3140AP
to the DES-1228P switch
using an Ethernet cable.
LAN LED
A solid green light indicates
a connection to the Ethernet
port. This LED blinks during
data transmission.
Reset
Press the reset button to
restore the access point to
its original factory default
settings.
WLAN LED
A solid green light indicates a
wireless connection is ready.
This LED blinks during data
transmission.
7 D-Link DWL-3140AP Hardware Installation Guide
Mounting Options
You can mount a DWL-3140AP access point on any of the following
types of surfaces:
• Solid surface wall or ceiling
• Tabletop
Cable Requirement
The Ethernet ports on the DWL-3140AP access point cannot accept
a CAT 5 cable that has an uneven sheath. The RJ-45 connector on
the cable will not seat properly in the receptacle on the access point.
Use a CAT 5 cable with an even sheath instead.
Wall Installation Recommendations
If you plan to install an AP on a partial wall or other vertical surface,
orient the top of the access point (the side with the D-Link Logo)
toward the intended coverage area. The radio antennas transmit
through the top of the access point but not through the bottom
(where the bracket is).
DES-1228P Wireless Switch Recommendations
D-Link recommends that you install and congure the DES-1228P
wireless switch before installing an access point. If the switch is
already installed and congured for the access point(s), you can
immediately verify the cable connection(s) when you plug the
cable(s) into the access point.
Warning: The DWL-3140AP is designed to receive power only from
an 802.3af-compliant source, a D-Link DES-1228P wireless switch,
or a D-Link-approved power injector. Connecting an access point to
a Power over Ethernet (PoE) device that is not approved by D-Link
can damage the equipment.
8D-Link DWL-3140AP Hardware Installation Guide
Solid Wall or Ceiling Installation
1. Remove the mounting bracket from the DWL-3140AP.
2. Attach the bracket to the wall or ceiling.
3. Mark the points where you will use screws. Take out the bracket.
4. Drill the marked points and insert the plastic wall mount.
5. Let the power and CAT5 cable slide through the mounting
bracket.
6. Use the supplied screws to attach the bracket.
7. Plug the power cable into the access point.
9 D-Link DWL-3140AP Hardware Installation Guide
8. Plug the CAT 5 cable into the access point.
9. Attach the access point to the mounting bracket.
10. Gently pull the power cable and the ethernet cable as you slide
up to lock the access point onto the bracket.
Technical Support
You can nd software updates and user documentation on the D-Link website.
Tech Support for customers in
Australia:
Tel: 1300-766-868
24/7(24Hrs, 7days a week) technical support
http://www.dlink.com.au
e-mail: [email protected]
India:
Tel: 1800-222-002
9.00 AM to 9.00 PM. All days
http://www.dlink.co.in/support/productsupport.aspx
Indonesia, Malaysia, Singapore and Thailand:
Tel: +62-21-5731610 (Indonesia)
Tel: 1800-882-880 (Malaysia)
Tel: +65 6501 4200 (Singapore)
Tel: +66-2-719-8978/9 (Thailand)
24/7, for English Support Only
http://www.dlink.com.sg/support/
e-mail: [email protected]
Korea:
Tel: +82-2-2028-1815
Monday to Friday 9:00am to 6:00pm
http://www.d-link.co.kr
e-mail: [email protected]
New Zealand:
Tel: 0800-900-900
24/7(24Hrs, 7days a week) technical support
http://www.dlink.co.nz
e-mail: [email protected]
Autres manuels pour DWL-3140AP - Web Smart PoE Thin Access Point
2
Table des matières
Langues :
Autres manuels D-Link Point d'accès sans fil
D-Link
D-Link UNIFIED WIRED & WIRELESS ACCESS SYSTEM... Guide de référence rapide
D-Link
D-Link DWL-3500AP Manuel utilisateur
D-Link
D-Link DAP-1160 Manuel utilisateur
D-Link
D-Link DAP-3220 Manuel utilisateur
D-Link
D-Link DAP-1533 Manuel utilisateur
D-Link
D-Link DAP-1160 Manuel utilisateur
D-Link
D-Link DWL-8220AP - AirPremier Wireless Switch Dualband Access... Manuel utilisateur
D-Link
D-Link DAP-2590 - AirPremier N Dual Band PoE Access... Manuel utilisateur
D-Link
D-Link DAP-2553 - Wireless N Dual Band Gigabit Access... Manuel utilisateur
D-Link
D-Link DAP-2660 Manuel utilisateur
D-Link
D-Link DWL-2200AP - AirPremier - Wireless Access... Manuel utilisateur
D-Link
D-Link DAP-2553 - Wireless N Dual Band Gigabit Access... Manuel utilisateur
D-Link
D-Link DAP-1533 Manuel utilisateur
D-Link
D-Link AirPremier N DAP-3690 Manuel utilisateur
D-Link
D-Link DWL-3500AP Manuel utilisateur
D-Link
D-Link DAP-1665 Manuel utilisateur
D-Link
D-Link DAP-1155 Manuel utilisateur
D-Link
D-Link DWL-1000AP Manuel utilisateur
D-Link
D-Link DAP-1665 Manuel utilisateur
D-Link
D-Link DAP-1360 Manuel utilisateur
