0970 0055 DP 500 English, V1.0, 21.05.12 0970 0055 DP 500 English, V1.0, 21.05.12
DP 500 DP 500
The operating instructions must be read in full and carefully ob-
served before starting up the device. The manufacturer cannot be
held liable for any damage which occurs as a result of non-
observance or non-compliance with this manual.
Should the device be tampered with in any manner other than a
procedure which is described and specified in the manual, the war-
ranty is cancelled and the manufacturer is exempt from liability.
CS Instruments is not liable for errors which may have slipped into
this operating manual.
The DP 500 is to be used for measuring the moisture, pressure and
temperature of air and gases.
Do not apply any corrosive gases to the sensor! Any use other than
that described here compromises the safety of persons and the
entire measuring system and is, therefore, not permitted.
The manufacturer is not liable for damage caused by improper or
non-designated use.
Important
information
Area of
application
314
Installation
and operation The measuring device must only be installed, connected, commis-
sioned and maintained by qualified and authorized specialists (e.g.
electrical technicians) in full compliance with the instructions in this
manual, the applicable norms, legal regulations and certificates
(depending on the application).
The measuring device may only be modified or repaired if such work
is permitted in this instruction manual.
In order to achieve and maintain the accuracy stipulated in the tech-
nical data, the sensor must be installed according to the instructions
in this manual.
1. General information
• Do not exceed the pressure range of 1.6 MPa. Please contact
manufacturer for high pressure options.
• Observe permissible storage, transport and operating tempera-
tures.
Notes on
safety
EC Declaration of Conformity
according to the guideline of the Board for Approximation
of Laws of the member states on the
electromagnetic compatibility (89/336/EWG)
Portable dew point meter DP 500 / DP 520
CS Instruments (Asia) as the manufacurer herewith declares that the above
mentioned humidity sensor correspond with the requirements of the following
guideline:
Electromagnetic compatibility (EMV) (89/336/EWG)
The assessment of the instrument was subject to the following
standards:
Emitted interference: EN 61326: 1997 + A1; 1998 + A2: 2001
Interference resistance: EN 61326: 1997 + A1: 1998 + A2: 2001
CS Instruments (Shenzhen) Co., Ltd. Shenzhen, 15.05.2012
The Management
This declaration does not guarantee any product characteristics.
