Page 4
Table of Contents
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Mounting and Wiring. . . . . . . . . . . . . . . . . . . . . . . 6
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
Key Functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Backlight Intensity . . . . . . . . . . . . . . . . . . . . . . . . . 8
Setting Low/High Level Alarms . . . . . . . . . . . . . . . 9
Alarms On/Off . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Displaying Pressure . . . . . . . . . . . . . . . . . . . . 10
Selecting Sender Type . . . . . . . . . . . . . . . . . . . . 11
Setting Maximum Tank Capacity . . . . . . . . . . . . . . . . 12
Selecting NMEA 0183 or External Alarm Output . . . . .13
Other CruzPro Products . . . . . . . . . . . . . . . . . . . 16
Specifications
Power supply: 9.5 to 33.0 VDC, .035 amps nom.
Operating temperature: 32 to 122 F ( 0 to 50 C)
Size: 2.5" dia X 4.1" deep (61mm x 104 mm)
Accuracy: Limited only by sender accuracy
Senders: Works with 0-30, 0-70, 0-90, 10-73, 10-
180, 33-240, 40-250 ohm resistive senders by VDO,
Teleflex, GM, Stewart-Warner, Mercury, Faria, and
others (both American and European styles). Custom
versions available for 0-5V and 4-20mA senders.
Alarms: 85 db internal Low and High level alarms,
settable from 000.0 to 6553. External alarm output.
Display: 4 digits, PSI, Bars or %, 000.0 to 6553. Five
levelsofbacklighting.
Data output: NMEA 0183 4800 baud serial output
of pressure. $IIXDR sentence or programmable as an
externalalarm output.
Page 15
2016 BV Engineering PR60MAN-A
Page 13
Notes
Selecting NMEA 0183 or External Alarm Output
To toggle Screw Terminal Pin (C) between NMEA
0183 and External Alarm Output, press and hold
down both the tand s keys for 10 seconds (until
you hear a long beep). The new output mode is
automatically saved to memory. When the external
alarm output is activated, a 5V signal (10 mA Max.)
is output on screw terminal (C).
