6. Having tested the shower after all the components have been installed so as to
check whether there are any leaking problems. Transportation and any improper
operation during installation will make the parts loose thus cause leaking. Tightly
screw the leaking part may help to solve any leaking problem.
NOTES
1. When the sunshine is strong, especially in summer, the water inside the tube will
reach a very high temperature, so please do not stand under the solar head
when you use it. Otherwise you will be scalded by the hot water, please turn on
the cold water first then adjust the water temperature by the handle gradually.
2. Do not remove or add any parts, otherwise leaking would be easily caused.
3. Clean the shower head periodically to make sure the water sprays without
resistance.
4. Children are not allowed to use the solar shower alone.
5. Fill up the tube afterthe shower is installed. You should turn the adjusting handle
to the position of hot water, when the shower head has water, the tube is fully
filled
6. When in winter, empty the water in the tube by drainage to avoid freezing inside
the tube. (Warranty is void if this happens, so please winterize properly).
1. For MODEL A TYPE （two section solar shower）, the handle on the top is for hot
water and the handle in the bottom is for the cold water. See picture ⑥
Turn on the cold water first then adjust the water temperature by the handle
gradually.
DRAIN SCREW
