USER GUIDE
1. Pre-ride inspection
It is necessary for your safety, check:
• Engine oil level
• fuel, according to the route to go
• Tire pressures as indicated calibrate
• Battery
• Operation of the throttle
• Operation of lights and indicators
• Alignment of management
• Proper operation of the brakes
2. Starting the Engine
Follow these steps:
1. Place the unit in contact
2. Make sure gear is in neutral
3. Check the fuel level
4. Be sure to tighten the clutch to reduce friction starter motor
and for safety.
5. Press button electric start accelerating throttle to 1/4 "of the
position of the fist.
• Do not start the engine indoors or shortly ventilated,
it may cause accidents due the toxic exhaust fumes.
• If the engine is ignited by button start, the motorcycle
must be stopped with the front brake.
• If you can not start the engine in 5 seconds start the
engine via the button again, starting at intervals of 10
seconds for battery can renew its power (to recover)
and not overheat the starter.
• Avoid sudden acceleration when the engine is cold,
as
can cause serious damage.。
• Do not keep the motorcycle unnecessarily idle to
avoid overloading the motor.
3. Seated engine
We recommend that during the first 1000km
• Do not speed excessively, suggest
circulate
at a maximum speed of 50 km / h.
• Be careful not to exceed 5000rpm for
correct transposition of metals
• Do not load the vehicle in excess
• Perform the first maintenance whintin 4 hour
or 30 liters of fuel consumed, and then follow
the instructions on the maintenance table.
• Use front and rear brakes independently reduces
braking efficiency, otherwise wheel can lock up
losing control.
