3
Safe work with the machine is only possible if you read
this operating instruction and the safety instructions
completely and follow the instructions contained strictly.
Additionally, the general safety instructions of the leaflet
supplied with the tool must be observed. Prior to the first
use, the user should absolve a practical training.
If the mains cable gets damaged or cut during the use, do not
touch it, but instantly pull the plug out of the socket. Never use
the tool with damaged mains cable.
When drilling in ceilings or walls make sure you will not cut
through electrical mains, gas or water pipes. Use metal
detection systems if needed.
Prior to the start of your work, consult a statics specialist to
determine the exact drilling position.
If drilling through ceilings, secure the place below, because
the may fall downward.
The tool must neither be wet nor used in humid environment.
Do not use the tool in an environment with danger of explosion.
Do not use the tool standing on a ladder.
Do not drill into asbestos-containing materials.
Do not carry the tool at its cable, and always check the tool, cable and
plug before use. Have damages only repaired by specialists. Insert the
plug into the socket only when the tool switch is off.
Modifications of the tool are prohibited.
The machine should only work under supervision of sbd. Plug and
switch the machine off if it is not under supervision, in case of putting
up and stripping down the machine, in case of voltage drop or when
fixing or mounting an accessory.
Switch the machine off if it stops for whatever reason. You avoid that
it starts suddenly and not under supervision.
Don’t use the machine if a part of the housing is damaged or in case
of damages on the switch, the cable or plug.
Electrical tools have to be inspected visually by a specialist in regular
intervals.
When using the drill, cooling water is not allowed to get into the
motor and all electrical parts.
Overhead-drilling only with suitable safety measures (water
collection).
Safet
Instructions
